Document 734 Flyback Transformer For Linear Technology LT3751 Capacitor Charger Controller • Flyback transformer for the Linear Technology LT3751 Capacitor Charger Controller • 120 – 377 V input; up to 500 V output • 3000 Vrms isolation from primary to secondary windings Core material Ferrite Terminations RoHS tin-silver over tin over nickel over phos bronze. Other terminations available at additional cost. Weight 23.8 g Ambient temperature –40°C to +85°C Storage temperature Component: –40°C to +85°C. Packaging: –40°C to +80°C Resistance to soldering heat Max three 40 second reflows at +260°C, parts cooled to room temperature between cycles Moisture Sensitivity Level (MSL) 1 (unlimited floor life at <30°C / 85% relative humidity) Failures in Time (FIT) / Mean Time Between Failures (MTBF) 38 per billion hours / 26,315,789 hours, calculated per Telcordia SR-332 Packaging 24 per tray PCB washing Only pure water or alcohol recommended Part number HA4060-AL 1. 2. 3. 4. Inductance at 0 A1 ±10% (µH) 300 DCR max (Ohms)3 pri sec 0.422 1.58 Inductance at Ipk2 min (µH) 270 Inductance is measured at 100 kHz, 0.1 Vrms. Peak primary current drawn at minimum input voltage. DCR is with the windings connected in parallel. Leakage inductance is for both windings of the primary with the secondary windings shorted. Dot indicates pin 1 0.108 2,75 1 12 HA4060-AL CCIxxxx 0.039 1,00 1.053 max 26,75 Leakage inductance4 max (µH) 2.7 Volt-time product typ (V µsec) 600 5. Turns ratios are with the primary and secondary windings connected in parallel. 6. Electrical specifications at 25°C. Refer to Doc 362 “Soldering Surface Mount Components” before soldering. 1.10 28,2 1 0.148 3,75 1 2 12 Recommended Land Pattern 8 7 Pri Sec 11 12 6 5 Primary windings and secondary windings to be connected in parallel on PC board. 0.079 2,00 0.148 3,75 Ipk2 (A) 2.0 Turns ratio5 pri : sec 1:3 0.551 max 14,0 1.024 26,0 1.350 max 34,29 0.004 / 0,10 Dimensions are in inches mm Specifications subject to change without notice. Please check our website for latest information. © Coilcraft, Inc. 2009 Document 734 Revised 02/0909