M ICROWAVE A Division of Crystek Corporation PERFORMANCE SPECIFICATION MIN TYP Lower Frequency: Upper Frequency: MAX UNITS 1145 MHz 4.5 VDC 1210 MHz Tuning Voltage: 0.5 Supply Voltage: 4.75 5.0 5.25 VDC Output Power: +2.0 +4.0 +6.0 dBm 25 35 mA Harmonic Suppression (2 Harmonic): -15 -10 dBc Pushing: 1.0 2.0 MHz/V Pulling, all Phases: 1.0 2.0 MHz pk-pk Supply Current: nd Tuning Sensitivity: 50 MHz/V Phase Noise @ 10kHz offset: -106 -104 dBc/Hz Phase Noise @ 100kHz offset: -128 -126 dBc/Hz 22 pF Load Impedance: 50 Input Capacitance: Operating Temperature Range: -40 +85 °C Storage Temperature Range: -45 +90 °C Phase Noise (1 Hz BW, Typical) Tuning Curve (Typical) Page 1 of 2 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com M ICROWAVE A Division of Crystek Corporation BOTTOM VIEW SIDE VIEW Gold Finish [RF] Solder Mask 0.465 SQ (11.81 SQ) 0.030 (0.76) 0.100 (2.54) 0.052 (1.32) 0.025 (0.64) 14 0.215 15 0.115 16 0.180 0.280 0.380 9 0.405 7 0.305 6 0.205 5 0.105 Pad Connection 2 10 14 Others Vt RF-OUTPUT Vcc GROUND PAD LOCATION 0.000 1 0.000 TOP ORIENTATION MARK 8 2 3 4 0.500 0.315 10 0.415 13 11 0.315 0.415 12 0.115 CRYSTEK CVCO55CL 1145-1210 YYWW 0.500 (12.70) 0.500 0.215 BOTTOM ORIENTATION MARK 0.500 (12.70) 0.080 0.040 (1.02) [Vt] TOP VIEW 0.150 (3.81) [Vcc] Unless otherwise specified, Dimensions are in: IN (mm) Pad Location Dimensions are in: Inches TAPE AND REEL 0.059 Ø TYP (1.50 Ø) TYP 0.157±0.004 (4.00±0.10) 0.945±0.012 (24.00±0.30) DIRECTION OF FEED 0.630±0.004 (16.00±0.10) Drawing not to scale Product Control: Crystek Part Number: CVCO55CL-1145-1210 Release Date: 12-May-08 Revision Level: A Responsible: C. Vales CRYSTEK CORPORATION Specification is subject to change without notice Page 2 of 2 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com