LED-40W-HL-HV Series– Hazardous Location, High Voltage Input Drivers Fixed Output and Dimmable Switch Mode LED Drivers Constant Current & Constant Voltage with Isolation Black Magic Thermal Advantage™ Plastic Housing Electrical Specifications Input Voltage Range: 347-480 Vac Nom. (312-528 V Min/Max) Frequency: 50/60 Hz Nom. (47-63 Hz Min/Max) Power Factor: >0.90 @ >60% load 347V, >80% load 480V Inrush Current: <30.0 Amps max @ 480Vac, full load, cold start 25ºC Input Current: 0.14 Amps typical @ 347Vac, 60 Hz, full load Maximum Power: 40W Current Accuracy: ± 3% Over input line variation Load Regulation: ± 4% THD: < _ 20% @ any load, 347V/480V Leakage Current: 600 µA Typical Hold Up Time: Half Cycle Output Protection: Over-Voltage, Over-Current, Short Circuit (Auto Recovery) • Total Power: 40 Watts • Input Voltage: 347-480 Vac Nom. • UL Dry & Damp Location Rated • IP66 • High Power Factor • UL Type HL, with V5A Case and internal thermal protection • Rated for Hazardous Locations Environmental Specifications Maximum Case Temp. 90°C Minimum Starting Temp: -30ºC Storage Temperature: -40ºC to +85ºC Humidity: 5% to 95% Cooling: Constant Current - Product Specifications Output Current Output Voltage Max Output Typical (mA ±5%) Range (Vdc) Power (W) Efficiency Model Number LED40W-130-C0300-HL-XY-HV 300 44-130 39.0 86% LED40W-114-C0350-HL-XY-HV 350 38-114 39.9 86% Convection LED40W-100-C0400-HL-XY-HV 400 33-100 40 85% Vibration Frequency: 5 to 55 Hz/2g, 30 minutes LED40W-089-C0450-HL-XY-HV 450 30-89 40 85% Sound Rating: Class A LED40W-072-C0550-HL-XY-HV 550 24-72 39.6 84% LED40W-057-C0700-HL-XY-HV 700 20-57 40 83% MTBF @ 40ºC: 482,000 Hours at full load, per MIL-217F Notice 2 LED40W-048-C0830-HL-XY-HV 830 16-48 39.8 83% EMC: FCC 47CFR Part 15 Class B compliant LED40W-045-C0900-HL-XY-HV 900 16-45 40 83% Weight: 12.9 oz (364 g) LED40W-040-C1000-HL-XY-HV 1000 13-40 40 82% LED40W-036-C1100-HL-XY-HV 1100 12-36 39.6 82% LED40W-030-C1400-HL-XY-HV 1400 10-30 42 82% LED40W-024-C1670-HL-XY-HV 1670 8-24 40 82% LED40W-022-C1820-HL-XY-HV 1820 7-22 40 82% LED40W-018-C2200-HL-XY-HV 2200 6-18 39.6 81% LED40W-015-C2680-HL-XY-HV 2680 5-15 40 81% LED40W-013-C3080-HL-XY-HV 3080 4-13 40 81% LED40W-012-C3330-HL-XY-HV 3330 4-12 40 81% LED40W-010-C4000-HL-XY-HV 4000 3-10 40 81% LED40W-009-C4450-HL-XY-HV 4450 3-9 40 80% -X indicates lead options. B for bottom leads, S for side leads. -Y indicates dimming options are available. See options below. Blank = fixed current output Ordering Options: -D:Dimmable model dims 100-10%. Two extra wires on the output side: +Purple/-Gray. It offers 0-10V & Resistance dimming, compatible with most quality 0-10V dimmers. See page 3. -P: PWM dimmable version dims 100-10%. Two extra wires on the output side: +Purple/-Gray. It is PWM Dimmable via a positive duty cycle, 200Hz to 1KHz, 0-10V Pulse. See page 4. E332160 Note: LED drivers are designed and intended to operate LED loads only. Non-LED loading may be outside the specified design limits of our LED drivers, and therefore cannot be covered by any warranty. If you desire to use our LED drivers to operate non-LED loads please contact us to discuss compatibility. Specifications subject to change without notice. Constant Voltage - Product Specifications Model Number Output Voltage (Vdc ±5%) Output Current Range (mA) Max Output Power (W) Typical Efficiency LED40W-009-HL-X-HV 9 1113-4450 40 82% LED40W-010-HL-X-HV 10 1000-4000 40 83% LED40W-012-HL-X-HV 12 825-3330 40 83% LED40W-013-HL-X-HV 13 770-3080 40 84% LED40W-015-HL-X-HV 15 670-2680 40 84% LED40W-018-HL-X-HV 18 550-2200 39.6 84% LED40W-022-HL-X-HV 22 455-1820 40 85% LED40W-024-HL-X-HV 24 418-1670 40 85% LED40W-030-HL-X-HV 30 350-1400 42 85% LED40W-036-HL-X-HV 36 275-1100 39.6 85% LED40W-040-HL-X-HV 40 250-1000 40 85% LED40W-045-HL-X-HV 45 225-900 40 85% LED40W-048-HL-X-HV 48 208-830 39.8 85% LED40W-057-HL-X-HV 57 175-700 40 85% LED40W-072-HL-X-HV 72 138-550 39.6 85% LED40W-089-HL-X-HV 89 113-450 40 86% LED40W-100-HL-X-HV 100 100-400 40 86% LED40W-114-HL-X-HV 114 75-350 39.9 86% LED40W-130-HL-X-HV 130 75-300 39.0 87% Class 2: US/Canada Rev 8-26-15 Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com LED40W-HL-HV