DIGITRON SEMICONDUCTORS MAC10 SERIES MAC11 SERIES SILICON BIDIRECTIONAL THYRISTORS Available Non-RoHS (standard) or RoHS compliant (add PBF suffix). Available as “HR” (high reliability) screened per MIL-PRF-19500, JANTX level. Add “HR” suffix to base part number. MAXIMUM RATINGS Rating Symbol Peak repetitive off-state voltage (TJ = 100°C) MAC10-1,MAC11-1 MAC10-2,MAC11-2 MAC10-3,MAC11-3 MAC10-4,MAC11-4 MAC10-5,MAC11-5 MAC10-6,MAC11-6 MAC10-7,MAC11-7 MAC10-8,MAC11-8 VDRM RMS on-state current (TC = 75°C) IT(RMS) Value Unit (1) Peak non-repetitive surge current (1 cycle, 60Hz, TJ = -40 to + 100°C) ITSM Circuit fusing considerations (TJ = -40 to + 100°C, t = 8.3ms) I2t Volts 10 Amps Amps 100 40 A2s PGM 10 Watts PG(AV) 0.5 Watts Peak gate power Average gate power 25 50 100 200 300 400 500 600 Peak gate current IGM 2 Amps Operating junction temperature range TJ -40 to +100 °C Tstg -40 to +150 °C 8 In. lb. Storage temperature range Mounting torque (6-32 screw)(2) Note 1: Ratings apply for open gate conditions. Thyristor devices shall not be tested with a constant current source for blocking capability such that the voltage applied exceeds the rated blocking voltage. Note 2: Torque rating applies with use of torque washer. Mounting torque in excess of 8 in. lb. does not appreciably lower case to sink thermal resistance. Anode lead and heatsink contact pad are common. * Soldering temperatures shall not exceed 200°C THERMAL CHARACTERISTICS Characteristic Symbol Maximum Unit Thermal resistance, junction to case RӨJC 2.0 °C/W Thermal resistance, junction to ambient RӨJA 50 °C/W ELECTRICAL CHARACTERISTICS (TC = 25°C unless otherwise noted) Characteristic Symbol Peak blocking current (either direction) (VD = Rated VDRM, gate open, TJ = 100°C) IDRM Peak on-state voltage (either direction) (ITM = 14A peak) VTM Gate trigger current (continuous dc) (VD = 12V, RL = 100Ω) MT2(+),G(+); MT2(-),G(-) , MAC10, MAC11 MT2(+),G(-); MT2(-), G(+), MAC10 IGT Gate trigger voltage (continuous dc) (VD = 12V, RL = 100Ω) MT2(+),G(+); MT2(-),G(-) , MAC10, MAC11 MT2(+),G(-); MT2(-), G(+), MAC10 VGT Gate trigger voltage (continuous dc) (VD = Rated VDRM, RL = 100Ω, TJ = 100°C) All modes VGD 144 Market Street Kenilworth NJ 07033 USA phone +1.908.245-7200 fax +1.908.245-0555 Min Typ. Max - - 2.0 - 1.3 1.8 - - 50 75 - 0.9 1.0 2.0 2.5 0.2 - - [email protected] www.digitroncorp.com Rev. 20130207 Unit mA Volts mA Volts Volts DIGITRON SEMICONDUCTORS MAC10 SERIES MAC11 SERIES SILICON BIDIRECTIONAL THYRISTORS Characteristic Symbol Holding current (either direction) (VD = 12V, ITM = 100mA, gate open) IH Gate controlled turn-on time (ITM = 14A, IGT = 100mA) ton Blocking voltage application rate at commutation (@ VDRM, TJ = 75°C, gate open) dv/dt Min Typ. Max - - 50 - 1.5 - - 5.0 - MECHANICAL CHARACTERISTIC Case TO-220AB Marking Alpha-numeric Pin out See below TO-220AB A B C D F G H J K L N Q R S T U V Z 144 Market Street Kenilworth NJ 07033 USA phone +1.908.245-7200 fax +1.908.245-0555 Inches Min Max 0.575 0.620 0.380 0.405 0.160 0.190 0.025 0.035 0.142 0.147 0.095 0.105 0.110 0.155 0.014 0.022 0.500 0.562 0.045 0.055 0.190 0.210 0.100 0.120 0.080 0.110 0.045 0.055 0.235 0.255 0.050 0.045 0.080 Millimeters Min Max 14.600 15.750 9.650 10.290 4.060 4.820 0.640 0.890 3.610 3.730 2.410 2.670 2.790 3.930 0.360 0.560 12.700 14.270 1.140 1.390 4.830 5.330 2.540 3.040 2.040 2.790 1.140 1.390 5.970 6.480 1.270 1.140 2.030 [email protected] www.digitroncorp.com Rev. 20130207 Unit mA µs V/µs DIGITRON SEMICONDUCTORS MAC10 SERIES MAC11 SERIES 144 Market Street Kenilworth NJ 07033 USA SILICON BIDIRECTIONAL THYRISTORS phone +1.908.245-7200 fax +1.908.245-0555 [email protected] www.digitroncorp.com Rev. 20130207 DIGITRON SEMICONDUCTORS MAC10 SERIES MAC11 SERIES 144 Market Street Kenilworth NJ 07033 USA SILICON BIDIRECTIONAL THYRISTORS phone +1.908.245-7200 fax +1.908.245-0555 [email protected] www.digitroncorp.com Rev. 20130207