HETERO JUNCTION FIELD EFFECT TRANSISTOR NE3514S02 K BAND SUPER LOW NOISE AMPLIFIER N-CHANNEL HJ-FET FEATURES • Super low noise figure and high associated gain NF = 0.75 dB TYP., Ga = 10 dB TYP. @ f = 20 GHz • Micro-X plastic (S02) package APPLICATIONS • 20 GHz-band DBS LNB • Other K-band communication systems ORDERING INFORMATION Part Number Order Number Package NE3514S02-T1C NE3514S02-T1C-A S02 (Pb-Free) NE3514S02-T1D NE3514S02-T1D-A Quantity 2 kpcs/reel Marking Supplying Form • 8 mm wide embossed taping D • Pin 4 (Gate) faces the perforation side 10 kpcs/reel of the tape Remark To order evaluation samples, contact your nearby sales office. Part number for sample order: NE3514S02-A ABSOLUTE MAXIMUM RATINGS (T A = +25C) Parameter Symbol Ratings Unit Drain to Source Voltage VDS 4 V Gate to Source Voltage VGS 3 V Drain Current ID IDSS mA Gate Current IG 100 A 165 mW Total Power Dissipation Ptot Note Channel Temperature Tch +125 C Storage Temperature Tstg 65 to +125 C Note Mounted on 1.08 cm 1.0 mm (t) glass epoxy PCB 2 Caution: Observe precautions when handling because these devices are sensitive to electrostatic discharge Document No. PG10593EJ01V0DS (1st edition) Date Published February 2006 CP(N) NE3514S02 RECOMMENDED OPERATING CONDITIONS (T A = +25C) Parameter Symbol MIN. TYP. MAX. Unit VDS 1 2 3 V Drain Current ID 5 10 15 mA Input Power Pin 0 dBm Drain to Source Voltage ELECTRICAL CHARACTERISTICS (T A = +25C, unless otherwise specified) Parameter Symbol Test Conditions MIN. TYP. MAX. Unit Gate to Source Leak Current IGSO VGS = 3 V 0.5 10 A Saturated Drain Current IDSS VDS = 2 V, VGS = 0 V 15 40 70 mA VGS (off) VDS = 2 V, ID = 100 A 0.2 0.7 2.0 V Transconductance gm VDS = 2 V, ID = 10 mA 40 55 mS Noise Figure NF VDS = 2 V, ID = 10 mA, f = 20 GHz 0.75 1.0 dB Associated Gain Ga 8 10 dB Gate to Source Cutoff Voltage 2 Data Sheet PG10593EJ01V0DS NE3514S02 TYPICAL CHARACTERISTICS (T A = +25C, unless otherwise specified) Remark The graphs indicate nominal characteristics. Data Sheet PG10593EJ01V0DS 3 NE3514S02 S-PARAMETERS 4 Data Sheet PG10593EJ01V0DS NE3514S02 RF MEASURING LAYOUT PATTERN (REFERENCE ONLY) (UNIT: mm) RT/duroid 5880/ROGERS t = 0.254 mm r = 2.20 tan delta = 0.0009 @10 GHz Data Sheet PG10593EJ01V0DS 5 NE3514S02 PACKAGE DIMENSIONS S02 (UNIT: mm) 6 Data Sheet PG10593EJ01V0DS NE3514S02 RECOMMENDED SOLDERING CONDITIONS This product should be soldered and mounted under the following recommended conditions. For soldering methods and conditions other than those recommended below, contact your nearby sales office. Soldering Method Infrared Reflow Partial Heating Soldering Conditions Condition Symbol Peak temperature (package surface temperature) : 260C or below Time at peak temperature : 10 seconds or less Time at temperature of 220C or higher : 60 seconds or less Preheating time at 120 to 180C : 12030 seconds Maximum number of reflow processes : 3 times Maximum chlorine content of rosin flux (% mass) : 0.2%(Wt.) or below Peak temperature (terminal temperature) : 350C or below Soldering time (per side of device) : 3 seconds or less Maximum chlorine content of rosin flux (% mass) : 0.2%(Wt.) or below IR260 HS350 Caution Do not use different soldering methods together (except for partial heating). Data Sheet PG10593EJ01V0DS 7 NE3514S02 Caution GaAs Products This product uses gallium arsenide (GaAs). GaAs vapor and powder are hazardous to human health if inhaled or ingested, so please observe the following points. • Follow related laws and ordinances when disposing of the product. If there are no applicable laws and/or ordinances, dispose of the product as recommended below. 1. Commission a disposal company able to (with a license to) collect, transport and dispose of materials that contain arsenic and other such industrial waste materials. 2. Exclude the product from general industrial waste and household garbage, and ensure that the product is controlled (as industrial waste subject to special control) up until final disposal. • Do not burn, destroy, cut, crush, or chemically dissolve the product. • Do not lick the product or in any way allow it to enter the mouth. 8 Data Sheet PG10593EJ01V0DS