1733 Reader's Spreads pg1-203:document 1/27/09 4:03 PM Page 26 HV73 resistors flat chip resistors for high voltage EU features • Superior to RK73 series in maximum working voltage • Suitable for flow and reflow solderings • Marking: White three-digit on black protective coat 1J: no marking • Products with lead-free terminations meet EU RoHS requirements. Pb located in glass material, electrode and resistor element is exempt per Annex 1, exemption 5 of EU directive 2005/95/EC dimensions and construction L c Type c W Solder Plating Ni Plating t d Protective Coating L (Inch Size Code) Resistive Inner Film Electrode Ceramic Substrate Dimensions inches (mm) W c d t 1J (0603) .063±.008 .031±.004 .012±.004 .012±.004 .018±.004 (1.6±0.2) (0.8±0.1) (0.3±0.1) (0.3±0.1) (0.45±0.1) 2A (0805) .079±.008 .049±.004 .016±.008 (2.0±0.2) (1.25±0.1) (0.4±0.2) .012 2B (1206) .126±.008 .063±.008 (1.6±0.2) (3.2±0.2) .02±.012 (0.5±0.3) .016 2H (2010) .197±.008 .098±.008 (2.5±0.2) (5.0±0.2) .02±.012 (0.5±0.3) .016 3A (2512) .248±.008 .122±.008 (3.1±0.2) (6.3±0.2) .02±.012 (0.5±0.3) (0.3 (0.4 +.008 -.004 +0.2 ) -0.1 .02±.004 (0.5±0.1) +.008 -.004 +0.2 ) -0.1 .024±.004 (0.6±0.1) +.008 -.004 (0.4 +0.2 -0.1 ) .016 +.008 -.004 (0.4 +0.2 -0.1 ) .024±.004 (0.6±0.1) .024±.004 (0.6±0.1) ordering information New Part # HV73 2B Type Size 1J: 0.1W 2A: 0.125W 2B: 0.25W 2H: 0.5W 3A: 1W T Termination Material T: Sn TD Packaging TD: 0603, 0805, 1206: 7" 2mm pitch punched paper TDD: 0603, 0805, 1206: 10" paper tape TE: 2010 & 2512: 7" punched plastic TED: 2010 & 2512: 10" punched plastic For further information on packaging, please refer to Appendix A 1004 F Nominal Resistance ±0.5%, ±1%: 3 significant figures + 1 multiplier ±2%, ±5%: 2 significant figures + 1 multiplier Resistance Tolerance D: ±0.5% F: ±1% G: ±2% J: ±5% Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. 28 12/16/08 KOA Speer Electronics, Inc. • 199 Bolivar Drive • Bradford, PA 16701 • USA • 814-362-5536 • Fax: 814-362-8883 • www.koaspeer.com 1733 Reader's Spreads pg1-203:document 1/27/09 4:03 PM Page 27 PMS 300 neg. Black neg. flat chip resistors for high voltage applications and ratings E-24 (D±0.5%) E-24 (F±1%) E-24 (G±2%) E-24 (J±5%) Absolute Maximum Working Voltage ±100** — 10k - 10M 10k - 10M 10k - 10M 350V 500V* ±100 100k - 1M 100k - 10M 100k - 10M 100k - 10M ±200 — — — 11M - 51M 400V 800V* ±100 100k - 1M 100k - 10M 100k - 10M ±200 — — — 100k - 10M 11M - 51M 500V 1000V* ±100 100k - 1M 100k - 10M 100k - 10M ±200 — — — 100k - 10M 11M - 51M 2000V(*D.C.) 3000V* ±100 43k - 1M 43k - 10M 43k - 10M ±200 — 11M - 20M 11M - 20M 43k - 10M 11M - 51M 3000V(*D.C.) 4000V* Part Designation Power Rating @ 70°C T.C.R. (ppm/°C) Max. 1J 0.1W 2A 0.125W 2B 0.25W 2H 0.5W 3A 1W Resistance Range Maximum Overload Voltage (D.C.)* Operating Temperature Range -55°C to +155°C * AC Voltage Reference: When using for A.C. Voltage, use the peek A.C. Voltage, which should not exceed the Maximum DC Overload Voltage (Max. DC Voltage/ √2) ** Cold T.C.R. of 1.1MΩ ~ 10MΩ is +200x10-6/K environmental applications Derating Curve 100 % Rated Power 80 60 40 20 0 -60 -40 -20 -55 0 20 40 60 80 100 120 140 160 70 155 Ambient Temperature (°C) Performance Characteristics Parameter Resistance T.C.R. Overload (Short time) Resistance to Solder Heat Rapid Change of Temperature Moisture Resistance Endurance at 70°C High Temperature Exposure Requirement ∆ R Limit Typical Within regulated — tolerance Within specified — T.C.R. ±2% ±0.5% ±1% ±0.5% ±0.5%, ±1%* ±0.3%, ±0.5%** ±2% ±0.75% ±2% ±0.75% ±2% ±0.3% Test Method 25°C +25°C/-55°C and +25°C/+125°C Rated Voltage (D.C.) x 2.5 for 5 seconds 260°C ± 5°C, 10 seconds ± 1 second -55°C (30 minutes), +125°C (30 minutes), 100 cycles 40°C ± 2°C, 90%-95% RH, 1000 hours, 1.5 hr ON, 0.5 hr OFF cycle 70°C ± 2°C, 1000 hours, 1.5 hr ON, 0.5 hr OFF cycle +155°C, 1000 hours * ±0.5%: (100kΩ≤R≤10MΩ), ±1%: (11MΩ≤R≤51MΩ) ** ±0.3%: (100kΩ≤R≤10MΩ, ±0.5%: (11MΩ≤R≤51MΩ) Additional environmental applications can also be found at www.koaspeer.com Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. 11/07/08 KOA Speer Electronics, Inc. • 199 Bolivar Drive • Bradford, PA 16701 • USA • 814-362-5536 • Fax: 814-362-8883 • www.koaspeer.com 29 resistors HV73