HER101G THRU HER108G HIGH EFFICIENCY GLASS PASSIVATED RECTIFIER Reverse Voltage - 50 to 1000 Volts Forward Current - 1.0 Ampere Features Low power loss, high efficiency Low leakage Low forward voltage High current capability High speed switching High surge capability High reliability Mechanical Data DIM ENSIONS Case: Molded plastic Epoxy: UL94V-0 rate flame retardant Lead: MIL-STD-202E method 208C guaranteed Mounting Position: Any Weight: 0.012 ounce, 0.335 gram inches DIM mm Min. Max. Min. Max. A 0.165 0.205 4.2 5.2 B 0.079 0.106 2.0 2.7 C 0.028 0.034 0.71 0.86 D 1.000 - 25.40 - Note Maximum Ratings and Electrical Characteristics Ratings at 25 ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. Symbols HER 101G HER 102G HER 103G HER 104G HER 105G HER 106G HER 107G HER 108G Units Volts Maximum repetitive peak reverse voltage VRRM 50 100 200 300 400 600 800 1000 Maximum RMS voltage VRMS 35 70 140 210 280 420 560 700 Volts Maximum DC blocking voltage VDC 50 100 200 300 400 600 800 1000 Volts Maximum average forward rectified current 0.375" (9.5mm) lead length at TA=50 I(AV) 1.0 Amp Peak forward surge current 8.3mS single half sine-wave superimposed on rated load (MIL-STD-750D 4066 method) IFSM 30.0 Amps Maximum instantaneous forward voltage at 1.0A DC VF Maximum full load reverse current average, full cycle 0.375" (9.5mm) lead length at TL=55 IR(AV) 100.0 A IR 5.0 A Maximum DC reverse current at rated DC blocking voltage TA=25 1.0 1.3 1.5 1.7 Typical reverse recovery time (Note 1) Trr 50.0 75.0 Typical junction capacitance (Note 2) CJ 15 12 Operating and storage temperature range TJ, TSTG -65 to +150 Notes: (1) Test conditions: IF=0.5A, IR=1.0A, Irr=0.25A (2) Measured at 1.0MHz and applied reverse voltage of 4.0 volts 1 Volts nS F RATINGS AND CHARACTERISTIC CURVES 2