ETC2 LED100W-020 Switch mode led driver Datasheet

LED-100W Series– Fixed Output and Dimmable
Switch Mode LED Drivers
Constant Current & Constant Voltage with Isolation
Black Magic Thermal Advantage™ Aluminum Housing
Electrical Specifications
Input Voltage Range:
100-277 Vac Nom. (90-305 V Min/Max)
Input Over-Voltage:
Can endure 320Vac for 48 Hrs, 350Vac for 2 Hrs
Frequency:
50/60 Hz Nom. (47-63 Hz Min/Max)
Power Factor:
>0.90 @ full load, 100V through 277V
Inrush Current:
<30.0 Amps max @ 230 Vac, cold start 25ºC
Input Current:
1.30 Amps max
Maximum Power:
100W
Current Accuracy:
± 1% Over input line variation
Load Regulation:
± 3%
THD:
<
_ 20% @ full load
Leakage Current:
400 µA Typical
Hold Up Time:
Half Cycle
Protection:
utput Over-Voltage, Output Over-Current, and
O
Output Short Circuit Protection reset by power cycling
Electrical Specifications
Minimum Starting Temp:
-30ºC
Maximum Case Temp.
90°C
UL Type TL Rating:
Non-Class 2: 90/73°C
Storage Temperature:
-40ºC to +85ºC
Humidity:
5% to 95%
Cooling:
Convection
Vibration Frequency:
5 to 55 Hz/2g, 30 minutes
Sound Rating:
MTBF:
EMC:
• Total Power: 100 Watts
• Input Voltage: 100-277 Vac Nom.
• UL Dry & Damp Location Rated
• IP66
• High Power Factor
• UL Type HL Rated for Hazardous Locations
• UL Sign Components Manual (S.A.M. Models)
Constant Current - Product Specifications
Model Number
Output Current Output Voltage
(mA ±3%)
Range (Vdc)
Max. Output
Power (W)
Typical
Efficiency
92%
LED100W-286-C0350-XX
350
95-286
100
LED100W-222-C0450-XX
450
74-222
100
92%
Class A
LED100W-143-C0700-XX
700
47-143
100
91%
LED100W-095-C1050-XX
1050
31-95
100
91%
18,000 Hours at full load and 40ºC ambient conditions
4
per MIL-217F Notice 2
LED100W-071-C1400-XX
1400
23-71
100
91%
LED100W-057-C1750-XX
1750
19-57
100
90%
FCC 47CFR Part 15 Class B compliant
LED100W-048-C2100-XX
2100
16-48
100
90%
LED100W-041-C2450-XX
2450
13-41
100
90%
90%
Ordering Options:
LED100W-036-C2800-XX
2800
12-36
100
LED100W-032-C3150-XX
3150
10-32
100
90%
-D:
LED100W-028-C3570-XX
3570
9-28
100
89%
LED100W-024-C4200-XX
4200
8-24
100
89%
LED100W-020-C5000-XX
5000
7-20
100
88%
LED100W-018-C5550-XX
5550
6-18
100
88%
0-10V & Resistance dimmable version comes with an extra two wires +Purple/-Gray on
the output side. -D 0-10V Dimming is compatible with most quality 0-10V wall dimmers.
See page 3 for additional specifications.
-XX indicates dimming options are available. See options at left. Blank = fixed current output
Constant Voltage - Product Specifications
Model Number
TL
E332160
Note:
LED drivers are designed and intended to operate LED loads only.
Non-LED loading may be outside the specified design limits of our
LED drivers, and therefore cannot be covered by any warranty.
If you desire to use our LED drivers to operate non-LED loads
please contact us to discuss compatibility.
Specifications subject to change without notice.
Typical
Efficiency
LED100W-018
18
1388-5550
100
88%
20
1250-5000
100
88%
LED100W-024
TYPE
Max. Output
Power (W)
LED100W-020
•
24
1050-4200
100
89%
28
893-3570
100
89%
LED100W-032
32
788-3150
100
90%
LED100W-036
36
700-2800
100
90%
LED100W-041
41
613-2450
100
90%
LED100W-048
48
525-2100
100
90%
LED100W-057
57
438-1750
100
90%
91%
LED100W-028
Sign Components Manual
Output Voltage Output Current
(Vdc ±5%)
Range (mA)
LED100W-071
71
350-1400
100
LED100W-095
95
263-1050
100
91%
LED100W-143
143
175-700
100
91%
LED100W-222
222
113-450
100
92%
LED100W-286
286
88-350
100
92%
• Indicates S.A.M.
