Document 1022 Isolation Transformer For Texas Instruments SN6501 Transformer Driver • Developed to work with Texas Instruments SN6501 Transformer Driver for Isolated Power Supplies • Center tapped primary and secondary windings • Designed to meet UL/CSA/IEC 60950 Basic Insulation with 1.5 mm creepage and clearance. Core material Ferrite Terminations RoHS tin-silver over tin over nickel over phos bronze. Other terminations available at additional cost. Weight 0.98 g Ambient temperature –40°C to +125°C Storage temperature Component: –40°C to +125°C. Tape and reel packaging: –40°C to +80°C Isolation 2500 Vrms, one minute, winding to winding Resistance to soldering heat Max three 40 second reflows at +260°C, parts cooled to room temperature between cycles Moisture Sensitivity Level (MSL) 1 (unlimited floor life at <30°C / 85% relative humidity) Failures in Time (FIT) / Mean Time Between Failures (MTBF) 38 per billion hours / 26,315,789 hours, calculated per Telcordia SR-332 Packaging 600/13″ reel Plastic tape: 24 mm wide, 0.37 mm thick, 16 mm pocket spacing, 6.1 mm pocket depth PCB washing Tested to MIL-STD-202 Method 215 plus an additional aqueous wash. See Doc787_PCB_Washing.pdf. DCR max (Ohms)3 Pri / sec Inductance2 1 Part number voltage min (µH) pri sec MA5632-AL_ 3.3 V to 5.0 V 17.8 0.086 0.219 Leakage inductance4 max (µH) 0.464 Volt-time product5 (V-µsec) 17.6 Power6 (W) 2.0 1. When ordering, please specify termination and packaging codes: MA5632-ALD Termination: L = RoHS compliant tin-silver over tin over nickel over phos bronze. Special order: T = RoHS tin-silver-copper (95.5/4/0.5) or S = non-RoHS tin-lead (63/37). Packaging: D = 13″ machine ready reel. EIA-481 embossed plastic tape (600 per full reel). B = Less than full reel. In tape, but not machine ready. To have a leader and trailer added ($25 charge), use code letter D instead. 2. Inductance is tested between pins 4 and 3 at 500 kHz, 0.5 Vrms, 0 Adc. 3. DCR is per winding. 4. Leakage inductance is for the primary with both windings connected in series and with the secondary windings shorted. 5. Based on Bsat of the core at 25°C and number of turns on winding 4-3. 6. Calculated output power based on 150 kHz operating frequency. Power varies depending on application. 7. Electrical specifications at 25°C. Refer to Doc 362 “Soldering Surface Mount Components” before soldering. Pri Turns ratio pri : sec 1:2 4 8 3 2 7 1 5 6 Sec Primary windings and secondary windings to be connected in series on the PC board. Dimensions are in inches mm Document 1022 Revised 08/24/12