GBJ2001 THRU GBJ2007 SINGLE PHASE 20.0 AMP BRIDGE RECTIFIERS VOLTAGE RANGE 50 to 1000 Volts CURRENT 20.0 Amperes GBJ FEATURES * Ideal for printed circuit board .134(3.4) .122(3.1) 1.193(30.3) 1.169(29.7) .189(4.8) .173(4.4) .150(3.8) .134(3.4) ~ ~ .165(4.2) .142(3.6) .094(2.4) .078(2.0) .043(1.1) .035(0.9) .441(11.2) .425(10.8) + * Mounting position: Any .800(20.3) .776(19.7) * Low leakage current .708(18.0) .669(17.0) .189 (4.8) * Low forward voltage .114(2.9) .098(2.5) .031(0.8) .023(0.6) .402(10.2) .303(7.7) .303(7.7) SPACING .386(9.8) .287(7.3) .287(7.3) Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating 25 C ambient temperature uniess otherwies specified. Single phase half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. TYPE NUMBER GBJ2001 GBJ2002 GBJ2003 GBJ2004 GBJ2005 GBJ2006 GBJ2007 UNITS 50 35 50 Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward (with heatsink Note 2) 100 70 100 200 140 200 400 280 400 600 420 600 800 560 800 1000 700 1000 V V V 20.0 A Rectified Current at Tc=100 C (Without heatsink) Peak Forward Surge Current, 8.3 ms single half sine-wave 3.6 A superimposed on rated load (JEDEC method) Maximum Forward Voltage Drop per Bridge Element at 10.0A D.C. Maximum DC Reverse Current Ta=25 C 260 1.1 5.0 A V A at Rated DC Blocking Voltage Typical Junction Capacitance (Note 1) Typical Thermal Resistance R JC (Note 2) Operating Temperature Range, TJ Storage Temperature Range, TSTG 500 A 60 0.8 -55 +150 -55 +150 PF C/W C C Ta=100 C NOTES: 1. Measured at 1.0MHz and applied reverse voltage of 4.0V DC. 2. Thermal Resistance from Junction to Case with device mounted on 300mm x 300mm x 1.6mm Cu Plate Heatsink. 320 RATING AND CHARACTERISTIC CURVES (GBJ2001 THRU GBJ2007) FIG.2-MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT WITH HEATSINK 18 Single Phase 15 Half Wave 60Hz 12 Resistive Or Inductive Load 9 6 3 0 WITHOUT HEATSINK 0 20 40 60 80 100 120 140 160 500 400 300 260 8.3ms Single Half Tj=25 C Sine Wave 200 JEDEC method 100 0 1 CASE TEMPERATURE,( C) 50 10 5 100 NUMBER OF CYCLES AT 60Hz FIG.3-TYPICAL FORWARD FIG.4-TYPICAL REVERSE CHARACTERISTICS CHARACTERISTICS 50 50 10 10 REVERSE LEAKAGE CURRENT, ( A) INSTANTANEOUS FORWARD CURRENT,(A) AVERAGE FORWARD CURRENT,(A) 27 24 21 PEAK FORWARD SURGE CURRENT,(A) FIG.1-TYPICAL FORWARD CURRENT DERATING CURVE 3.0 1.0 Tj=25 C Pulse Width 300us 1% Duty Cycle 0.1 3.0 Tj=100 C 1.0 0.1 Tj=25 C .01 0 .2 .4 .6 .8 1.0 1.2 .01 1.4 FORWARD VOLTAGE,(V) 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE, (%) 321