14 Pin DIP Triple TTL Compatible Active Delay Lines DELAY TIME ±5% or ±2 nS† PART NUMBER 5 6 7 8 9 10 11 12 13 14 15 16 17 18 EP9206-005 EP9206-006 EP9206-007 EP9206-008 EP9206-009 EP9206-010 EP9206-011 EP9206-012 EP9206-013 EP9206-014 EP9206-015 EP9206-016 EP9206-017 EP9206-018 †Whichever is greater. 19 20 21 22 23 24 25 30 35 40 45 50 55 60 DELAY TIME ±5% or ±2 nS† PART NUMBER EP9206-019 EP9206-020 EP9206-021 EP9206-022 EP9206-023 EP9206-024 EP9206-025 EP9206-030 EP9206-035 EP9206-040 EP9206-045 EP9206-050 EP9206-055 EP9206-060 65 70 75 80 85 90 95 100 125 150 175 200 225 250 EP9206-065 EP9206-070 EP9206-075 EP9206-080 EP9206-085 EP9206-090 EP9206-095 EP9206-100 EP9206-125 EP9206-150 EP9206-175 EP9206-200 EP9206-225 EP9206-250 Schematic Test Conditions Min Max Unit VCC = min. VIL = max. I OH = max VCC = min. VIH = min. I OL= max VCC = min. II = IIK VCC = max. VIN = 2.7V VCC = max. VIN = 5.25V IIL Low-Level Input Current VCC = max. VIN = 0.5V IOS Short Circuit Output Current VCC = max. VOUT = 0. (One output at a time) ICCH High-Level Supply Current VCC = max. VIN = OPEN ICCL Low-Level Supply Current VCC = max. VIN = 0 TRO Output Rise Time Td ≤ 500 nS (0.75 to 2.4 Volts) NH Fanout High-Level Output VCC = max. VOH = 2.7V NL Fanout Low-Level Output VCC = max. VOL = 0.5V High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current Recommended Operating Conditions VCC VIH VIL IIK IOH IOL PW* d* TA PART NUMBER Delay Times referenced from input to leading edges at 25°C, 5.0V, with no load. DC Electrical Characteristics Parameter VOH VOL VIK IIH DELAY TIME ±5% or ±2 nS† Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature 2.7 -40 0.5 -1.2V 50 1.0 -2 -100 V V V µA mA mA mA 14 DSD9206 115 mA 115 mA 4 nS 20 TTL LOAD 10 TTL LOAD 5 7 GROUND Max Unit 4.75 2.0 5.25 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 0 40 +70 PCA EP9206-005 Date Code White Dot Pin#1 Unit 3.2 110 2.0 1.0 100 5.0 .020 Typ. Volts % nS MHz KHz Volts .280 Max. .780 Max. .020 Min. .010 Typ. .120 Min. .200 .365 Max. QAF-CSO1 Rev. B 8/25/94 Rev. A 2/5/96 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = ± 1/32 .XX = ± .030 .XXX = ± .010 3 Package Dimensions Min Input Pulse Test Conditions @ 25° C VCC 10 8 .250 Max. Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td ≤ 200 nS Pulse Repetition Rate @ Td > 200 nS Supply Voltage 12 1 *These two values are inter-dependent. EIN PW TRI PRR VCC ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791