Series SSL Solutions Faster Than The Speed Of Light® Pg 2 of 4 Dimensions - Inches (mm) Standard “-BY” Bottom Leads Configuration: “-SY” Optional Side Leads Configuration: 3.78 [96] 3.78 [96] 1.89 [48] 1.18 [30] 1.18 [30] 1.89 [48] 2.8 [71] Tc = 90°C max 2.8 [71] Tc = 90°C max 0.39 [10] 0.39 [10.0] 1.2 [30.5] 0.39 [10.0] 1.2 [30.5] 0.39 [10] 1.00 0.95 0.90 30% 95% 25% 90% 20% PF THD 0.85 0.80 0.70 5% 0.65 60% Load 80% 100% 130 347 Vac 480 Vac 85% 80% CE FCC, 47CFR Part 15 EN 55015 EN61000-3-2 EN61000-3-3 EN61000-4-5 70% 0% 35% 35% 60% 60% 80% 80% Normalized Output Voltage Load UL8750, CAN/CSA-C22.2 No. 250.13-12, UL1310 & CAN/CSA-22.1 No. 223-M91 (for Class 2), UL1012/CS-C22.2 No.107.1 (for Non-Class 2) EN 61347-1, EN 61347-2-13 Class B > 80% Rated Power Class C 2kV/4kV 5.91 Min [150 Min] Lifetime / Case Temperature 90 75 60 45 30 347 Vac 480 Vac 75% Safety and EMC Compliance UL/CUL 0.39±0.04 [10±1] 115 10% 347 Vac 480 Vac Dimming Purple (+) Gray (-) 0.16 [4] Typical Efficiency THD / Load / Load 15% 0.75 0.60 35% 5.91 Min [150 Min] WIRE SPECS: Input Leads: 18 AWG, rated 600 V, 105C, min. Output Leads: 18 AWG, rated 300 V, 105C, min. Dimming Leads: 22 AWG, rated 300 V, 105C. All wires are stranded with solder dipped ends. Power Factor / Load DC OUT Red (+) Blue (-) Lifetime (kHrs) Dimming Purple (+) Gray (-) AC IN White (N) Black (L) 1.4 [35.6] DC OUT Red (+) Blue (-) 0.14 [3.6] 0.2 [5] 0.39±0.04 [10±1] Efficiency 0.39±0.04 [10±1] AC IN White (N) Black (L) 5.91 Min [150 Min] 0.16 [4] 1.4 [35.6] 0.14 [3.6] 0.2 [5] 15 100%100% 0 45 50 55 60 65 70 75 80 Case Hotspot Temperature (°C) 85 90 Note: Life calculations are based on reliability with confidence using a 90% confidence level and <5% failure rate. At a confidence level of 90% it is expected that <5% of the parts will fail at the rated life provided. (Failure is defined as a driver drifting outside specification, rather than fail to operate) UL Conditions of Acceptability See website for additional information Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com LED40W-HL-HV Series SSL Solutions Faster Than The Speed Of Light® Pg 3 of 4 “-D” Option: 0-10VDC and Resistance Dimming Parameters Minimum Typical Maximum 0 mA -2.0 V ——- 2 mA +15 V Source Current out of 0-10V Purple Wire Absolute Voltage Range on 0-10V (+) Purple Wire “-D” Typical Dimming Circuit Dim (+) Purple LED40W-xxx-Cxxxx-HL-D-HV IP710 Wall Dimmer Dim (-) Gray (Dimmer must be current-sink type control) Output Current / 0-10VDC Dimming Control Voltage Output Current % 100 90 80 70 60 50 40 30 20 10 0 0V 1V 2V 3V 4V 5V 6V 7V Purple-to-Gray Voltage (Vdc) 8V 9V 10V Notes: 1. 2. 3. 4. D dimmable version comes with an extra two wires on the output side: +Purple/-Gray. Compatible with most 0-10V dimmers. Recommended dimmer is Leviton IP710 or equivalent. D & D3 dimmable versions are not intended to dim below about 5% @ 0V or 10% @ 1.0V. Output will be 100% with Purple/Gray open and minimum with Purple/Gray Shorted. Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com LED40W-HL-HV Series SSL Solutions Faster Than The Speed Of Light® Pg 4 of 4 “-P” Option: PWM Dimming Parameters Absolute Maximum Voltage Range on PWM Input (Purple Wire) Input LOW Level Voltage Range (Purple Wire) Input HIGH Level Voltage Range (Purple Wire) Sink Current into PWM Input (Purple Wire) Source Current out of PWM Input (Purple Wire) PWM Input Signal Frequency PWM Input Signal Positive Duty Cycle Minimum Typical Maximum -2.0V -2.0V +9.0V 0mA 0mA 500Hz 0% 10V 0V 10V ———10-90% +15V +5.5V +15V 1.2mA 2mA 1500Hz 100% “-P” PWM Positive Dimming Typical Circuit PWM (+) Purple LED40W-XX-CXXXX-HL-P-HV PWM In PWM (-) Gray Output Current / 1.0kHz Positive Duty Cycle Output Current % 100 90 80 70 60 50 40 30 20 10 0 0% 10% 20% 30% 40% 50% 60% Positive Duty Cycle 70% 80% 90% 100% Notes: 1. PD dimmable version comes with an extra 2 wires on the output side for PWM type dimming: +Purple/-Gray. 2. Below 10% Duty cycle proper dimming operation is not assured. Unit is not intended to turn off at <10% Duty Cycle. 3. Output will be 100% with Purple/Gray open and minimum with Purple/Gray Shorted. Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com