TH97/10561QM RGP15A - RGP15M IATF 0060636 SGS TH07/1033 FAST RECOVERY RECTIFIER DO-15 PRV : 50 - 1000 Volts Io : 1.5 Amperes FEATURES : * * * * * TW00/17276EM 1.00 (25.4) MIN. 0.140 (3.6) 0.104 (2.6) High reliability Low reverse current Low forward voltage drop Fast switching for high efficiency Pb / RoHS Free 0.300 (7.6) 0.230 (5.8) MECHANICAL DATA : 1.00 (25.4) MIN. 0.034 (0.86) 0.028 (0.71) * Case : DO-15 Molded plastic * Epoxy : UL94V-O rate flame retardant * Lead : Axial lead solderable per MIL-STD-202, Method 208 guaranteed * Polarity : Color band denotes cathode end * Mounting position : Any * Weight : 0.4 gram Dimensions in inches and ( millimeters ) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating at 25 °C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. SYMBOL RGP 15A RGP 15B RGP 15D RGP 15G RGP 15J RGP 15K RGP 15M UNIT Maximum Recurrent Peak Reverse Voltage VRRM 50 100 200 400 600 800 1000 V Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 V Maximum DC Blocking Voltage VDC 50 100 200 400 600 800 1000 V RATING Maximum Average Forward Current 0.375"(9.5mm) Lead Length Ta = 55 °C Peak Forward Surge Current, 8.3ms Single half sine wave Superimposed on rated load (JEDEC Method) Maximum Peak Forward Voltage at IF = 1.5 A Maximum DC Reverse Current Ta = 25 °C at Rated DC Blocking Voltage Ta = 150 °C IF(AV) 1.5 A IFSM 50 A VF 1.3 V IR 5.0 μA IR(H) 200 μA Maximum Reverse Recovery Time ( Note 1 ) Trr Typical Junction Capacitance ( Note 2 ) CJ 25 pF RӨJA 30 °C/W Junction Temperature Range TJ - 65 to + 175 °C Storage Temperature Range TSTG - 65 to + 175 °C Typical Thermal Resistance ( Note 3 ) 150 250 500 ns Notes : ( 1 ) Reverse Recovery Test Conditions : IF = 0.5 A, IR = 1.0 A, Irr = 0.25 A. ( 2 ) Measured at 1.0 MHz and applied reverse voltage of 4.0 VDC ( 3 ) Thermal Resistance from Junction to Ambient at 0.375" (9.5mm) Lead Lengths, P.C. Board Mounted. Page 1 of 2 Rev. 03 : June 9, 2008 TH97/10561QM TW00/17276EM IATF 0060636 SGS TH07/1033 RATING AND CHARACTERISTIC CURVES ( RGP15A - RGP15M ) FIG.1 - REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM 50 Ω Trr 10 Ω + 0.5 D.U.T. + 0 PULSE GENERATOR ( NOTE 2 ) 50 Vdc (approx.) 1Ω - 0.25 OSCILLOSCOPE ( NOTE 1 ) - 1.0 A SET TIME BASE FOR 50/100 ns/cm NOTES : 1. Rise Time = 7 ns max., Input Impedance = 1 megaohm, 22 pF. 1 cm 2. Rise time = 10 ns max., Source Impedance = 50 ohms. 3. All Resistors = Non-inductive Types. FIG.3 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT 50 1.5 PEAK FORWARD SURGE CURRENT, AMPERES AVERAGE FORWARD OUTPUT CURRENT, AMPERES FIG.2 - DERATING CURVE FOR OUTPUT RECTIFIED CURRENT 1.2 0.9 TJ = 25 °C 0.6 60Hz RESISTIVE OR INDUCTIVE LOAD 0.375" (9.5mm) LEAD LENGTHS 0.3 40 30 20 8.3 ms SINGLE HALF SINE-WAVE (JEDEC) METHOD 10 TJ = Tj max. 0 0 25 50 75 100 125 150 0 175 1 AMBIENT TEMPERATURE, ( °C) 4 6 20 40 60 100 FIG.5 - TYPICAL REVERSE CHARACTERISTICS 10 10 TJ = 100 °C REVERSE CURRENT , MICROAMPERES Pulse Width = 300 μs 2% Duty Cycle TJ = 25 °C 1.0 0.1 0.01 10 NUMBER OF CYCLES AT 60Hz FIG.4 - TYPICAL FORWARD CHARACTERISTICS FORWARD CURRENT, AMPERES 2 1.0 0.1 TJ = 25 °C 0.01 0 0.2 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0 0 20 40 60 80 100 120 140 FORWARD VOLTAGE, VOLTS PERCENT OF RATED REVERSE VOLTAGE, (%) Page 2 of 2 Rev. 03 : June 9, 2008