2 to 4 GHz Bandpass Filter AFL05290 Features ▪ Small Size ▪ Fully Shielded Component ▪ Frequency Stable over Temperature Description Surface mount, fully shielded, thin film filter designed for use on PCB 812 mils thick with permitivity of 3.0-3.8. Electrical Specifications 3000 MHz Center Frequency 2000 - 4000 MHz Passband 2.5 dB @ 25C 3.0 dB -40C to +85C VSWR 1.63:1 2000 MHz to 4000 MHz* Rejection 40 dB dc to 1250 MHz 40 dB 4850 MHz to 6000 MHz Insertion Loss (@Fc) -55 to +125 degree C Usable Temp Range *50 Ohm System Mechanical Footprint LxW 0.450 x 0.400 inch inch [11.43 x10.16] mm 0.113 [2.87] Height Inch [mm] Typical Performance 0 -5 -10 -15 -20 Magnitude in dB -25 -30 -35 -40 -45 Frequency Response -50 -55 -60 -65 -70 -75 -80 1000 1250 1500 1750 2000 2250 2500 2750 3000 3250 3500 3750 4000 4250 4500 4750 5000 5250 5500 5750 6000 Frequency in MHz Catalog specifications subject to change without notice 1of3 AFL05290 May 2013 Revision A Narrow Band Performance 0 -10 Magnitude in dB -20 -30 -40 -50 -60 -70 1000 3000 4000 Frequency in MHz 5000 6000 3800 4300 Passband Performance Return Loss 0 2000 0 -10 -1 -30 -2 Magnitude in dB Magnitude in dB -20 -40 -3 -50 -60 -4 -70 -80 1800 2of3 2300 2800 3300 Frequency in MHz 3800 4300 -5 1800 AFL05290 2300 2800 3300 Frequency in MHz May 2013 Revision A Mechanical Drawing All units in inches Mounting Information PCB ground pattern length and width can be 0.002-0.003 inches larger than filter footprint. Dimensions of filter launch and PCB launch pattern should be closely matched. It is suggested that PCB ground metal be pulled back from RF I/O trace to account for component alignment tolerance. Ground via depth and spacing should be set so as not to create any resonances at the frequency of operation. Reference SMT Filter Mounting application note for additional mounting information. Dielectric Laboratories, Inc. 2777 Route 20 East, Cazenovia, NY 13035 USA Phone: (315) 655-8710 Fax: (315)655-0445 Email: [email protected] 3of3 AFL05290 May 2013 Revision A