MCC S3A THRU S3M omponents 21201 Itasca Street Chatsworth !"# $ % !"# Features • • • • • 3 Amp Silicon Rectifier 50 to 1000 Volts For Surface Mount Applications Extremely Low Thermal Resistance Easy Pick And Place High Temp Soldering: 250°C for 10 Seconds At Terminals\ High Current Capability Maximum Ratings • • • DO-214AB (SMCJ) Operating Temperature: -55°C to +150°C Storage Temperature: -55°C to +150°C Maximum Thermal Resistance; 10°C/W Junction To Lead MCC Part Number Device Marking S3A S3B S3D S3G S3J S3K S3M S3A S3B S3D S3G S3J S3K S3M Maximum Recurrent Peak Reverse Voltage 50V 100V 200V 400V 600V 800V 1000V Maximum RMS Voltage 35V 70V 140V 280V 420V 560V 700V H Maximum DC Blocking Voltage 50V 100V 200V 400V 600V 800V 1000V J A E C D B F G DIMENSIONS Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward IF(AV) 3.0A TJ = 120°C Current Peak Forward Surge IFSM 100A 8.3ms, half sine Current Maximum VF IFM = 3.0A; Instantaneous 1.20V Forward Voltage TJ = 25°C* Maximum DC IR Reverse Current At TJ = 25°C 10µA Rated DC Blocking 250µA TJ = 125°C Voltage Typical Junction CJ 60pF Measured at Capacitance 1.0MHz, VR=4.0V *Pulse test: Pulse width 200 µsec, Duty cycle 2% DIM A B C D E F G H J INCHES MIN .079 .108 .002 MAX .103 .128 .008 MM MIN 2.00 2.75 .051 MAX 2.62 3.25 .203 .030 .050 .76 1.27 .305 .260 .220 .320 .280 .245 7.75 6.60 5.59 8.13 7.11 6.22 NOTE SUGGESTED SOLDER PAD LAYOUT 0.190 0.125” 0.070” www.mccsemi.com Version: 3 2002/12/27 MCC S3A thru S3M Figure 1 Typical Forward Characteristics 100 Figure 2 Forward Derating Curve 60 3.0 40 2.5 20 10 2.0 6 1.5 4 Amps 2 1.0 25°C Amps 1 .5 .6 .4 0 Single Phase, Half Wave 60Hz Resistive or Inductive Load 40 60 80 100 120 140 160 .2 °C .1 Average Forward Rectified Current - Amperes versus Ambient Temperature - °C .06 .04 .02 .01 .5 .9 .7 1.1 1.3 1.7 1.5 Volts Instantaneous Forward Current - Amperes versus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 60 40 20 pF 10 TJ=25°C 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 Junction Capacitance - pF versus Reverse Voltage - Volts www.mccsemi.com Version: 3 2002/12/27 MCC S3A thru S3M Figure 4 Typical Reverse Characteristics 1000 600 400 Figure 5 Peak Forward Surge Current 150 200 125 100 100 60 75 40 Amps 50 20 25 TA=125°C µAmps 10 0 6 1 2 4 6 8 10 20 40 60 80 100 Cycles 4 Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles 2 1 .6 .4 TA=25°C .2 .1 20 40 60 80 100 12 0 140 Volts Instantaneous Reverse Leakage Current - MicroAmperes versus Percent Of Rated Peak Reverse Voltage - Volts www.mccsemi.com Version: 3 2002/12/27