AVS20 AVS200 AUTOMATIC VOLTAGE SWITCH (SMPS < 300W) .. .. . . . .. . .. CONTROLLER 50/60Hz FULL COMPATIBILITY INTEGRATED VOLTAGE REGULATOR TRIAC TRIGGERING BY PULSE TRAIN HIGH IMMUNITY TO AC DISTURBANCES (SPIKES, MISSING CYCLE) HIGH RELIABILITY ON LINE VOLTAGE DETECTION (PARASITIC FILTER ON SIGNAL INPUT) FAST DIGITAL START-UP TIME (< 2 LINE CYCLES) LOW POWER CONSUMPTION P DIP8 (Plastic Package) ORDER CODE : AVS2ACP08 TRIAC HIGH EFFICIENCY AND SAFETY SWITCHING UNINSULATED PACKAGE : AVS10CB/AVS100CB INSULATED PACKAGE (2500VRMS) : AVS10CBI VDRM = ±600V (AVS10CB), ±800V (AVS100CB) IT(RMS) : 8A B TO220AB (Plastic Package) DESCRIPTION The AVS20 (AVS200) kit is an automatic mains selector (120/230V AC) to be used in SMPS with input power < 300 W. It is composed of 2 devices : • The Controller is optimized for low consumption and high security triggering of the triac. When connected to VSS, the mode input activates an additional option “the latched option”. If the main power drops from 230V to 120V, the triac control remains locked to the 230V mode and avoids any high voltage spike when the voltage is restored to 230V. When connected to VDD, the mode input desactivates this option “this is the follower option”. • The TRIAC is specially designed for this application. An optimization between sensitivity and dynamic parameters of the triac gate highly reduces the losses of supply resistor and allows excellent immunity against line disturbances. ORDER CODES : AVS10CB-AVS10CBI-AVS100CB PIN CONNECTIONS DIP8 VSS 1 8 VM Osc/ In 2 7 Mode Osc/Out 3 6 NC VDD 4 5 VG AVS20-01.EPS July 1992 1/8 AVS20 - AVS200 BLOCK DIAGRAM MODE 7 V SS 1 R SUPPLY RESET RST CK V DD 4 LATCHED MODE CONTROL A2 PEAK LINE VOLTAGE DETECTOR VM 8 4.25 2 MAINS R MODE CK CONTROLLER PARASITIC FILTER AVS10CB AVS10CBI VG 0.05 or 3 5 PARASITIC FILTER G 1 R 0.25 PARASITIC FILTER CK AVS100CB A1 TRIAC TRIGGERING WINDOW 4 V DD CROSSING DETECTOR OSC/IN 2 CLOCK 10 OSC/OUT 3 AVS2ACP08 AVS20-02.EPS Symbol VSS VI / VO II / IO Tstg Top er Parameter Supply voltage I / O voltage I / O current Storage Temperature Operating Temperature code “ C ” Min. - 12 VSS - 0.5 - 40 - 60 0 Max. 0.5 0.5 + 40 + 150 + 70 Unit V V mA °C °C AVS20-01.TBL ABSOLUTE MAXIMUM RATINGS CONTROLLER AVS2ACP08 Symbol VDRM IT(RMS) ITSM 2 It di/dt dv/dt (3) Tstg Tj Parameter Repetitive peak off-state voltage (2) AVS10 AVS100 RMS on-state current (360° conduction angle) TC = 80°C, AVS10CB/AVS100CB TC = 70°C, AVS10CBI Non repetitive surge peak on-state current ( Tj initial = 25°C ) t = 8.3ms t = 10ms 2 I t value (t = 10ms) Critical rate of rise of on-state current (1) Repetitive f = 50Hz Non Repetitive Linear slope up to 400V (Gate open) (Tj = 70°C) AVS10 AVS100 Storage Temperature Operating Junction Temperature (1) Gate supply : IG = 100mA – di/dt = 1A /µs (2) Tj = 110°C (3) For either polarity of electrode A2 voltage with reference to electrode A1 2/8 Value Unit ±600 ±800 V V 8 8 A A 85 80 32 A A 2 As 20 100 A/µs A/µs 75 150 -40, +150 0, +110 V/µs V/µs o C o C AVS20-02.TBL TRIAC AVS10CB / AVS10CBI / AVS100CB Tj = +25°C (unless otherwise specified) AVS20 - AVS200 THERMAL RESISTANCES TRIAC AVS10CB / AVS10CBI / AVS100CB R th (j-c) AC Parameter Value 60 Junction-to-ambient Junction-to-case for DC AVS10CB / AVS100CB AVS10CBI Junction-to-case for 360° conduction angle ( f = 50Hz) AVS10CB / AVS100CB AVS10CBI Unit C/W o 3.5 4.4 o C/W o 2.6 3.3 o C/W o C/W C/W AVS20-03.TBL Symbol R th (j-a) Rth (j-c) DC Symbol VGD VTM (1) IDRM (1) Parameter VD = VDRM R L = 3.3kΩ Pulse duration> 20µs (Tj = 110°C) ITM = 11A (tp = 10ms, Tj = 25°C) VDRM rated Gate open AVS10/AVS100 Tj = 25°C Tj = 110°C AVS10 Tj = 700°C AVS100 Min. 0.2 Max. 1.75 Unit V V 10 500 500 µA µA µA AVS20-04.TBL DC GENERAL ELECTRICAL CHARACTERISTICS TRIAC AVS10CB / AVS10CBI / AVS100CB CONTROLLER AVS2ACP08 Toper = 25°C (unless otherwise specified) Symbol Parameter Min. Typ. Max. Unit - 10 0.4 -9 -8 30 V mA 0.6 0.7 mA 44 46 kHz MAIN CHARACTERISTICS VSS (pin 1) (Vreg) ISS (pin 1) (Vreg) (@ VSS = -9V) ISS (pin 1) (@ triac gate non connected) F (pin 3) (@ R = 91kΩ) (C = 100pF) VPWRON (2) VPWROFF (2) Mode (pin 7) VG (pin 5) Shunt Regulator Voltage Supply Current Quiescent Current Oscillator Frequency Power-on-reset Threshold Power-off-reset Threshold VIL (2) (2) VIH VOL (IVG = 25mA) Leakage Current (VG = VDD) 42 0.89 Vreg 4.6 V 0.3 Vreg 0.7 Vreg 650 + 10 mV µA PEAK LINE VOLTAGE DETECTOR VSWON (pin 8) VSWOFF (pin 8) tON (pin 5) Low Threshold of Trip Point (switching-on of triac triggering) (3) High Threshold of Trip Point (switching-off of triac triggering) (3) Triac Turn-on Delay Time (VAC = 120V) 3.89 4.05 4.22 V 4.08 4.25 4.42 V 2 Line cycles 1 V0CRPH (pin8) V0CRPL (pin8) V0CRNH (pin8) V0CRNL (pin8) High Threshold on Positive AC Side (3) Low Threshold on Positive AC Side (3) (4) High Threshold on Negative AC Side (3) Low Threshold on Negative AC Side (3) (4) 250 200 100 60 mV mV mV mV NOTES : (1) : For either polarity of electrode A2 voltage with reference to electrode A 1. (2) : Voltage referred to VDD. (3) : Voltage referred to VSS. (4) : These values give a typical noise immunity on the zero-crossing detection of 100mV x 1018 = 5.65V on the mains supply. 18 3/8 AVS20-05.TBL ZERO VOLTAGE CROSSING DETECTOR AVS20 - AVS200 Figure 1: Maximum RMS power dissipation versus RMS on-state current (f=60Hz) (Curves are cut-off (di/dt)c limitation) Figure 2a : Correlation between maximum mean power dissipation and maximum allowable temperatures (TA and TC) for different thermal resistances heatsink + contact (AVS10CB/AVS100CB) AVS20-03.EPS AVS20-04.EPS Figure 2b : Correlation between maximum mean power dissipation and maximum allowable temperatures (TA and TC) for different thermal resistances heatsink + contact (AVS10CBI) AVS20-03.EPS Figure 3 : Non-repetitive surge peak on-state current for a sinusoidal pulse with width : t ≤2 10ms, and corresponding value of I t. AVS20-06.EPS 4/8 AVS20-05.EPS Figure 4 : On-state characteristics (maximum values). AVS20-07.EPS AVS20 - AVS200 POWER-ON AND POWER-OFF RESET BEHAVIOUR Power-on reset Undetermine d Power-off Undetermined Reset Normal operation 0V 0V -3V -3V VPWROFF VPWRON Vreg = VSS - V DD AVS20-08.EPS TYPICAL APPLICATION DIAGRAM 110 V or 220V NTC NTC 1N 4007 2 x 9.1K 1W AVS10CB/CBI option VDD or AVS100CB R1 1M 1% VM VSS 7 5 8 AVS2ACP08 R2 18K 1% A2 390 G VG A1 4 3 2 1 91k 1 % VDD VSS 33 µF 16V 100pF 5 % AVS20-09.EPS AVS20 ORDERING INFORMATION AVS20/AVS200 CONTROLLER AVS 2A AUTOMATIC VOLTAGE SWITCH TRIAC C P08 PACKAGE : DIP8 IDENTIFICATION OPERATING TEMPERATURE : C = 0/70 C AVS 10 AUTOMATIC VOLTAGE SWITCH C B I INSULATED Suffix PACKAGE B : UNINSULATED TO220 IDENTIFICATION 10 : VDRM = 600V 100 : VDRM = 800V OPERATING TEMPERATURE : C = 0/70 C AVS20-10.EPS 5/8 AVS20 - AVS200 PACKAGE MECHANICAL DATA CONTROLLER 8 PINS - PLASTIC DIP I L a1 A e4 b1 B B1 b E e e3 Z Z D 5 1 4 F 8 PM-DIP8.EPS A a1 B b b1 D E e e3 e4 F i L Z 6/8 Min. Millimeters Typ. 3.32 0.51 1.15 0.356 0.204 Max. 1.65 0.55 0.304 10.92 9.75 7.95 Min. 0.020 0.045 0.014 0.008 Max. 0.065 0.022 0.012 0.430 0.384 0.313 2.54 7.62 7.62 3.18 Inches Typ. 0.131 0.100 0.300 0.300 6.6 5.08 3.81 1.52 0.125 0260 0.200 0.150 0.060 DIP8.TBL Dimensions AVS20 - AVS200 PACKAGE MECHANICAL DATA TRIAC 3 PINS - PLASTIC TO220AB PM-TOTRI.IMG Cooling method : by conduction (method C) Weight : 2 g 7/8 AVS20 - AVS200 NOTES: Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no responsability for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. SGS-THOMSON Microelectronics products are not authorized for use as critical components in life support devices or systems without the express written approval of SGS-THOMSON Microelectronics. 1994 SGS-THOMSON Microelectronics - All rights reserved. Purchase of I2C Components by SGS-THOMSON Microelectronics conveys a license under the Philips I 2C Patent. Rights to use these components in an I2C system is granted provided that the system conforms to the I 2C Standard Specification as defined by Philips. SGS-THOMSON Microelectronics Group of Companies Australia - Brazil - France - Germany - Hong Kong - Italy - Japan - Korea - Malaysia - Malta - Morocco - The Netherlands Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A. 8/8