MBR10xx, MBRF10xx & MBRB10xx Series Reverse Voltage 35 to 60 Volts Schottky Barrier Rectifiers Forward Current 10.0 Amperes Features Plastic package has Underwriters Laboratory Flammability Classifications 94V-0 Metal silicon junction, majority carrier conduction Low power loss, high efficiency Guardring for overvoltage protection For use in low voltage, high frequency inverters, free wheeling, and polarity protection applications High temperature soldering guaranteed: 250°C/10 seconds, 0.25" (6.35mm) from case Mechanical Data Case: JEDEC TO-220AC, ITO-220AC & TO-263AB molded plastic body Terminals: Plated leads, solderable per MIL-STD-750, Method 2026 Polarity: As marked Mounting Position: Any Mounting Torque: 10 in-lbs maximum Weight: 0.08 ounce, 2.24 grams ITO-220AC TO-220AC TO-263AB(D2PAK) Mounting Pad Layout TO-263AB Dimensions in inches and (millimeters) 344 Maximum Ratings and Electrical Characteristics ( TC = 25oC unless otherwise noted ) Parameter Symbol MBR1035 MBR1045 MBR1050 MBR1060 Unit Maximum repetitive peak reverse voltage VRRM 35 45 50 60 Volts Working peak reverse voltage VRWM 35 45 50 60 Volts Maximum DC blocking voltage V DC 35 45 50 60 Maximum average forward rectified current (See Fig. 1) IF(AV) 10 Amps Peak repetitive forward current (sq. wave, 20KHz) at TC=135oC IFRM 20 Amps Peak forward surge current 8.3ms single half sine-wave superimposed on rated load (JEDEC Method) IFSM 150 Amps Peak repetitive reverse current at tp = 2.0us, 1KHz IRRM Voltage rate of change (rated VR) 1.0 dv/dt 0.5 10,000 Volts Amps V/us Maximum instantaneous forward voltage (Note 4) at IF=10A, TC=25oC at IF=10A, TC=125oC Maximum instantaneous reverse current at rated DC blocking voltage (Note 4) 0.70 at IF=20A, TC=25oC 0.84 0.95 at IF=20A, TC=125oC 0.72 0.85 o TC=25 C TC=125oC RMS Isolation voltage (MBRF type only) from terminals to heatsink with t = 1.0 second, RH < 30% Operating junction temperature range Notes: 0.80 0.57 Maximum thermal resistance from junction to case Storage temperature range VF Volts 0.10 IR mA 15 o RθJC MBR 2.0 / MBRF 4.0 / MBRB 2.0 VISOL 4500 (Note 1) 3500 (Note 2) 1500 (Note 3) TJ -55 to +150 o C TSTG -55 to +150 o C 1. Clip mounting (on case), where lead does not overlap heatsink with 0.110" offset 2. Clip mounting (on case), where leads do overlap heatsink 3. Screw mounting with 4-40 screw, where washer diameter is < 4.9 mm (0.19") 4. Pulse test: 300us pulse width, 1% duty cycle 345 C/W Volts RATINGS AND CHARACTERISTIC CURVES ( TA = 25oC unless otherwise noted ) 346