<^E.m.i-C.ond\j.ctoi LPioaucti, Line. TELEPHONE: (973) 376-2922 (212)227-6005 FAX: (973) 376-8960 20 STERN AVE. SPRINGFIELD, NEW JERSEY 07081 U.S.A. Silicon Power Tab Transistor D40P FEATURING: POWER-GLAS Passivation High Free Air Power Dissipation Hard Solder Mountdown Fast Switching Brown for Nl'N Brown Leads can be formed to a TO 5 Pin Configuration. absolute maximum ratings: (25°c unless otherwise specified) Voltages Collector to Emitter Emitter to Base Collector to Base Current Collector (Continous) Power Dissipation Tab at 25°C Tab at 70T Free Air at SO°C Free Ak at 50°C (without tab) Thermal Resistance Junction to Case Junction to Ambient (with tab) (without tab) Temperature Operating Storage Lead Soldering, 1/16" + 1/32" From case for 10 sec. max. V CEO V E8O V CBO D40P1 120 7 200 D40P3 180 7 250 D40P5 225 7 300 0.5 Amp. -6.25 . Watts Watts Watts Watts lc - 4.0 • -1.33 • • 1.0 PT Volts Volts Volts t/W R0JC R#JA °c/w °ow 75 100 Dimensional Outlines T -55 t o + 1 5 0 55 to+150- Tj Tstg An insulating hardware kit (mica washer, nylon shoulder washor, and solder lug) is available at an additional cost upon request. Kit #13868189P11. °c TL electrical characteristics: <25°c unless otherwise specified) Forward Current Transfer Ratio ( I c = 8 0 m A , V C E = 10V) (Ic = 2 mA, V C E = 10V) Collector to Emitter Voltage (Ic = 1.0 mA, I b = 0) D40P1 D40P3 D40P5 Collector Cutoff Current (Rated V CEO ) Emitter Cutoff Current (V E 80= 7V > Collector Saturation Voltage (l c = 100mA, 1B = 10mA) Base Saturation Voltage (Ic= 100 mA, IB = 10 mA) Gain Bandwidth Product ( l c = 80mA, V C E = 10V) Storage Time <I C (ON) = 80 mA, 1B (ON) = 8 mA l e (OFF) = 8 mA) Collector Capacitance (VCB = 10V, 1E = 0) Mm. Max. Units 40 20 VCEO Volts Volts Volts 120 180 225 ICBO 10 IEBO 10 MA V CE (SAT) i Volt V B E (SAT) 1.5 Volt MHz <T tS CCB 2.5 Pi NJ Semi-Conductors reserves the right to change test conditions, parameter limits and package dimensions without notice. Information furnished b> NJ Semi-Conductors is believed to be both accurate and reliable at the time of going to press. However. NJ Semi-Conductors assumes no responsibility for any errors or omissions discovered in its use. VI Semi-Conductors encourages customers ro verify that datasheets are current before phicing orders.