CAR Series Thin Film Precision Chip Resistor • • • • • Resistances from 1 Ohm to 3M Ohms Power Rating 0.06 to 0.75 Watt Resistance Tolerances to ± 0.01% TCR’s to ±5 ppm/°C Sizes: 0402 /0603 / 0805 / 1206 / 2010 / 2512 SPECIFICATIONS Type CAR0402 CAR0603 CAR0805 CAR1206 CAR2010 CAR2512 Power Rating (W) at 70°C 0.0625 0.0625 0.1 0.125 0.25 0.5 - 0.1 0.125 0.25 0.33 0.75 50 to 205k 50 to 70k 1 to 1M 5 - 332k 1 to 2M 5 to 511k 1 to 2.5M 5 to 1M High Power Rating (W) at 70°C ( Add HP to part number ) Standard Resistance Range (W) Low TCR Resistance Range (W) Operating Temperature 1 to 3M 5 to 1M -55 - +155°C MAX Operating Voltage1 25V 50V 100V 150V MAX Overload Voltage2 50V 100V 200V 300V Tolerances (depending on ohmic value) 0.01% / 0.05% / 0.1% / 0.25% / 0.5% / 1% Temperature Coefficient (depending on ohmic value) ± 5 to ± 50 Dimensions (LxWxT) mm [inches] 1.00 x 0.50 x 0.3 [0.04 x 0.02 x 0.012] Packaging (pcs) Tape and Reel 10,000 1.55 x 0.80 x 0.45 [0.06 x 0.03 x 0.018] 2.00 x 1.25 x 0.55 [0.08 x 0.05 x 0.022] 3.05 x 1.55 x 0.55 [0.12 x 0.06 x 0.022] 5,000 5.00 x 2.50 x 0.55 [0.20 x 0.10 x 0.022] 6.30 x 3.10 x 0.55 [0.25 x 0.12 x 0.022] 4,000 1 Operating Voltage = 2 ( P * R ) or MAX Listed, whichever is lower. Overload Voltage = 2.5 * ( P * R ) or MAX Listed, whichever is lower. Ordering Information Part Description: Part Type - Resistance - Tolerance - TCR - HP option - Packaging Example: CAR 0402 50Ohms 0.05% 25ppm (Note: if no TCR is specified: The highest value will be supplied) Riedon Inc. 300 Cypress Avenue 09/13 Alhambra CA 91801 (626) 284-9901 (626) 284-1704 www.riedon.com CAR Series Thin Film Precision Chip Resistor Pow er Derating Curve 100 Power (%) 80 60 40 20 0 0 20 40 60 70 80 100 120 140 155 Am bient Tem perature (°C) Environmental Characteristics Test Requirement Tol. < 0.05% TCR Short Time Overload Tol. >0.05% As Spec. ΔR±0.05% Conditions +25/-55/+25/+125/+25°C ΔR±0.2% RCWV*2.5 or Max. overload voltage for 5 seconds ΔR±0.2% for high power rating Insulation Resistance >1000 MΩ ΔR±0.05% Load Life Apply 100VDC for 1 minute ΔR±0.2% 70±2°C, Max. working voltage for 1000 hrs with 1.5 hrs “ON” and 0.5 hrs “OFF” >7kΩ ΔR±0.5% ΔR±0.5% for high power rating ΔR±0.05% ΔR±0.3% Damp Heat with Load 40±2°C, 90~95% R.H. Max. working voltage for 1000 hrs with 1.5 hrs “ON” and 0.5 hrs “OFF” ΔR±0.5% for high power rating Bending Strength ΔR±0.05% Solderability ΔR±0.2% 95% min. coverage Bending amplitude 3 mm for 10 seconds 245±5°C for 3 seconds Resistance to Soldering Heat ΔR±0.05% ΔR±0.2% 260±5°C for 10 seconds Thermal Shock ΔR±0.05% ΔR±0.25% -55°C~150°C, 100 cycles ΔR±0.05% ΔR±0.2% Low Temperature Operation 1 hour, -65°C, followed by 45 minutes of RCWV ΔR±0.5% for high power rating Riedon Inc. 300 Cypress Avenue 09/13 Alhambra CA 91801 (626) 284-9901 (626) 284-1704 www.riedon.com