ER3A THRU ER3J SURFACE MOUNT SUPERFAST RECTIFIER VOLTAGE - 50 to 600 Volts CURRENT - 3.0 Amperes FEATURES l For surface mounted applications l Low profile package l Built-in strain relief l Easy pick and place l Superfast recovery times for high efficiency l Plastic package has Underwriters Laboratory SMC/DO-214AB Flammability Classification 94V-O l Glass passivated junction l High temperature soldering: 260 /10 seconds at terminals MECHANICAL DATA Case: JEDEC DO-214AB molded plastic Terminals: Solder plated, solderable per MIL-STD750, Method 2026 Polarity: Indicated by cathode band Standard packaging: 16mm tape (EIA-481) Weight: 0.007 ounce, 0.21 gram MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Current, at TL=75 Peak Forward Surge Current 8.3ms single half sinewave superimposed on rated load(JEDEC method) Maximum Instantaneous Forward Voltage at 3.0A Maximum DC Reverse Current TA=25 At Rated DC Blocking Voltage TA=100 Maximum Reverse Recovery (Note 1) Typical Junction capacitance (Note 2) Typical Thermal Resistance (Note 3) Operating and Storage Temp NOTES: SYMBOLS ER3A ER3B ER3C ER3D ER3E ER3G ER3J UNITS 50 100 150 200 300 400 600 Volts VRRM 35 70 105 140 210 280 420 Volts VRMS 50 100 150 200 300 400 600 Volts VDC I(AV) 3.0 Amps IFSM 100 Amps VF IR TRR CJ R JL TJ,TSTG 0.95 1.25 5.0 200 35.0 45.0 16 -50 to +150 1.7 Volts A nS PF /W 1. Reverse Recovery Test Conditions: IF=0.5A, IR=1.0A, Irr=0.25A 2. Measured at 1 MHz and Applied reverse voltage of 4.0 volts 3. 8.0mm2 (.013mm thick) land areas RATING AND CHARACTERISTIC CURVES ER3A THRU ER3J Fig. 1-REVERSE RECOVERY TIME CHARACTERISTIC Fig. 2-MAXIMUM AVERAGE FORWARD AND TEST DIAGRAM CURRENT RATING Fig. 3-TYPICAL REVERSE CHARACTERISTICS Fig. 5-MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT Fig. 4-TYPICAL FORWARD CHARACTERISTICS Fig. 6-TYPICAL JUNCTION CAPACITANCE