DR65-0001 Quad Driver for GaAs FET Switches and Attenuators Rev. V7 Features • • • • • • • High Speed CMOS Technology Complementary Outputs Positive Voltage Control Low Power Dissipation Plastic SOIC Package for SMT Applications Tape and Reel Packaging Available SOIC-16 Package Logic Diagram Ax Cx Bx Description M/A-COM's DR65-0001 is a Quad channel driver used to translate TTL control inputs into gate voltages for GaAs FET microwave switches and attenuators. High speed analog CMOS technology is utilized to achieve low power dissipation at moderate to high speeds, encompassing most microwave switching applications. Pin Configuration Ordering Information Pin No. Function Pin No. Function 1 A3 9 C2 2 B3 10 C1 3 A4 11 GND Part Number Package 4 B4 12 GND DR65-0001 Bulk Packaging 5 VEE 13 A1 DR65-0001TR 1000 piece reel 6 VCC 14 B1 7 C4 15 A2 8 C3 16 B2 Note: Reference Application Note M513 for reel size information. Guaranteed Operating Ranges Symbol Parameter1 Unit Min Typical Max VCC Positive DC Supply Voltage V 4.5 5.0 5.5 VEE Negative DC Supply Voltage V -5.5 -5.0 -4.5 TA Operating Ambient Temperature °C -40 +25 +85 IOH DC Output Current - HIGH mA — — -1.0 IOL DC Output Current - LOW mA — — 1.0 Trise, Tfall Maximum Input Rise or Fall Time nS — — 500 1. All voltages are relative to GND. 1 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. DR65-0001 Quad Driver for GaAs FET Switches and Attenuators Rev. V7 AC & DC Characteristics Over Guaranteed Operating Range Symbol Parameter Test Conditions Units Min Typ Max VIH Input HIGH Voltage Guaranteed HIGH Input Voltage V 2.0 — - VIL Input LOW Voltage Guaranteed LOW Input Voltage V - — 0.8 VOH Output HIGH Voltage IOH = -1 mA VEE = Max V - 0.1 — - VOL Output LOW Voltage IOL = 1 mA VEE = Max V — — VEE + 0.1 IIN Input Current VIN = VCC or GND VEE = Min µA -10 0 10 ICC Quiescent Supply Current VCC = Max VEE = Min VIN = VCC or GND µA — — 400 ΔICC Additional Supply Current, per TTL Input pin VCC = Max VIN = VCC - 2.1V mA — — 1.0 TPHL, TPLH Propagation Delay Guaranteed -40° C to + 85° C nS — — 50 TTHL, TTLH Output Transition Time Guaranteed -40° C to + 85° C nS — — 25 Delay Skew, Output A to Output B Guaranteed -40° C to + 85° C nS — — 8 Switching Waveforms INPUT C VIN TF Absolute Maximum Ratings2,3 TR Parameter Absolute Maximum VCC - .5V to + 6.0 V VEE - 6.0 V to - .5 V VCC - VEE 12 V LOGIC 1 90% 1.3 V 10% LOGIC 0 TPLH TPHL OUTPUT A V IN GND 90% 4 VCC + .5 V V OUT VEE - .5 V Storage Temperature -65°C to +150°C Operating Temperature -40°C to +85°C VOUT 50% OUTPUT B 10% TTLH TTHL VEE Note: See Switching Wave Forms for the definition of the switching terms. Supplies must be by-passed with .01 µF Capacitors. Note: Unused inputs must be tied to Ground Handling Procedures Please observe the following precautions to avoid damage: Static Sensitivity Silicon Integrated Circuits are sensitive to electrostatic discharge (ESD) and can be damaged by static electricity. Proper ESD control techniques should be used when handling these devices. 2. 3. 4. Exceeding any one or combination of these limits may cause permanent damage to this device. M/A-COM does not recommend sustained operation near these survivability limits. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply. Truth Table Input Outputs CX AX BX 0 VEE GND 1 GND VEE 2 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. DR65-0001 Quad Driver for GaAs FET Switches and Attenuators Rev. V7 SOIC-16† † Reference Application Note M538 for lead-free solder reflow recommendations. 3 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice.