CopperWing12 ADSL Central Office (CO) Chipset: STLC61256/55 + STLC60454 + STLC60243 DATA BRIEF 1 GENERAL DESCRIPTION The CopperWing12 ADSL Chipset family targets a complete set of solution for Central Office (CO) ADSL technology integrating also processing and management capability to provide the best solution for ATM/IP DSLAM, ATM/IP mini DSLAM and "Pizza" boxes. The chipset integrates all ADSL/ ADSL2+ functions from ATM/IP interfaces to the line in three devices: ■ Two data pump chip options: – STLC61255: 12 channels ATM ADSL Data Pump – STLC61256: 12 Channels ATM/IP ADSL data Pump with embedded Cell Processor ■ STLC60454: 4 Ch ADSL/ADSL2+ AFE with integrated receiver and LP filters ■ STLC60243: Dual channel Line Driver CopperWing12 chipset family provides Ethernet and ATM interfaces to fit IP and ATM based Remote Unit or CO line cards; it provides also a general purpose controller to allow the development of controller-less line cards. The Modem Control Software runs entirely on the DMT Transceiver (no external memory needed for Interleave memory nor modem SW): the line card host controller is in charge only of high-level management operation. The chipset is able to support not only the current ADSL standards, but also ADSL2 and ADSL+ (12 channels). With only 1 square inches and less than 1 Watt per channel (in ADSL mode, 1.15W/line in ADSL+ mode), the Copperwing12 chipset is one of the most competitive solutions for CO ADSL application. The chip set supports also ADSL+ mode to deliver higher bit rate (24Mb/s) on short loops while with Reach Extended ADSL is able to guarantee high reach performance. Figure 1. Chipset Architecture Overview Host CPU Flash ROM SDRAM STLC60454 STLC60243 Dual Line Driver Quad AFE ATM/ Utopia POS In-Band STM/ Serial STLC61256 Twelve ADSL STLC60454 Transceiver Quad AFE RMII/ with SMII/ PerFlow STLC60454 ATM Quad AFE STLC60243 Dual Line Driver Serial Host interface June 2004 This is preliminary information on a new product foreseen to be developed. Details are subject to change without notice. REV. 1 1/8 CopperWing12 2 ADSL SUPPORTED STANDARDS ■ T1.413 Issue 2 ■ ETSI RTS/TM 06006 - ADSL over ISDN ■ ITU G.992.1 - G.dmt, Annexes A, B, C, I – Amendment to G.992.1 Annex C ■ ITU G.994.1 - G.hs rev 2. ■ ITU G.992.2 - G.lite, Annexes A, B, C. ■ G.992.3 - G.dmt.bis, Annex A, B, C, I, J, L, M ■ G.992.4 - G.lite.bis ■ G.992.5 - G.adslplus, Annex A, B, C, I, J, M ■ RE-ADSL ■ Metallic loop testing 3 ■ PERFLOW ATM/IP CELL PROCESSOR FEATURES Network processing functionality on the line card – First stage switching ■ Cell and Packet processing – -AAL5 and AAL2 SAR functions on chip – ATM line card switch – Serial ATM – PTM-TC (Packet Over HDLC) – Traffic Management and Policing ■ Configurable backplane interfaces – Utopia Level 2&3, PoS, RMII, SMII, Serial ATM, STM 2/8 STLC61255 12 CHANNEL DMT ADSL DATA PUMP DATA BRIEF 4 ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ 5 MAIN FEATURES Support for 12 independent ports. Low power consumption Category II Functionality: Trellis coding and Echo cancellation Flexible bin assignment: Supports ADSL over POTS, ADSL over ISDN, all digital loop and overlapping spectra. TC layer supporting: ATM TC No external memory needed for Interleave memory nor modem SW No real time requirements from the controller Each modem can be different phase (startup/ Showtime) independently of other modems Package: PBGA676 27x27mm 0.13um CMOS technology 1.2V core logic supply (3.3V for I/O) -40ºC to +85ºC operation DESCRIPTION The STLC61255 twelve channels ADSL Transceiver is the key component for Asymmetrical Digital Subscriber Line (ADSL) Central Office modem implementation. The highly integrated device supports category II ADSL functionalities, including trellis coding and echo cancellation. The device embodies 6 independent dual transceivers optimized for Central Office operation, with bit rates of up to 3.0 Mbps up- Figure 1. Package PBGA676 (27 x 27mm) Table 1. Order Codes Part Number Package STLC61255 PBGA676 stream and 24 Mbps downstream. This device is ideal for power and area sensitive Central Office equipment, providing highest performance and density while meeting all telecom grade equipment requirements. The STLC61255 is designed for minimal host controller intervention during runtime operation. Combining this feature with additional management interfaces such as the serial host interface and the Inband Utopia management interface provides many alternatives for designs that significantly reduce operation complexity and cost. Cost saving can be achieved by using a singe low-cost controller to support high-density line-cards, saving the need for onboard flash memory or even the entire host processor environment. The STLC61255 host interface provides a full sup-port of the ADSL MIB, and a rich set of statistic information and programmable fault alarms. June 2004 This is preliminary information on a new product foreseen to be developed. Details are subject to change without notice. 