STMICROELECTRONICS TDA8160

TDA8160
INFRARED REMOTE CONTROL RECEIVER
..
..
.
..
LOW SUPPLY VOLTAGE (VS = 5V)
LOW CURRENT CONSUMPTION (IS = 6mA)
INTERNAL 5.5 V SHUNT REGULATOR
PHOTODIODE DIRECTLY COUPLED WITH
THE I.C.
INPUT STAGE WITH GOOD REJECTION AT
LOW FREQUENCY
LARGE INPUT DYNAMIC RANGE
FEW EXTERNAL COMPONENTS
DIP8
(Plastic Package)
ORDER CODE : TDA 8160
PIN CONNECTIONS
OUTPUT
1
8
OPEN
SUPPLY
VOLTAGE
D1 DC BIAS
2
7
PEAK
DETECTOR
DECOUPLING
3
6
GROUND
4
5
INPUT
8160-01.EPS
DESCRIPTION
The TDA8160 is a monolithic integrated circuit
in-lead minidip plastic package specially designed
to amplify the infrared signals in remote controlled
TV, Radio or VCR sets. It can be used in flash
transmission mode in conjunction with dedicated
remote control circuits (for example : M491-494).
8160-02.EPS
BLOCK DIAGRAM
August 1992
1/4
TDA8160
Parameter
Supply Voltage
Storage and Junction Temperature
Total Power Dissipation at Tamb = 70 °C
Value
16
– 40, +150
400
Unit
V
°C
mW
Value
200
Unit
°C/W
THERMAL DATA
Symbol
R th (j-a)
Parameter
Thermal Resistance Junction-ambient
Max
8160-02.TBL
Symbol
Vs
Tstg–j
Ptot
8160-01.TBL
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS
(Refer to the test circuit ; VS = 5V, fO = 10kHz, Tamb = 25oC, unless otherwise specified)
IIN
R IN
LfR
N
Parameter
Supply Voltage
Supply Current (Pin 3)
Stabilized Voltage at Pin 3
Voltage Gain (1st stage)
Transconductance (2nd stage)
Input Voltage Sensitivity (Pin 5)
Input Current Sensitivity (Pin 5)
Input Impedance
Low Frequency Rejection at the Input
Stage
Noise Signal at Pin 7
Test Conditions
Applied between Pins 3 and 6
I3 = 8mA
For Full Swing at the Output Pin 1
Rgen = 600Ω
For Full Swing at the Output Pin 1
Min.
4
Typ.
5
6
5.5
28
15
2
Max.
5.25
C1 = 100pF , f = 100HZ
30
nAP
kΩ
dB
C4 Missing
200
mVPP
CIRCUIT DESCRIPTION (see the block diagram)
The infrared light received from D1 generates an
AC signal that comes in to the device at pin 5. The
capacitor C1 and the integrated 10kΩ resistor
(pin 4) filter out the low frequency noise.
10
200
Unit
V
mA
V
dB
mA/V
mVP
8160-03.TBL
Symbol
VS
IS
V3
GV 1st
gm 2nd
VIN
The first stage shows a voltage gain of about 28dB ;
the second stage is a voltage to current converter
of 50mA/V (R2 = Zero). A sensitive peak detector
detects the amplifier signal ; one open collector
output (pin 1) gives out the recovered pulses.
8160-03.EPS
TEST CIRCUIT
2/4
TDA8160
Recommended Application Circuit for the Drive of the IC M491 by Means of a Flash Mode IR.
Transmitter only, in a TV 16 Station Memory Remote Control Subsystem.
The Above Shown IR Receiver Application must be Housed Inside a Metal Can Shield.
8160-04.TIF
Figure 1 :
3/4
TDA8160
PACKAGE MECHANICAL DATA
8 PINS - PLASTIC DIP
B
b
I
b1
B1
E
e
e3
Z
L
a1
A
e4
Z
D
5
1
4
A
a1
B
b
b1
D
E
e
e3
e4
F
i
L
Z
Min.
Millimeters
Typ.
3.32
0.51
1.15
0.356
0.204
Max.
1.65
0.55
0.304
10.92
9.75
7.95
Min.
0.020
0.045
0.014
0.008
Max.
0.065
0.022
0.012
0.430
0.384
0.313
2.54
7.62
7.62
3.18
Inches
Typ.
0.131
0.100
0.300
0.300
6.6
5.08
3.81
1.52
0.125
0260
0.200
0.150
0.060
Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no responsibility
for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result
from its use. No licence is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics.
Specifications mentioned in this publication are subject to change without noti ce. This publication supersedes and replaces all
information previously supplied. SGS-THOMSON Microelectronics products are not authorized for use as critical components in life
support devices or systems without express written approval of SGS-THOMSON Microelectronics.
 1994 SGS-THOMSON Microelectronics - All Rights Reserved
Purchase of I2C Components of SGS-THOMSON Microelectronics, conveys a license under the Philips
I2C Patent. Rights to use these components in a I2C system, is granted provided that the system confo rms to
the I2C Standard Specifications as defined by Philips.
SGS-THOMSON Microelectronics GROUP OF COMPANIES
Australia - Brazil - China - France - Germany - Hong Kong - Italy - Japan - Korea - Malaysia - Malta - Morocco
The Netherlands - Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A.
4/4
DIP8.TBL
Dimensions
PM-DIP8.EPS
F
8