CSD-SMA-2500 Surge Diverter SMA Coaxial Cable Power Surge Protection Specifications Parameters Frequency < 2.5GHz Insertion Loss <0.2dB Max RF Power 37W Clamping Voltage 90Vdc VSWR 1.20:1 Impedance 50Ohms Max Discharge Current 40kA (8/20us) Connectors SMA Male - SMA Female General Description Size 41mm x 22mm (1.6” x 0.9”) The CSD-SMA-2500 Surge Diverter is a low insertion loss for applications up to 2.5GHz. This in-line surge arrestor has SMA male and SMA female connectors and fitted 6mm2 earth cable, that protects the module from the impact of lightning/transients via the antenna port. Housing Plated Brass Mounting In-line between ELPRO product and coaxial cable Weight 100g (3.5oz) The CSD-SMA-2500 is designed to be connected directly to the antenna port allowing simple installation or retrofit. Used with the CC3, CC10, CC20 SMA male to N-type male coaxial cable kits, allows connection to ELPRO products with SMA female/male antenna connector. Note: Surge Protection Devices rely on good earthing practices to be effective. This product assumes both a metallic enclosure and good earth connection to the enclosure. If in doubt, apply another earth under the locknut to create a sufficient Earth. Also note: In applications of high vibration, it is recommended to use CSD-N-6000 Surge Diverter. Warning: Do not stand near or touch operating equipment during an electrical storm as the CSD-SMA-2500 will not protect personnel. Note: Specifications subject to change. Ordering To order, select product code from the table and specify country of application. Product Code Description CSD-SMA-2500 SMA Surge Diverter for use with CC3, CC10, CC20-SMA Product Compatibility The following products are compatible with this accessory. Please refer to product datasheets for compatibility details to suit your application. Product Code Description Data Sheet # CC3-SMA CC10-SMA CC20-SMA Coaxial Cable Kit - 3m (9.8’)/10m (32’)/20m (65’), N-type to SMA 7932 7947 7948 CCTAIL-SMA-F Coaxial Cable Tail - 600mm (24”), N-type Female to BNC/SMA Male 7951 The only controlled copy of this Data Sheet is the electronic read-only version located on the Cooper Bussmann Network Drive. All other copies of this document are by definition uncontrolled. This bulletin is intended to clearly present comprehensive product data and provide technical information that will help the end user with design applications. Cooper Bussmann reserves the right, without notice, to change design or construction of any products and to discontinue or limit distribution of any products. Cooper Bussmann also reserves the right to change or update, without notice, any technical information contained in this bulletin. Once a product has been selected, it should be tested by the user in all possible applications. ©2013 Cooper Bussmann www.cooperbussmann.com/wireless 0513 BU-SB13583 Page 1 of 1 Datasheet: 7959