Vectron EX-4000-DAJ-147 Evacuated miniature crystal oscillator Datasheet

EX-400
Evacuated Miniature Crystal Oscillator
EX-400
Description
The EX-400 provides exceptionally low aging rates and tight temperature stabilities in an extremely small package over a wide
range of environmental conditions. This EMXO series bridges the gap between current large, high precision OCXO’s and smaller
TCXO’s. The EX-400 Series becomes the most economical choice where there is a need for spectral purity, short and long term
stability, along with small size and dramatically reduced power consumption.
Features
•
•
•
•
•
Applications
4-Pin Dip
Uses Doubly Rotated Crystal
Low Power Consumption: <0.35 watts @ +25°C
Previous Model Number: EX-380, EX-381, EX-385 series
Frequency Range: 10 MHz - 80 MHz
•
•
•
•
SONET/SDH, DWDM, FDM, ATM, 3G
Telecom Transmission and Switching Equipment
Wireless Communication Equipment
Military Airborne and Mobile systems
Performance Specifications
Frequency Stabilities1
Parameter
vs. operating temperature range (referenced to +25°C)
Min
-75
-100
-100
-150
-150
-150
-250
-250
-250
-500
-500
-500
Typ
Max
Units
Condition
+75
+100
+100
+150
+150
+150
+250
+250
+250
+500
+500
+500
ppb
ppb
ppb
ppb
ppb
ppb
ppb
ppb
ppb
ppb
ppb
ppb
-20… +70°C (10 to 20.49 MHz)
-20… +70°C
(10 to 50 MHz)
-40… +85°C (10 to 20.49 MHz)
-20… +70°C
-40… +85°C
-55… +85°C (10 to 50 MHz)
-20… +70°C
-40… +85°C
-55… +85°C
-20… +70°C
-40… +85°C
-55… +85°C
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Performance Specifications
Frequency Stabilities1
Parameter
vs. Stratum
3 per
GR-1244CORE
Operating Temp
Holdover
Drift
MTIE
Min
Typ
-140
-140
-140
-370
-4.63
Warm-up Time
Max
Units
Condition
+140
+140
+140
+370
+4.63
+1
ppb
ppb
ppb
ppb
10-13/sec
ppm
-20… +70°C
-40… +85°C (10 to 50 MHz)
-55… +85°C (10 to 20.49 MHz)
24 hours
Over 7100 seconds
0.16sec < Observe Times < 64 sec
1
2
minutes
minutes
to ± 1ppm of final frequency (1 hour)
to ± 100ppb of final frequency (1 hour)
Initial Tolerance (10 to 19.9 MHz)
Initial Tolerance (20 to 80 MHz)
-1.0
-1.5
+1.0
+1.5
ppb
ppb
for fixed frequency
for fixed frequency
vs. supply voltage change (10 to 50 MHz)
vs. supply voltage change (50 to 80 MHz)
-2.5
-5.0
+2.5
+5.0
ppb
ppb
VS ± 5%
VS ± 5%
vs. load change (10 to 80 MHz)
-15
+15
ppb
Load ± 5%
vs. aging / day (10 to 14.9 MHz)
vs. aging / day (15 to 19.9 MHz)
vs. aging / day (20 to 49.9 MHz)
vs. aging / day (50 to 80.0 MHz)
-1.0
-2.0
-3.0
-4.0
+1.0
+2.0
+3.0
+4.0
ppb
ppb
ppb
ppb
after 30 days of operation
after 30 days of operation
after 30 days of operation
after 30 days of operation
vs. aging / 1 year (10 to 14.9 MHz)
vs. aging / 1 year (15 to 19.9 MHz)
vs. aging / 1 year (20 to 80 MHz)
-200
-300
-500
+200
+300
+500
ppb
ppb
ppb
after 30 days of operation
after 30 days of operation
after 30 days of operation
vs. aging / 10 year (10 to 14.9 MHz)
vs. aging / 10 year (15 to 19.9 MHz)
vs. aging / 10 year (20 to 80 MHz)
-1000
-2000
-3000
+1000
+2000
+3000
ppb
ppb
ppb
after 30 days of operation
after 30 days of operation
after 30 days of operation
Supply Voltage (Vs)
Supply voltage (Standard)
4.75
5.0
5.25
VDC
Supply voltage (Option)
3.135
3.3
3.465
VDC
1.5
Watts
during warm-up
0.35
Watts
steady state @ +25°C (10 to 29.99 MHz)
0.45
Watts
steady state @ +25°C (30 to 80 MHz)
0.7
Watts
steady state @ -40°C (10 to 29.99 MHz)
0.8
Watts
steady state @ -40°C (30 to 80 MHz)
Power Consumption
RF Output
Signal [Standard]
HCMOS
15
Load
Signal Level (Vol)
pF
0.4
0.8
Signal Level (Voh)
VDC
Rise/Fall Time
40
Duty cycle
VDC
Signal [Option]
+5
ns
(10-80%)
60
%
(Voh-Vol)/2
Sinewave
Load
50
ohm
Output Power [Standard]
0
+4
dBm
50 Ohm load
Output Power [Option]
+3
+7
dBm
50 Ohm load
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Frequency Stabilities1
Parameter
Min
Typ
Max
Units
Condition
Frequency Tuning (EFC)
Tuning Range
Fixed OCXO; No adjust
Tuning Range
Control Voltage Range
±1.0
±2.0
±3.0
±4.0
±5.0
±8.0
±10.0
±12.0
ppm
ppm
ppm
ppm
0
Vdd
VDC
with 10 to 14.99 MHz
with 15 to 20.48 MHz
with 20.5 to 49.99 MHz
