Series AM8TW-Z 8Watt | DC-DC Converter FEATURES: Wide 4:1 input range 24 Pin DIP Package High efficiency up to 87% Over Voltage/Overload Protection Operating temperature -40oC to + 85oC Input / Output Isolation 1600 VDC Continuous short circuit protection RoHS compliant Models Single output Model Input Voltage (V) Output Voltage (V) Output Current max (mA) Isolation (VDC) Max Capacitive Load(uF) Efficiency (%) 9-36 9-36 9-36 9-36 18-75 18-75 18-75 18-75 3.3 5 12 15 3.3 5 12 15 2000 1500 665 535 2000 1500 665 535 1600 1600 1600 1600 1600 1600 1600 1600 1330 1330 288 200 1330 1330 288 200 83 86 87 87 82 86 87 87 Input Voltage (V) Output Voltage (V) Output Current max (mA) Isolation (VDC) Max Capacitive Load(uF) Efficiency (%) 1600 1600 1600 1600 1600 1600 ±900 ±133 ±90 ±900 ±133 ±90 84 86 87 84 87 87 AM8TW-2403SZ AM8TW-2405SZ AM8TW-2412SZ AM8TW-2415SZ AM8TW-4803SZ AM8TW-4805SZ AM8TW-4812SZ AM8TW-4815SZ Models Dual output Model AM8TW-2405DZ AM8TW-2412DZ AM8TW-2415DZ AM8TW-4805DZ AM8TW-4812DZ AM8TW-4815DZ 9-36 9-36 9-36 18-75 18-75 18-75 ±5 ±12 ±15 ±5 ±12 ±15 ±800 ±335 ±265 ±800 ±335 ±265 NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. Input Specifications Parameters Voltage range Nominal 24 48 Filter Start up time Absolute Maximum Rating 24 48 Peak Input Voltage time On/Off control No Load Input Current Input reflected current Typical Maximum Units 9-36 18-75 (Pi) Network 20 VDC ms -0.7-50 -0.7-100 100 ON – 3.0 ~ 12VDC (or open) OFF -0~1.2VDC (or short between pin 1 and 2/3) 15 20 VDC ms mA mAp-p Isolation Specifications Parameters Tested I/O voltage Resistance Capacitance www.aimtec.com F 051e R12.E Conditions Typical 3 sec >1000 1500 Tel: +1 514 620 2722 1 of 4 Rated Units 1600 VDC MOhm pF Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AM8TW-Z 8Watt | DC-DC Converter Output Specifications Parameters Conditions Voltage accuracy Over voltage protection Over current protection Short Circuit protection Short circuit restart Line voltage regulation Load voltage regulation (Single) Load voltage regulation (Dual) Temperature coefficient Ripple & Noise Minimum Load Current Typical Maximum Units ±1 % % % Zener Diode Clamp 150 Continuous Auto-Recovery ±0.2 ±0.5 ±1 ±0.02 75 0 HL-LL 0 – 100% load 0 – 100% load 20MHz Bandwidth % of Vin % % %/oC mV p-p % of Max General Specifications Parameters Conditions Typical Switching frequency Operating temperature Storage temperature Maximum case temperature Cooling Humidity Case material Weight Dimensions (L x W x H) MTBF Maximum soldering temperature Transient recovery time Transient recovery deviation 100% load Derating above +70 270 Maximum Units KHz o C o C o C -40 to +85 -40 to +125 105 Free air convection 95 Nickel plated Cooper 18 1.25 x 0.80 x 0.12 inches 31.80 x 20.30 x 10.20 mm > 1,000,100 hours(MIL-HDBK-217F , Ground Benign, t=+25oC) 1.5mm from case for 10sec 260 250 ±3 % RH g o C uS % Safety Specifications Parameters Agency Approval Standards www.aimtec.com F 051e R12.E CE EN55022 Class A, EN55024 IEC61000-4-2, Perf. Criteria B IEC61000-4-3, Perf. Criteria A IEC61000-4-4, Perf. Criteria B (external 330uF/100V cap required) IEC61000-4-5, Perf. Criteria B (external 330uF/100V cap required) IEC61000-4-6, Perf. Criteria A IEC61000-4-8, Perf. Criteria A Tel: +1 514 620 2722 2 of 4 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AM8TW-Z 8Watt | DC-DC Converter Dimensions Dual Remote On/Off -V Input -V Input Common -V Output +V Output Common +V Input +V Input 31.80 (1.25) 0.50 (0.02) 0.50 (0.02) 1 2 20.30 (0.80) Pin 1 2 3 9 11 14 16 22 23 Single Remote On/Off -V Input -V Input No Pin N.C. +V Output -V Output +V Input +V Input 3 2.54 (0.10) 16 14 5.08 (0.20) 3.05 (0.12) 10.20 (0.40) N.C.: Not Connected 11 Bottom View 23 22 Printed Face 9 15.20 (0.60) Pin Out Specifications Derating 70 ºC Output Power (%) 100 80 Safe Operating Area 60 40 20 0 - 40 - 20 0 20 40 60 80 85 100 Ambient Temperature º C www.aimtec.com F 051e R12.E Tel: +1 514 620 2722 3 of 4 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AM8TW-Z 8Watt | DC-DC Converter Recommended Circuits C1 2.2uF, 100V L 12uH C2 2.2uF, 100V C1 330uF, 100V NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com. www.aimtec.com F 051e R12.E Tel: +1 514 620 2722 4 of 4 Toll free: + 1 888 9 AIMTEC (924 6832) North America only