MCC TM Micro Commercial Components Features • • • • FR2AL THRU FR2ML omponents 20736 Marilla Street Chatsworth !"# $ % !"# Case Material: Molded Plastic. UL Flammability Classification Rating 94V-0 Easy Pick And Place High Temp Soldering: 260°C for 10 Seconds At Terminals Superfast Recovery Times For High Efficiency 2 Amp Fast Recovery Silicon Rectifier 50 to 1000 Volts Maximum Ratings • • • DO-214AA (SMB) (Lead Frame) Operating Temperature: -50°C to +150°C Storage Temperature: -50°C to +150°C Maximum Thermal Resistance; 15 °C/W Junction To Lead MCC Device Maximum Maximum Maximum Catalog Marking Recurrent RMS DC Number Peak Reverse Voltage Blocking Voltage Voltage FR2AL FR2A 50V 35V 50V FR2BL FR2B 100V 70V 100V FR2DL FR2D 200V 140V 200V FR2GL FR2G 400V 280V 400V FR2JL FR2J 600V 420V 600V FR2KL FR2K 800V 560V 800V FR2ML FR2M 1000V 700V 1000V H J A C A E C D F B D B G Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward I F(AV) 2.0A TA = 90°C current Peak Forward Surge IFSM 50A 8.3ms, half sine Current IFM = 2.0A; Maximum 1.30V Instantaneous VF TJ = 25°C* Forward Voltage Maximum DC Reverse Current At IR 5µA TJ = 25°C Rated DC Blocking 200µA TJ = 125°C Voltage Maximum Reverse Recovery Time 150ns FR2AL-GL IF=0.5A, IR=1.0A, Trr 250ns Irr=0.25A FR2JL 500ns FR2KL-ML Typical Junction CJ 40pF Measured at Capacitance 1.0MHz, VR=4.0V *Pulse test: Pulse width 300 µsec, Duty cycle 1% DIMENSIONS DIM A B C D E G H J INCHES MIN .075 .077 .002 ----.030 .200 .160 .130 MM MIN 1.91 1.96 .05 ----.76 5.08 4.06 3.30 MAX .095 .083 .008 .02 .060 .220 .187 .155 MAX 2.41 2.10 .20 .51 1.52 5.59 4.75 3.94 NOTE SUGGESTED SOLDER PAD LAYOUT 0.090" 0.085” 0.070” www.mccsemi.com Revision: 5 1 of 4 2006/05/19 MCC FR2AL thru FR2ML Figure 1 Typical Forward Characteristics TM Micro Commercial Components 20 Figure 2 Forward Derating Curve 10 3.0 6 4 2.5 2 25°C Amps 2.0 1 .6 1.5 Amps .4 1.0 .2 .5 .1 Single Phase, Half Wave 60Hz Resistive or Inductive Load .06 0 .04 0 50 75 100 125 150 175 °C .02 .01 .4 .6 .8 1.0 1.2 Average Forward Rectified Current - Amperesversus Ambient Temperature - °C 1.4 Volts Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 60 40 20 pF TJ=25°C 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 Junction Capacitance - pFversus Reverse Voltage - Volts Revision: 5 www.mccsemi.com 2 of 4 2006/05/19 MCC FR2AL thru FR2ML TM Micro Commercial Components Figure 4 Maximum Non-Repetitive Forward Surge Current 90 75 60 45 Amps 30 15 0 1 2 4 6 8 10 20 40 60 80 100 Cycles Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 Pulse Generator Note 2 25Vdc 1Ω Oscilloscope Note 1 -1.0 1cm Set Time Base for 20/100ns/cm Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Revision: 5 -0.25 www.mccsemi.com 3 of 4 2006/05/19 MCC TM Micro Commercial Components ***IMPORTANT NOTICE*** Micro Commercial Components Corp . reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are represented on our website, harmless against all damages. ***APPLICATIONS DISCLAIMER*** Products offer by Micro Commercial Components Corp . are not intended for use in Medical, Aerospace or Military Applications. www.mccsemi.com Revision: 5 4 of 4 2006/05/19