DTAM165 SERIES Up to 165 Watts, Medical AC/DC Desktop Power Supplies Rev A Wall Industries, Inc. FEATURES • RoHS Compliant • No Load Power Consumption < 500mW • PF > 0.9 at 230VAC • Single Outputs Ranging from 12VDC to 48VDC • Up to 165 Watts Output Power • Over Voltage, Over Load, and Short Circuit Protection • 90~264 VAC Input Voltage Range • CSA-C22.2 601.1-M90, NEMKO EN60601-1, & CB IEC60601-1 • High Efficiency up to 87% Size: 6.69 x 3.35 x 1.73 inches 170.0 x 85.0 x 44.0 mm 3rd Edition Medical Approvals • MTBF > 100,000 Hours • Fully Meets CEC, ERP, EISA Efficiency Level V Requirements • IEC-320-C14 AC Inlet • 100% Burn-in and Hi-pot Tested DESCRIPTION The DTAM165 series of medical AC/DC desktop power supplies provides up to 165 Watts of output power in a 6.69” x 3.35” x 1.73” package. This series consists of 12V, 15V, 19V, 24V, 28V, 36V, and 48VDC single output models with a 90-264VAC wide input range and an IEC-320-C14 AC inlet connector. This series also feature a high efficiency up to 87% and a power factor > 0.9 at 230VAC. These supplies are also protected against short circuit, over voltage, and over load conditions. The DTAM165 series has CSAC22.2 NO.601.1-M90, Nemko EN60601-1, and CB IEC60601-1 3rd edition medical approvals. This series is also CE marked and meets EN55011 Class B, FCC Part 18 Class B, and EN60601-1-2 EMC standards. MODEL SELECTION TABLE Model Number Input Voltage Range Output Voltage Output Current Ripple & Noise Output Regulation Output Power DTAM-160A-1Y12H 12 VDC 13.33A 120mVp-p ±5% 160W DTAM-160A-1Y15H 15 VDC 10.67A 150mVp-p ±5% 160W DTAM-160A-1Y19H 19 VDC 8.42A 190mVp-p ±5% 160W 24 VDC 6.88A 240mVp-p ±3% 165W DTAM-165A-1Y28H 28 VDC 5.89A 280mVp-p ±3% 165W DTAM-165A-1Y36H 36 VDC 4.58A 360mVp-p ±3% 165W DTAM-165A-1Y48H 48 VDC 3.44A 480mVp-p ±3% 165W 90 - 264 VAC DTAM-165A-1Y24H DERATING CURVE Output Power (%) 120 Convection Cooling: 100 0 to +60°C derating linearly 2.5% per °C from +41°C to +60°C 80 60 40 20 0 0 10 20 30 40 50 60 70 Ambient Temperature (°C) 08/14/2013 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 1 of 3 Rev A Wall Industries, Inc. DTAM165 SERIES Up to 165 Watts, Medical AC/DC Desktop Power Supplies TECHNICAL SPECIFICATIONS: DTAM165 SERIES All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. SPECIFICATION TEST CONDITIONS Min Typ Max Unit INPUT SPECIFICATIONS Input Voltage Range 90 264 VAC Input Frequency 47 63 Hz Input Current (rms) Inrush Current 90VAC 2.5 264VAC 1.0 115VAC, cold start, 25°C 65 115VAC, cold start, 25°C 130 No Load Power Consumption Power Factor Correction A Apeak 500 115VAC and full load 0.95 230VAV and full load 0.90 mW OUTPUT SPECIFICATIONS Output Voltage See Table Output Regulation See Table Output Power See Table Output Current See Table Minimum Load 0 Ripple & Noise Measured at 20MHz limited bandwidth and with 0.1μF ceramic and 10μF electrolytic capacitors in parallel across the output Hold-up Time 115VAC and full load % 1.0 % 10 ms PROTECTION Over Voltage Protection Over Load Protection Shutdown and latch off, AC recycle Automatic recovery Automatic recovery Short Circuit Protection Automatic recovery GENERAL SPECIFICATIONS Efficiency 115/230VAC and average load 87 % ENVIRONMENTAL SPECIFICATIONS Operating Temperature Derating linearly 2.5% per °C from +41°C to +60°C Storage Temperature Range Humidity Non-condensing 0 +60 °C -10 +80 °C 0 90 % Cooling Free air convection MTBF Full load, 25°C ambient temperature 100,000 hours PHYSICAL SPECIFICATIONS Weight 1.73 lbs (790g) Dimensions (L x W x H) AC Inlet Output Connector 6.69 x 3.35 x 1.73 in (170.0 x 85.0 x 44.0 mm) IEC-320-C14 Several options available SAFETY & EMC Safety Approvals EMC Standards 08/14/2013 CSA C22.2 601.1-M90: 3rd edition, NEMKO EN60601-1: 3rd edition, CB IEC60601-1: 3rd edition EN60601-1-2, EN55011 Class B, FCC Part 18 Class B, CE Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 2 of 3 Rev A Wall Industries, Inc. DTAM165 SERIES Up to 165 Watts, Medical AC/DC Desktop Power Supplies MECHANICAL DRAWING Top View 6.69 (170.0) Rear View 3.35 (85.0) DC Output Cable Front View Side View 1.73 (44.0) 4X Rubber Foot Label Area Bottom View 0.08 (2.0) NOTES 1. Unit: inches (mm) 2. AC Inlet: IEC-320-C14 3. Plastic Case Color: Black 4. Tolerance: ±0.5mm 5. Several output connector options available 6. All dimensions are for reference only Standard output cable: AWM 2464 #16 AWG / 3C + SHIELDING, UL 80°C 300V VW-1, 1050mm COMPANY INFORMATION Wall Industries, Inc. has created custom and modified units for over 50 years. Our in-house research and development engineers will provide a solution that exceeds your performance requirements on-time and on budget. Our ISO9001-2008 certification is just one example of our commitment to producing a high quality, well-documented product for our customers. Our past projects demonstrate our commitment to you, our customer. Wall Industries, Inc. has a reputation for working closely with its customers to ensure each solution meets or exceeds form, fit and function requirements. We will continue to provide ongoing support for your project above and beyond the design and production phases. Give us a call today to discuss your future projects. Contact Wall Industries for further information: Phone: (603)778-2300 E-mail: [email protected] 08/14/2013 Toll Free: (888)597-9255 Web: www.wallindustries.com Fax: (603)778-9797 Address: 37 Industrial Drive, Exeter, NH 03833 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 3 of 3