TS9013 500mA CMOS Low Dropout Voltage Regulator Pin assignment SOT-89 1. Gnd 2. Input 3. Output SOT-223 1. Input 2. Gnd 3. Output Low Power Consumption 2uA(typ) Low Drop Out Voltage 0.6V General Description The TS9013 series is a positive voltage regulator developed utilizing CMOS technology featured very low power consumption, low dropout voltage and high output voltage accuracy. Built in low on-resistor provides low dropout voltage and large output current. A 1uF or greater can be used as an output capacitor. The TS9013 series are prevented device failure under the worst operation condition with both thermal shutdown and current fold-back. These series are recommended for configuring portable devices and large current application, respectively. This series are offered in 3-pin SOT-89 and SOT-223 package. Ordering Information Features Dropout voltage typically 0.4V @Io=500mA (Vo=5V) Output current up to 500mA Low power consumption, 2uA(typ) @Vo=5V Output voltage +/-2% Internal current limit Thermal shutdown protection Part No. TS9013xCW Palmtops Video recorders Battery powered equipment PC peripherals CD-ROM, DVD ROM Digital signal camera Block Diagram TS9013 series -20 ~ +85 oC Package SOT-223 TS9013xCY SOT-89 Note: Where x denotes voltage option, available are A=1.5V, D=1.8V, K=2.5V, S=3.3V, 5=5.0V. Contact factory for additional voltage options. Applications Operating Temp. (Ambient) Typical Application Circuit 1-3 2004/09 rev. E Absolute Maximum Rating Input Supply Voltage Input Operating Voltage Vin(max.) +12 Vin(opr. Typ.) +10 Io PD / (Vin – Vo) Output Current SOT-89 Power Dissipation (without heat sink) SOT-89 Thermal Resistance SOT-89 Thermal Resistance 180 Operating Junction Temperature Range 18 15 Tj Storage Temperature Range o C/W o C/W 160 RӨjc SOT-223 W 0.625 RӨja SOT-223 V 0. 55 PD SOT-223 V TSTG -40 ~ +125 o C -65 ~ +150 o C o Lead Soldering Temperature (260 C) 10 S Caution: Stress above the listed absolute rating may cause permanent damage to the device. Electrical Characteristics Ta = 25 oC unless otherwise specified. Parameter Output Voltage Maximum Output Current Input Stability Load Regulation (Note1) Conditions Vin=Vo + 1V, Io =10mA, Min Typ Max TS90135 4.900 5.0 5.100 TS9013S 3.234 3.3 3.366 TS9013K 2.450 2.5 2.550 TS9013D 1.764 1.8 1.836 TS9013A 1.47 1.5 1.575 500 -- -- mA -- 0.2 0.3 % -- 40 80 -- 40 90 Vin=Vo+1V, Vo+1V ≤ Vin ≤ Vo+2V, Io=1mA Vin=Vo+1V, TS90135 1mA≤IL≤500mA TS9013S 1mA≤IL≤400mA Io=500mA Dropout Voltage (Note 2) Io=400mA TS9013D V mV TS9013K Vin=Vo+1V, Unit TS9013A TS90135 -- 600 750 TS9013S -- 600 750 TS9013K -- 600 850 TS9013D -- 600 850 TS9013A mV -- 850 1100 Quiescent Current Vin=Vo+1V, Io=0A -- 2 5 uA Output Current Limit Vout < 0.4V -- 550 -- mA Power Supply Rejection Ratio At f=100KHz, Io=10mA, -- 30 -- dB Output Voltage Temperature -100 -ppm/ oC Coefficient (Note 3) Note: 1. Regulation is measured at constant junction temperature, using pulsed ON time. 2. Dropout is measured at constant junction temperature, using pulsed ON time, and the criterion is Vout inside target value +/-2%. 3. Guaranteed by design. TS9013 series 2-3 2004/09 rev. E SOT-89 Mechanical Drawing A I B G E G H 0.89 4.05 1.20 4.25 0.035 0.159 0.047 0.167 I J 1.4 0.35 1.6 0.44 0.055 0.014 0.068 0.017 DIM C H A B C D E F SOT-89 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX 4.40 4.60 0.173 0.181 1.50 1.7 0.059 0.070 2.30 2.60 0.090 0.102 0.40 0.52 0.016 0.020 1.50 1.50 0.059 0.059 3.00 3.00 0.118 0.118 D J F SOT-223 Mechanical Drawing A B DIM I C H J K D F G E TS9013 series 3-3 A B C D E F G H I J K SOT-223 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX 6.350 2.900 3.450 0.595 4.550 2.250 0.835 6.700 0.250 10° 1.550 6.850 3.100 3.750 0.635 4.650 2.350 1.035 7.300 0.355 16° 1.800 0.250 0.114 0.136 0.023 0.179 0.088 0.032 0.263 0.010 10° 0.061 2004/09 rev. E 0.270 0.122 0.148 0.025 0.183 0.093 0.041 0.287 0.014 16° 0.071