Rev 10-12-16
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com
LED100W Series
SSL Solutions Faster Than The Speed Of Light®
Pg 2 of 3
Dimensions - Inches (mm)
6.81 [173.0]
0.31 [7.8]
1.06 [27]
2.81 [71.3]
0.16 [4]
0.24 [6]
6.42 [163.0]
7.25 [184.0]
0.39±0.04 [10±1]
5.91 Min [150 Min]
0.90 [22.8]
Dimming
Purple (+)
Gray (-)
INPUT
Black (L)
White (N)
Green/Yellow (GND) 0.39±0.04
[10±1]
2.24±0.12 [57.0±3]
2.24±0.12 [57.0±3]
OUTPUT
Red (+)
Blue (-)
3.21 [81.5]
Tc = 90°C max
Power Factor / Load
1.00
THD / Load
50%
0.90
45%
0.80
40%
0.70
35%
0.60
30%
THD
PF
1.83 [46.5]
5.91 Min [150 Min]
WIRE SPECS:
Input Leads: 18 AWG, rated 600 V, 105C, min.
Output Leads: 18 AWG, rated 300 V, 105C, min.
Dimming Leads: 22 AWG, rated 300 V, 105C.
All wires are stranded with solder dipped ends.
0.50
0.40
25%
120Vac
277Vac
0.30
0.20
15%
0.10
10%
0.00
50%
60%
70%
80%
90%
Load
120Vac
277Vac
20%
100%
0%
50%
60%
70%
80%
Load
90%
100%
Lifetime/Case Temperature
(Full Load @ 120Vac)
350
Lifetime (kHrs)
300
250
200
150
100
50
0
45
Safety Cert.
Standard
UL/CUL
UL8750 & CAN/CSA-22.2
CE
EN 61347
EMC Standard
Notes
FCC, 47CFR Part 15
Class B
EN 61000-3-2
50
55
60
65
70
75
80
85
Case Hotspot Temperature (°C)
90
Note:
The area under the life-temperature curve represents where the driver
has highly reliable operation within specification. Driver performance
may drift out of published specifications as the hours of operation
exceed the curve at a given temperature. Higher operating
temperatures increase the chances of a failure to function.
Other electrical, mechanical and environmental factors affect
driver lifetime but are not represented in this calculation.
EN 61000-3-3
Class C
EN 61000-4-5
2 kV/4 kV 8/20µsec
UL Conditions of Acceptability
See website for additional information
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com
LED100W Series
SSL Solutions Faster Than The Speed Of Light®
Pg 3 of 3
“-D” Option: 0-10VDC and Resistance Dimming
Parameters
Minimum
Typical
Maximum
0 mA
-2.0 V
—
—
2 mA
+15 V
Source Current out of 0-10V Purple Wire
Absolute Voltage Range on 0-10V (+) Purple Wire
Typical Dimming Circuit
Dim (+) Purple
LED100W-XX-CXXXX-D
IP710 Wall Dimmer
Dim (-) Gray
(Dimmer must be current-sink type control)
Output Current / 0-10VDC Dimming Input
Output Current %
100
90
80
70
60
50
40
30
20
10
0
0V
1V
2V
3V
4V
5V
6V
Dimming Input (Vdc)
7V
8V
9V
10V
Notes:
1.
2.
3.
4.
0-10V dimmable version comes with an extra two wires +Purple/-Gray on the output side.
Compatible with most 0-10V Wall Slide dimmers and direct 0-10V analog signal. Recommended dimmer is Leviton IP710 or equivalent
0-10V dimmable version is not intended to dim below about 5% @ 0V or 10% @ 1.0V
0-10V dimmable version output will be 100% with Purple/Gray open and minimum with Purple/Gray Shorted.
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com
Similar pages