with 50 to 80 MHz
Positive
Tuning Slope
Additional Parameters
Phase Noise @ 20 MHz (Typical)
Phase Noise @ 50 MHz (Typical)
-100
dBc/Hz
10 Hz
-130
dBc/Hz
100 Hz
-140
dBc/Hz
1 KHz
-145
dBc/Hz
10 KHz
-150
dBc/Hz
10 KHz
-80
dBc/Hz
10 Hz
-110
dBc/Hz
100 Hz
-130
dBc/Hz
1 KHz
-135
dBc/Hz
10 KHz
-140
dBc/Hz
10 KHz
0.2
ppb
Tau = 1 sec to 10 sec (10 to 20.49 MHz)
0.5
ppb
Tau = 1 sec to 10 sec (20.5 to 80 MHz)
5
g
Allan Deviation
Weight
Absolute Maximum Ratings
Supply Voltage
Output Load
5.5
VDC
with Vs=5 V
5.5
VDC
with Vs=3.3 V
30
pF
Operable temperature range
-55
+85
°C
Storage temperature range
-55
+85
°C
Outline Drawing / Enclosure
Dimensions in mm (inches)
Type A
Code
Height “H”
Pin Length “L”
0
7.62
5.08
Pin Connections
1
EFC \ No Connect \ Oven Monitor
7
Ground (Case)
8
RF Output
14
Supply Voltage Input
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Outline Drawing / Enclosure
Dimensions in mm (inches)
Type B
Code
Height “H”
Pin Length “L”
1
8.9 (0.35”)
NA
2
10.2 (0.4”)
NA
Pin Connections
1
EFC \ No Connect \ Oven Monitor
7
Ground (Case)
8
RF Output
14
Supply Voltage Input
Recommended Reflow Profile
tp
Critical Zone
Tp
TL to Tp
Ramp up
TL
tL
Temperature
Ts
Ramp dow n
Ts
ts
preheat
25
t 25°C to peak
Time
Profile Feature
PRECAUTION:
Sn-Pb Assembly
Profile Feature
Sn-Pb Assembly
Series shall not expose to temperature higher than 230°C. If exposing to temperature higher than
230°C, stability and power consumption may permanently degrade.
Average ramp-up rate (TL to Tp)
3°C/second max.
Time 25°C to Peak Temperature
4 minutes max.
Preheat -Temperature Min Tsmin)
-Temperature Min Tsmax)
-Time (min to max) (ts)
135°c
155°c
60-90 seconds
Time maintained above
- Temperature (TL)
- Time (tL)
183°C
45-60 seconds
Tsmax to TL - Ramp-up Rate
3°C/second max.
Time maintained above
- Temperature (TL) 183°C
- Time (tL)
45-60 seconds
Time within 5°C of actual
Peak Temperature (tp)
10-20 seconds max.
Peak Temperature (Tp)
Ramp-down Rate
6°C/second max.
max 220°C
Note: All temperatures refer to topside of the package, measured on the package body surface.
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Ordering Information
EX - 400 0 - D A J - 107 0 - 10M0000000
Frequency
Product Family
EX: EMXO
Frequency Control
0: Fixed Frequency (HCMOS)
1: Fixed Frequency (0 dBm)
2: Fixed Frequency (+3 dBm)
3: Electrical Tuning (HCMOS)
4: Electrical Tuning (0 dBm)
5: Electrical Tuning (+3 dBm)
6: Oven Alarm Option (HCMOS)
7: Oven Alarm Option (0 dBm)
8: Oven Alarm Option (+3 dBm)
Package
13x20mm
Height
0: A 7.62mm (HCMOS only)
1: B 8.9mm (HCMOS only)
2: B 10.2mm (Sinewave only)
Supply Voltage
D: +5V
E: +3.3V
Stability Code
758: ±75ppb
107: ±100ppb
157: ±150ppb
257: ±250ppb
507: ±500ppb
147: ±140ppb(ST3)
RF Output Code
A: HCMOS
E: Sinewave
Temperature Range
A: -55°C to +85°C
E: -40°C to +85°C
J: -20°C to +70°C
Notes:
1. Contact factory for improved stabilities or additional product options. Not all options and codes are available at all
frequencies.
2. Unless other stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency
control voltage, load, temperature (25°C).
3. Phase noise degrades with increasing output frequency.
4. Subject to technical modification.
5. Contact factory for availability.
For Additional Information, Please Contact
USA:
Europe:
Asia:
Vectron International
267 Lowell Road
Hudson, NH 03051
Tel: 1.888.328.7661
Fax: 1.888.329.8328
Vectron International
Landstrasse, D-74924
Neckarbischofsheim, Germany
Tel: +49 (0) 3328.4784.17
Fax: +49 (0) 3328.4784.30
Vectron International
1F-2F, No 8 Workshop, No 308 Fenju Road
WaiGaoQiao Free Trade Zone
Pudong, Shanghai, China 200131
Tel: 86.21.5048.0777
Fax: 86.21.5048.1881
Disclaimer
Vectron International reserves the right to make changes to the product(s) and or information contained herein without notice. No liability is assumed as a result of their use or application.
No rights under any patent accompany the sale of any such product(s) or information.
Rev: 2-23-2009 daf
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Similar pages