GP08A THRU GP08J SINTERED GLASS JUNCTION PLASTIC RECTIFIER VOLTAGE:50 TO 600V CURRENT: 0.8A FEATURE DO-41\DO-204AL High temperature metallurgically bonded construction Sintered glass cavity free junction Capability of meeting environmental standard of MIL-S-19500 High temperature soldering guaranteed 350°C/10sec/0.375”lead length at 5 lbs tension Operate at Ta =55°C with no thermal run away Typical Ir<0.1µA MECHANICAL DATA Terminal: Plated axial leads solderable per MIL-STD 202E, method 208C Case: Molded with UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: color band denotes cathode Mounting position: any Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half-wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) SYMBOL Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC blocking Voltage Maximum Average Forward Rectified Current 3/8”lead length at Ta =45°C Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load Maximum Instantaneous Forward Voltage at 1.0A Maximum full load reverse current full cycle Average at 55°C Maximum DC Reverse Current Ta =25°C at rated DC blocking voltage Ta =125°C Typical Reverse Recovery Time (Note 1) Typical Junction Capacitance (Note 2) Vrrm Vrms Vdc Typical Thermal Resistance (Note 3) GP 08A 50 35 50 GP 08B 100 70 100 GP 08D 200 140 200 GP 08G 400 280 400 Units V V V If(av) 0.8 A Ifsm 25.0 A Vf 1.3 V Ir(av) 30.0 µA Trr Cj 5.0 50.0 2.0 8.0 R(ja) 55.0 µA µA µS pF °C /W °C Ir Storage and Operating Junction Temperature Tstg, Tj -65 to +175 Note: 1. Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A 2. Measured at 1.0 MHz and applied reverse voltage of 4.0Vdc 3. Thermal Resistance from Junction to Ambient at 3/8”lead length, P.C. Board Mounted Rev.A4 GP 08J 600 420 600 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES GP08A THRU GP08J 1 1 Rev.A4 www.gulfsemi.com