SL Power MENT1150 Universal input 150 watt sery Datasheet

MENT1150
Universal Input 150 Watt Series
Medical / ITE Switch-Mode Power Supply
3 Year Warranty
•100-240VAC Universal Input
•Meets EISA2007, CEC Efficiency Level V,
EU (EC) No 278/2009 Phase II
•Desktop Style with LED Power-On indicator
•12V to 48V Single Output Models, up to 150W
•Modified and Custom Designs Available
•Regulated Output with Low Ripple
•Impact-Resistant Polycarbonate Enclosure
•No Load Power Consumption <0.5W
nd
•Meets UL/EN/IEC60601-1 & 60950-1 2
edition
RoHS
Specifications
All Specifications are typical at nominal input, full load at 25°C unless otherwise stated.
AC Input
Input Current
100-240Vac, +/-10%, 47-63 Hz, 1∅
115VAC: 3A, 230VAC: 1.5A
Inrush Current
Input Fuse
75A peak @ 264Vac, cold start
4.0A, 250V Internal Primary Current Fuse provided
Efficiency
Meets International Efficiency Level V
MTBF
> 100K hours (calculated, 25 C at full load)
Hold-up Time
20 ms min. @ 115VAC
Overvoltage Protection
130% of nominal output voltage
Overload Protection
120-180% of full rated load, auto-recovery
Short Circuit Protection
Provided with no damage to supply
Output Voltage
See chart
Overtemperature Protection
Output Power
See chart
Input Harmonics
Meets IEC61000-3-2
1% pk-pk max., 20MHz BW
Safety Standards
IEC/EN/UL60601-1 & EN/IEC/UL60950-1 2nd edition
Ripple and Noise
Line/Load Regulation
Including Cord: Line: +/- 1%, Load: +/-5%
Switching Frequency
Transient Response
Maximum deviation of 5% with 25% to
75% load change and 0.2A/uSec slew rate
Not required
Isolation
Minimum Load
Case Material
Case Dimensions
Altitude
Black 94V0 Polycarbonate
see mechanical drawing
-500 to 10,000 ft, operating; -500 to 40,000 ft, non-operating
Operating Temperature
Temperature Coefficient
Latched, requires input recycling
40kHz to130kHz , variable
Input-Output: 4000VAC,
Input-GND: 1500VAC, Output-GND: 700VDC
0° to 40°C Full load Derate linearly to
40% of full rated load at 70°C
0.04% per °C, maximum
Storage Temperature
Relative Humidity
-40°C to +85°C
5% to 95%, non-condensing
EMI/EMC Compliance
Conducted Emissions
FCC Part 15 Subpart B, Class B, EN55011 Class B, EN55024
Radiated Emissions
FCC Part 15 Subpart B, Class B, EN55011 Class B, EN55024
Voltage Fluctuations
EN61000-3-3 Complies (dmax<6%)
Static Discharge Immunity
EN61000-4-2, 6kV Contact Discharge, 8kV air discharge. Criteria A
Radiated RF Immunity
EN61000-4-3, 3V/m. Criteria A
EFT/Burst Immunity
EN61000-4-4, 2kV/5kHz. Criteria A
Line Surge Immunity
EN61000-4-5, 1kV differential, 2kV common-mode, Criteria A
Conducted RF Immunity
EN61000-4-6, 3Vrms, Criteria A
Power Frequency Magnetic Field Immunity
Voltage Dip Immunity
EN61000-4-8, 3A/m, Criteria A
EN61000-4-11, 0 % Vnominal, 0.5 cycle; 40% Vnominal, 5 cycles;
70% Vnominal, 25 cycles: Criteria A
EN61000-3-2, Class A, B, C & D
Line Frequency Harmonics
______________________________________________________________________________________________________________________________ 1 of 2
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
MENT1150
Universal Input 150 Watt Series
Medical / ITE Switch-Mode Power Supply
3 Year Warranty
Model Number
Volts (V)
Output Current (max)
Max Watts
Ripple (Vp-p max)
MENT1150A1251F01
12V
11.67 A
140W
120mV
MENT1150A1551F01
15V
9.33 A
140W
150mV
MENT1150A1851F01
18V
7.78 A
140W
180mV
MENT1150A2451F01
24V
6.25 A
150W
240mV
MENT1150A2851F01
28V
5.35 A
150W
280mV
MENT1150A4851F01
48V
3.12 A
150W
480mV
Model Number Key
MENT 1 150 A VV 51 F 01
Model
Input Connector:
Output Connector:
Output Voltage:
Model
Output Pow er:
# of Outputs
Product Fam ily:
Input Recept.
"01" = Standard. "02" and higher indicates a m odified m odel.
"F" = IEC320 C14 grounded, Other options available, contact the factory.
"51" = Molex 39-01-3065 or equiv. Other options available, contact the factory.
"12" = 12Vdc, "24" = 24Vdc, etc.
"A" = Original Configuration
"150" = 150 Watts
"1" = Single Output
"M" = Medical, "E" = External, "NT" = Model Series Designator
#3 Output Connector - 2.5m m barrel type, center (+)
#51 Output Connector - Molex 39-01-2060 or equiv.
IEC320 - C14
Class I
Grounded (F)
Mate = Molex 39-01-2061 or equiv.
Outline Drawing
Connector Pinout
Pin No. Wire AWG & Color
1
18AWG RED
2
18AWG BLUE
3
18AWG GREEN
4
18AWG WHITE
5
18AWG YELLOW
6
18AWG BLACK
Desig.
+Vout
GND
GND
+Vout
+Vout
GND
Data Sheet © 2011 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication.
Rev. 3-28-2011
However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.
______________________________________________________________________________________________________________________________ 2 of 2
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
Similar pages