Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: http://www.frontierusa.com 3A FAST RECOVERY PLASTIC RECTIFIER FR30-005-LFR THRU FR30-10-LFR FEATURES z FAST RECOVERY TIMES z UL 94V-0 FLAME RETARDANT EPOXY MOLDING COMPOUND z DIFFUSED JUNCTION z LOW COST z HIGH SURGE CURRENT CAPABILITY z ROHS 1.0(25.4) MIN .052(1.3) .048(1.2) .375(9.5) .335(8.5) .220(5.6) .197(5.0) MECHANICAL DATA z CASE: TRANSFER MOLDED, DO201AD, DIMENSIONS IN INCHES AND (MILLIMETERS) z LEADS: SOLDERABLE PER MIL-STD-202, METHOD 208 z POLARITY: CATHODE INDICATED BY COLOR BAND z WEIGHT: 1.2 GRAMS 1.0(25.4) MIN MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25°C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% FR30-005 FR30-01 FR30-02 FR30-04 FR30-06 FR30-08 FR30-10 UNITS RATINGS SYMBOL -LFR -LFR -LFR -LFR -LFR -LFR -LFR MAXIMUM RECURRENT PEAK REVERSE VOLTAGE VRRM 50 100 200 400 600 800 1000 V MAXIMUM RMS VOLTAGE VRMS 35 70 140 280 420 560 700 V MAXIMUM DC BLOCKING VOLTAGE VDC 50 100 200 400 600 800 1000 V MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT IO 3.0 A 0.375”(9.5mm) LEAD LENGTH AT TA=55°C PEAK FORWARD SURGE CURRENT, 8.3ms SINGLE HALF IFSM 150 A SINE-WAVE SUPERIMPOSED ON RATED LOAD TYPICAL JUNCTION CAPACITANCE (NOTE 1) CJ 28 PF TYPICAL THERMAL RESISTANCE (NOTE 2) Rθja 20 ℃/W STORAGE TEMPERATURE RANGE TSTG -55 TO + 150 ℃ OPERATING TEMPERATURE RANGE TOP -55 TO + 125 ℃ ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) FR30-005 FR30-01 FR30-02 FR30-04 FR30-06 FR30-08 FR30-10 UNITS CHARACTERISTICS SYMBOL -LFR -LFR -LFR -LFR -LFR -LFR -LFR MAXIMUM FORWARD VOLTAGE AT IO DC VF 1.3 V MAXIMUM REVERSE CURRENT AT 25℃ IR 5 μA MAXIMUM REVERSE CURRENT AT 100℃ IR 50 μA MAXIMUM REVERSE RECOVERY TIME (NOTE 3) TRR 150 250 NOTE: 1. MEASURED AT 1 MHZ AND APPLIED REVERSE VOLTAGE 0F 4.0 VOLTS 2. BOTH LEADS ATTACHED TO HEAT SINK 63.5x63.5x1t(mm) COPPER PLATE AT LEAD LENGTH 5mm 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A FR30-005-LFR THRU FR30-10-LFR Page: 1 500 nS RATINGS AND CHARACTERISTIC CURVE FR30-005-LFR THRU FR30-10-LFR FIG. 1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC Trr 10Ω NO INDUCTIVE 50Ω NO INDUCTIVE +0.5A (-) D.U.T. PULSE GENERATOR ( NOTE 2 ) (+) 25 Vdc (approx) 1Ω NON INDUCTIVE (-) OSCILLOSCOPE ( NOTE 1 ) 0 -0.25A (+) -1.0A 1cm NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10ns MAX. SOURCE IMPEDANCE=50 OHMS SET TIME BASE FOR 10/20 ns/cm Fig. 3-MAXIMUM FORWARD SURGE NUMBER OF CYCLES 3.0 SINGLE PHASE HALF WAVE 60Hz RESISTIVE OR INDUCTIVE LOAD 2.0 1.0 0 0 20 40 PEAK FORWARD SURGE CURRENT AMPERES Io-AVERAGE RECTIFIED CURRENT (A) Fig. 2-MAXIMUM CURRENT DERATING CURVE 60 80 100 120 140 160 180 200 200 8.3ms Single Half Sine-Wave (JEDEC Method) 100 50 10 1 TA-AMBIENT TEMPERATURE (OC) 10 NUMBER OF CYCLES AT 60HZ FIG. 5-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS INSTANTANEOUS REVERSE CURRENT, MICROAMPERES 10 Tj=100oC 1.0 Tj=50oC 0.1 Tj=25oC 0.01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE, % FR30-005-LFR THRU FR30-10-LFR INSTANTANEOUS FORWARD CURRENT AMPERES FIG. 4-TYPICAL REVERSE CHARACTERISTICS 100 10 1.0 0.1 Tj=25oC PULSE WIDTH =300us 1% DUTY CYCLE 0.01 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 INSTANTANEOUS FORWARD VOLTAGE, VOLTS Page: 2 100