AZ2800 30 AMP MINIATURE POWER RELAY FEATURES • • • • • • 30 Amp switching capability DPST-NO and DPDT configuration Meets 8 mm creepage, 4 kV dielectric Class F construction Epoxy sealed version available UL, CUR file E44211, VDE pending GENERAL DATA CONTACTS Arrangement DPST (2 Form A) DPDT (2 Form C) Ratings Resistive load: Max. switched power: 560 W or 8310 VA Max. switched current: 30 A (N.O.), 3 A (N.C.) Max. switched voltage: 600 VAC or 30 VDC* * Note: If switching voltage is greater than 30VDC, special precautions must be taken. Please contact the factory. Rated Load UL, CUR N.O. UL, CUR N.C. 30 A at 277 VAC General Use, 100k cycles 1 Hp at 120 VAC, 100k cycles 2.5 Hp at 240 VAC, 100k cycles 110 LRA / 25.3 FLA at 240 VAC (DC coils only), 30k cycles 3 A at 277 VAC General Use, 100k cycles Material Silver cadmium oxide or silver tin oxide Resistance <50 milliohms initially (6 V, 1 A voltage drop method) COIL Life Expectancy Mechanical Electrical Minimum operations 5 x 107 1 x 105 at 30 A 120 VAC Res. N.O. Operate Time 15 ms typical 25 ms maximum with bounce Release Time 10 ms typical 25 ms maximum with bounce (with no coil suppression) Dielectric Strength 1500 Vrms contact to contact (at sea level for 1 min.) 4000 Vrms contact to coil 2000 Vrms between contact sets Insulation Resistance 109 ohms minimum at 500 VDC Dropout DC: Greater than 10% of nominal coil voltage AC: Greater than 20% of nominal coil voltage Ambient Temperature Operating At nominal coil voltage DC: -40°C (-40°F) to 85°C (185°F) AC: -40°C (-40°F) to 65°C (149°F) -40°C (-40°F) to 105°C (221°F) Storage Vibration 0.062" (1.5 mm) DA at 10–55 Hz Shock Operational, 10 g for 11 ms 1/2 sine pulse (no contact opening > 100usec) Non-destructive, 100 g for 11 ms 1/2 sine pulse Enclosure P.B.T. polyester Power At Pickup Voltage (typical) DC: 0.925 W AC: 2.6 VA Max. Continuous Dissipation DC: 5.0 W at 20°C (68°F) AC: 7.0 VA at 20°C (68°F) Temperature Rise DC: 48°C (86°F) at nominal coil voltage AC: 68° C (122°F) at nominal coil voltage Max. Solvent Temp. 80°C (176°F) Max. 155°C (311°F) Max. Immersion Time 30 seconds Weight 86 grams Packing unit in pcs 20 per plastic tray / 100 per carton box Temperature NOTES Terminals Quick connect tabs Note: Allow suitable slack on leads when wiring, and do not subject the terminals to excessive force 1. All values at 20°C (68°F). 2. Relay may pull in with less than “Must Operate” value. 3. Specifications subject to change without notice. ZETTLER electronics GmbH Junkersstrasse 3, D-82178 Puchheim, Germany Tel. +49 89 800 97 0 Fax +49 89 800 97 200 [email protected] www.ZETTLERelectronics.com 2004-07-20 AZ2800 RELAY ORDERING DATA COIL SPECIFICATIONS – DC Coil Nominal Coil VDC 6 Must Operate VDC 4.5 Max. Continuous VDC 10.5 Nominal Current mA ± 10% 272.0 ORDER NUMBER* Coil Resistance Ohm ± 10% 22 AZ2800–2C–6D 12 9.0 20.7 140.0 86 AZ2800–2C–12D 24 18.0 41.8 68.5 350 AZ2800–2C–24D 48 36.0 83.4 34.5 1,390 AZ2800–2C–48D 110 82.5 190.5 15.2 7,255 AZ2800–2C–110D COIL SPECIFICATIONS – AC Coil Nominal Coil VAC 12 50 Hz Nominal Current mA ± 10% 340.0 ORDER NUMBER* Must Operate VAC 9.6 Max. Continuous VAC 15.6 Coil Resistance Ohm ± 10% 8 24 19.2 31.2 166.0 45 120 96.0 156.0 33.3 1,125 AZ2800–2C–120A5 220 176.0 286.0 18.2 3,800 AZ2800–2C–220A5 240 192.0 312.0 16.7 4,500 AZ2800–2C–240A5 277 221.6 360.1 14.4 6,000 AZ2800–2C–277A5 AZ2800–2C–12A5 AZ2800–2C–24A5 * Substitute “2A” in place of “2C” to indicate 2 Form A contacts. Add suffix “E” to “2A” or “2C” to indicate silver tin oxide contacts. Add suffix “E” at the end of part number for sealed version. Add suffix “K” for 0.187 x 0.020 [4.8 x 0.5] coil terminals. MECHANICAL DATA MECHANICAL DATA .31 [8.0] .58 [14.8] WIRING DIAGRAM .18 [4.6] .63 [16.0] 1.36 [34.5] 1.00 [25.4] .15 [3.8] 6 x .250 [6.3] 1.62 [41.1] 2.35 [59.7] 8 x .032 [.8] 0 2 4 3 6 8 7 1 1.04 [26.4] 2 FORM C 2 x DIM "A" DIM. "A" = .250 x .032 [6.3 x 0.8] - STANDARD 0 DIM. "A" = .187 x .020 [4.8 x 0.5] - SUFFIX "K" 8 x .45 [11.4] 2 4 6 8 .13 [3.3] 1 2 FORM A 2.69 [68.4] VIEWED TOWARD TERMINALS Dimensions in inches with metric equivalents in parentheses. Tolerance: ± .010" ZETTLER electronics GmbH Junkersstrasse 3, D-82178 Puchheim, Germany Tel. +49 89 800 97 0 Fax +49 89 800 97 200 [email protected] www.ZETTLERelectronics.com 2004-07-20