RoHS HER201-207 HIGH EFFICIENCY RECTIFIER VOLTAGE RANGE CURRENT FEATURES D T ,. L 50 to 800 Volts 2.0 Amperes Low power loss,high efiiciency. Low leakage. .034(0.9) High speed switching. .028(0.7) High current capability. 1.0(25.4) MIN High surge capability. High temperature soldering guaranteed: o 260 C/10 seconds/0.375 ＂ (9.5mm)lead length at 5 lbs (2,3kg) tension .300(7.6) .230(5.8) MECHANICAL DATA IC Case: Transfer molded plastic Epoxy: UL94V-0 rate flame retardant C DO-15 DIA. O .140(3.6) DIA .104(2.6) 1.0(25.4) Polarity: Color band denotes cathode end Lead: Plated axial lead ,solderable per MIL-STD-202E method 208C Mounting position: Any Weight: 0.014 ounce,0.39 gram R T O N MIN Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 oC ambient temperature unless otherwise specified. Single phase,half wave,60Hz,resistive or inductive load. For capacitive load derate current by 20%. C E L Maximum Repetitive Peak Reverse Voltage Maximum RMS Voltage SYMBOLS HER HER 201 202 HER HER HER HER HER UNITS 203 204 205 206 207 V olts V RRM 50 100 200 300 400 600 800 V RMS 35 50 70 140 210 280 420 100 200 300 400 600 560 V olts 800 V olts Maximum DC Blocking Voltage V DC Maximum Average Forward Rectified Current o 0.375 ＂ (9.5mm) lead length at T A =50 C I (AV) 2.0 A mps Peak Forward Surge Current 8.3ms single half sine-wave superimposed on I FSM 60 A mps J E E rated load (JEDEC Method) Maximum Instantaneous Forward Voltage Drop at 2.0A Maximum DC Reverse Currentat rated DC o blocking voltage T A =25 C W Maximum Full Load Reverse Curren, full cycle o average 0.375 ＂ (9.5mm) lead length at T L =55 C VF 1.0 1.3 IR 5.0 I R(AV) 100 Maximum Reverse Recovery Time(NOTE1) Typical Junction Capacitance(NOTE2) t rr CJ Typical Thermal Resistance(NOTE3). R JA 50 1.5 1.7 V olts A A 70 30 nS pF 20 40 O T J ,T STG -65 to +150 Operating and Storage Temperature Range NOTES: 1.Test condition:I F =0.5A,I R =1.0A.I RR =0.25A. 2.Measured at 1MHz and applied reverse of 4.0volts. 3.Thermal resistance from junction to ambient with 0.375”(9.5mm) lead length,P.C.B.mounted. WEJ ELECTRONIC CO. Http:// www.wej.cn E-mail:[email protected] C/W O C RoHS FIG.2-MAXIMUM NON-REPETITIVE PEAK DERATING CURVE FORWARD SURGE CURRENT 3.0 PEAK FORWARD SURGE Single Phase Half Wave 60Hz Resistive or Inductive Load 0.375 ＂(9.5mm) Lead Length 0 0 25 50 75 100 125 150 8.3ms Single Half Sine-Wave (JEDEC Method) T j=Tjmax CURRENT,(A) 2.0 1.0 60 40 20 0 175 o 1 0V 80 (A) 0.001 0.4 C E L E 0.6 0.8 1.0 1.2 1.4 1.6 O 10 20 40 60 100 O FIG.4-TYPICAL REVERSE N CHARACTERISTICS 10 o Tj=100 C 1.0 o Tj=25 C 0.1 0 1.8 20 40 60 80 100 120 140 PERCENT OF RATED PEAK INSTANTANEOUS FORWARD VOLTAGE,(V) J E 8 (uA) 0V 60 30 0/4 00 V 100 50/ R T 0.1 o 6 100 INSTANTANEOUS REVERSE CURRENT, /20 0V 10 T j=25 C Pulse Width=300us 1% Duty Cycle 4 NUMBER OF CYCLES AT 60 Hz FORWARD CHARACTERISTICS 0.01 2 IC AMBIENT TEMPERATURE,( C) 1.0 C 1 Cycle FIG.3-TYPICAL INSTANTANEOUS INSTANTANEOUS FORWARD CURRENT, D T ,. L FIG.1-TYPICAL FORWARD CURRENT (A) AVERAGE FORWARD CURRENT, HER201-207 REVERSE VOLTAGE,(%) FIG.5-TYPICAL JUNCTION CAPACITANCE JUNCTION CAPACITANCE,(pF) 100 W FIG.6-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC HE R2 HER 01- 206- HE R2 05 50 NONINDUCTIVE +0.5A 10 NONINDUCTIVE HER (-) 207 (+) 10 D.U.T. 25 Vdc (approx.) PULSE GENERATIOR (NOTE 2) (+) (-) 1 NON INDUCTIVE 0.1 1.0 0 -0.25A OSCILLOSCOPE (NOTE 1) o Tj=25 C f=1MHz Vsig=50mVp-p 1 Trr -1.0A 10 100 NOTES: 1.Rise Time=7ns max.Input Impedance= 1 megohm.22pF 2.Rise time=10ns max.Source Impedance= 50 ohms 1cm SET TIME BASE FOR 50/100ns/cm REVRESE VOLTAGE,(V) WEJ ELECTRONIC CO. Http:// www.wej.cn E-mail:[email protected]