JBL702A Series Universal Input, 20 Watt Output Li-ion/Polymer Chargers •100-240VAC 2 Year Warranty Universal Input •Optimizes Li-ion/Polymer •4V Battery Life to 21V Output Models, up to 21W •Dual-color LED Indicator •Modified and Custom Designs Available •Impact-Resistant Polycarbonate Enclosure •Meets safety agency requirements Specifications All Specifications are typical at nominal input, full load at 25°C unless otherwise stated. Switching – Battery Charger 100-240VAC, +/-10%, 47-63 Hz, 1∅. Topology AC Input Input Current Inrush Current peak. Input Fuse 1.0A maximum, at 110Vac Inrush limiting provided – 150A Dual Internal Primary Current Fuse: 250Vac, 1A Approvals and Safety Standards Dielectric Withstand Operating Temperature Output Voltage See chart. Storage Temperature Output Power See chart Relative Humidity Minimum Load Battery Type: Charging Method: Not required. Li-ion/Polymer Constant current and constant voltage. Altitude MTBF Case Dimensions: EN/IEC/CSA/UL60950-1, EMC: EN55022/55024/61000 Input-Output: 3000Vac, Input-GND: 1500Vac, Output-GND: 500Vdc 0° to 40°C, no derating -30 to +85°C. 5% to 95%, non-condensing 0 to 10,000 ft. >61,000 hours (calculated) 4.49”(L) x 2.36”(W) x 1.38(H)”, 114mm(L) x 60mm(W) x 35mm(H) Black 94V0 Polycarbonate Overload Protection Hiccup Mode Case Material: Short Circuit Protection Hiccup Mode Output Connections: Cable: 1500mm, 18AWG, 2 conductor. Connector: 1.35 x 3.5mm barrel type, center contact (+). Pre-Charge Mode Operation: (a) Threshold Voltage: <10.0 +/-0.2V (b) Pre-charge Current = Fast charge current (c) Pre-charge Cycle 10 Times, 10sec ON / 2sec OFF (d) Fast charge Mode change When the battery voltage is more than 5.0V (Threshold voltage), change to the Fast charge Mode. (e) Pre-charge Failure check After 10 cycle, check the battery voltage is less than 5.0V, show the flickering LED; more than 5.0V, change to the Fast charge Mode. LED Indicators: LED Off: Battery Unloaded, output shorted. R/G/A 0.5 second on/off: Power switch ON, or reset microcontroller. Red LED On: Fast Charge, pre-charge Green LED On: Fully Charged or Trickle Charge Flickering Red LED: Error (Output overvoltage or undervoltage. LED error blink rate is 500 mSec on, 500 mSec off. ______________________________________________________________________________________________________________________________ 1 of 2 SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com JBL702A Series Universal Input, 20 Watt Output Li-ion/Polymer Chargers 2 Year Warranty Model Number Key JBL702 A 06 500 00 03 F J Model Input Connector: Output Connector: Custom item s Charge Current Charge Voltage Config. Product Fam ily Model Number Threshold Volts (V) "J" = Standard. "02" and higher indicates a m odified m odel. "F" = IEC320 C14 grounded "03" = 2.5m m Barrel Type connector, center (+). Other options available. "00" = Standard Model "200" = 2.00A "08" = 8.4V, etc. "A" = Original Design Configuration Fast Charge Current (A) Switchover Current (A) Fast Charge Voltage (V) Overvoltage Protection (V) Max Watts JBL702A082000003FK 5.0V 2.0A 0.450A 8.4V 8.8+/- 0.05V 17.0W JBL702A161200203FC 10.0V 1.2A 0.240A 16.8V 17.6+/-0.2V 20.0W Input Receptacle "F" = IEC320 C14 Class I Grounded Output Connector Notes: 1. Ault #3 Connector, center contact 2. Connector is Sw itchcraft 760 plug or equivalent. Suggested m ating connector is Sw itchcraft 712A or equivalent. 3. Other connector options are available. Contact your local SL Pow er Representative for details. Outline Drawing Data Sheet © 2014 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication. Rev. 9-20-2014 However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice. ______________________________________________________________________________________________________________________________ 2 of 2 SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com