GSIB805 THRU GSIB8100 SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIER Voltage: 50 to 1000V 8.0A Current: Features GSIB-5S Glass passivated chip junction Ideal for printed circuit board High surge current capability High case dielectric strength This series is UL listed under Recognized Component Index, file number E185029 Mechanical Data Terminal: Plated leads solderable per MIL-STD 202E, Method 208C Case: UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: Polarity symbol marked on body Mounting position: any Dimensions in millimeters MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half -wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) Symbol GSIB8 05 GSIB8 10 GSIB8 20 GSIB8 40 GSIB8 60 GSIB8 80 GSIB8 100 units Maximum repetitive peak reverse voltage Vrrm 50 100 200 400 600 800 1000 V Maximum RMS voltage Vrms 35 70 140 280 420 560 700 V Maximum DC blocking voltage Vdc 50 100 200 400 600 800 1000 V Maximum average forward Rectified output current at Tc =100℃(Note 1) Peak forward surge current single sine-wave superimposed on rated load (JEDEC Method) Maximum instantaneous forward voltage drop per leg at 4.0A If(av) 8.0 A Ifsm 200 A Vf 0.95 V I2t 120 A2Sec Ir 10.0 200 µA (Note2) (Note1) Rth(ja) Rth(jc) 22.0 3.4 ℃/W Operating junction and storage temperature range Tj, Tstg -55 to +150 ℃ Rating for fusing (t < 8.3ms) Maximum DC reverse current at rated DC blocking voltage per leg Maximum thermal resistance per leg Ta = 25°C Ta = 125°C Note: 1. Unit case mounted onAl plate heatsink 2. Unit case mounted on P.C.B. with 0.5 x 0.5” (12 x 12mm) copper peads and 0.375”(9.5mm) lead length 3. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw Rev.A8 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES GSIB805 THRU GSIB8100 Rev.A8 www.gulfsemi.com