UTC MC4580 LINEAR INTEGRATED CIRCUIT DUAL OPERATIONAL AMPLIFIER DESCRIPTION The UTC MC4580 is the dual operational amplifier, specially designed for improving the tone control, which is most suitable for the audio application. Featuring noiseless, higher gain bandwidth, high output current and low distortion ratio, and it is most suitable not only for acoustic electronic parts of audio pre-amp and active filter, but also for the industrial measurement tools. It is also suitable for the head phone amp at higher output current, and further more, it can be applied for the handy type set operational amplifier of general purpose in application of low voltage single supply type which is properly biased of the input low voltage source. SOP-8 DIP-8 TSSOP-8 FEATURES *Operating Voltage *Low Input Noise Voltage *Wide Gain Bandwidth Product *Low Distortion *Slew Rate *Bipolar Technology (±2V to±18V) (0.8μVrms typ.) (15MHz typ.) (0.0005% typ.) (5V/µs typ.) PIN CONFIGURATION UTC OUT1 1 8 Vcc+ IN1(-) 2 7 OUT2 IN1(+) 3 6 IN2(-) Vcc- 4 5 IN2(+) UNISONIC TECHNOLOGIES CO., LTD. 1 QW-R105-013,B UTC MC4580 LINEAR INTEGRATED CIRCUIT TEST CIRCUIT Vcc+ IN(-) OUTPUT IN(+) Vcc- ABSOLUTE MAXIMUM RATINGS (Ta=25°C) PARAMETER SYMBOL Supply Voltage Input Voltage Differential Input Voltage Output Current Power Dissipation V+/VVIC VID Io PD Operating Temperature Range Storage Temperature Range Topr Tstg UTC RATINGS ±18 ±15 ±30 ±50 300 (SOP-8) 800 (DIP-8) 250(TSSOP-8) -40 to+85 -40 to +125 UNIT V V V mA mW °C °C UNISONIC TECHNOLOGIES CO., LTD. 2 QW-R105-013,B UTC MC4580 LINEAR INTEGRATED CIRCUIT ELECTRICAL CHARACTERISTICS (V+ /V-=±15V, Ta=25°C ) PARAMETER SYMBOL Input Offset Voltage Input Offset Current Input Bias Current Large Signal Voltage Gain Output Voltage Swing VIO IIO IB AV VoM Input Common Mode Voltage Range Common Mode Rejection Ratio Supply Voltage Rejection Ratio Operating Current Slew Rate Gain bandwidth Product Total Harmonic Distortion Input Noise Voltage VICM CMR SVR Icc SR GB THD VNI TEST CONDITION RS≤10kΩ Vo=±10V, RL≥2kΩ RL＞=2kΩ RS≤10kΩ Rs≤10kΩ RL≥2kΩ f=10KHz Av=20dB,Vo=5V, RL=2kΩ, f=1KHz RIAA Rs=2.2 kΩ,30kHzLPF MIN TYP MAX UNIT 90 ±12 0.5 5 100 110 ±13.5 3 200 500 - mV nA nA dB V ±12 80 80 - ±13.5 110 110 6 5 15 0.0005 0.8 9 - V dB dB mA V/µs MHz % µVrms TYPICAL CHARACTERISTICS Maximum Output Voltage Swing vs. Load Resistance Maximum Output Voltage Swing vs. Frequency Output Voltage Swing vs. Output Current Equivalent Input Noise Voltage vs. Frequency UTC UNISONIC TECHNOLOGIES CO., LTD. 3 QW-R105-013,B UTC MC4580 LINEAR INTEGRATED CIRCUIT Operating Current vs. Temperature Output Voltage Swing vs. Temperature Input Offset Voltage vs. Temperature Input Bias Current vs. Temperature Maximum Output Voltage Swing vs. Operating Voltage Operating Current vs. Operating Voltage UTC UNISONIC TECHNOLOGIES CO., LTD. 4 QW-R105-013,B UTC MC4580 LINEAR INTEGRATED CIRCUIT Total Harmonic Distortion vs. Output Voltage Voltage Gain, Phase vs. Frequency UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UTC UNISONIC TECHNOLOGIES CO., LTD. 5 QW-R105-013,B