3/8 STLC61256 12 CHANNEL DMT ADSL DATA PUMP WITH EMBEDDED IP/ATM CELL PROCESSOR DATA BRIEF 6 ■ ■ ■ ■ ■ ■ MAIN FEATURES Support for 12 independent ports. Low power consumption Category II Functionality: Trellis coding and Echo cancellation Flexible bin assignment: Supports ADSL over POTS, ADSL over ISDN, all digital loop and overlapping spectra. TC layer supporting: STM TC, ATM TC and PTM TC (as required by G.dmt.bis annex K) Includes PerFlow Cell Processor – AAL5/2 SAR – Policing and Scheduling 4 priorities – Supports ATM and IP simultaneously per port – Full switching capability ■ ■ ■ ■ ■ ■ ■ 7 No external memory needed for Interleave memory nor modem SW (for advanced PerFlow applications external SDRAM needed) No real time requirements from the controller Each modem can be different phase (startup/ Showtime) independently of other modems Package: PBGA676 27x27mm 0.13um CMOS technology 1.2V core logic supply (3.3V for I/O) -40ºC to +85ºC operation DESCRIPTION The STLC61256 twelve channels ADSL Transceiver is an advanced component for ADSL Central Office modem implementation. The embedded IP/ATM Cell Processor allows to simplify the design of high density CO line cards and to develop a single platform that supports IP or ATM based equipments. It allows also different line card architecture with the possibility to have also chaining of several STLC61256 devices on Figure 1. Package PBGA676 (27 x 27mm) Table 1. Order Codes Part Number Package STLC61256 PBGA676 the same card. External DRAM is required only for full PerFlow feature support (layer 2 addressing like MAC or VPI/VCI level, Hash support, high number of voice+data connections per channel). The highly integrated device supports category II ADSL functionalities, including trellis coding and echo cancellation. The device embodies 6 independent dual transceivers optimized for Central Office operation, with bit rates of up to 3.0 Mbps upstream and 24 Mbps downstream. This device is ideal for power and area sensitive Central Office equipment, providing highest performance and density while meeting all telecom grade equipment requirements. The STLC61256 is designed for minimal host controller intervention during runtime operation. Combining this feature with additional management interfaces such as the serial host interface and the In-band Utopia management interface provides many alternatives for designs that significantly reduce operation complexity and cost. Cost saving can be achieved by using a singe low-cost controller to support high-density line-cards, saving the need for on-board flash memory or even the entire host processor environment. The STLC61256 host interface provides a full sup-port of the ADSL MIB, and a rich set of statistic information and programmable fault alarms. June 2004 This is preliminary information on a new product foreseen to be developed. Details are subject to change without notice. 4/8 STLC60454 4 CHANNEL ADSL/ADSL+ AFE DATA BRIEF 8 ■ MAIN FEATURES Figure 1. Package Tx Path – Low pass filter – Programmable Gain Amplifier ■ Rx Path – Programmable filters – Internal Low Noise Amplifier ■ ■ ■ ■ ■ ■ ■ ■ ITU-T and ANSI Tone Detection per channel Per channel Power Down Function Fully Programmable through the Data Pump Interface (STLC61255/6) 144-pin LBGA package (13x13mm) Power consumption 0.8W (200mW/line) 0.35 um technology Single 3.3V supply Extended temperature range LBGA144 (13 x 13mm) Table 1. Order Codes 9 Part Number Package STLC60454 LBGA144 DESCRIPTION The STLC60454 is a 4 channel ADSL AFE. It implements four analog transceiver functions required for a central office modem. It connects the digital modem chip with the line driver and hybrid balance circuit. This 4 channel AFE has been designed with high dynamic range in order to greatly reduce the external filter requirements. Each single channel can be put in power down mode and provides programmable filters in the receive path. No external receiver is required. June 2004 This is preliminary information on a new product foreseen to be developed. Details are subject to change without notice. 5/8 STLC60243 DUAL CHANNEL ADSL LINE DRIVER DATA BRIEF 10 MAIN FEATURES ■ ■ ■ ■ ■ ■ ■ ■ Low Noise: 3.5nV/Hz Class AB architecture High Peak Output Current: 600 mA Low Single Tone Distortion: -60dBc Thermal And Overload Protection BCD-SOI technology HTSSOP28 Package -40 TO +85°C Operating Rang 11 DESCRIPTION The STLC60243 is a dual channel ADSL Line Driver featuring a high slew rate and a large bandwidth optimized for XDSL applications (ADSL and ADSL+). The device is available in a HTSSOP 28 Figure 1. Package HTSSOP28 Table 1. Order Codes Part Number Package STLC60243 HTSSOP28 pin package (4x9 mm) with an exposed lead frame. The STLC60243 is designed optimizing bandwidth, distortion performances and power consumption. June 2004 This is preliminary information on a new product foreseen to be developed. Details are subject to change without notice. 6/8 CopperWing12 Table 1. Revision History Date Revision June 2004 1 Description of Changes First Issue 7/8 CopperWing12 Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics. The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners © 2004 STMicroelectronics - All rights reserved STMicroelectronics GROUP OF COMPANIES Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States www.st.com 8/8