EPCOS B1617

SAW Components
SAW RF low loss filter
Satellite BTS
Series/type:
Ordering code:
B1617
B39122B1617U810
Date:
Version:
December 15, 2006
2.1
 EPCOS AG 2006. Reproduction, publication and dissemination of this data sheet, enclosures
hereto and the information contained therein without EPCOS’ prior express consent is prohibited.
SAW Components
B1617
SAW RF low loss filter
1178.12 MHz
Data Sheet
Application
■
■
■
■
■
■
■
Low loss RF filter for satellite BTS
Usable passband 40.0 MHz
Low insertion attenuation
Low amplitude ripple
Low group delay ripple
Balanced to balanced operation
No matching network required for operation at 150 Ω
Features
0.6
1
1.5
1.5
3
7
5
side view
top view
3.0
Pin configuration
■
■
■
■
■
■
1
2
5
6
3,7
4,8
Input
Input
Output
Output
To be grounded
Case ground, to be grounded
Please read cautions and warnings and
important notes at the end of this document.
2
bottom view
1.8
1.1
Package size 3.0 x 3.0 x 1.1 mm3
Maximum height of 1.225mm
Package code QCC8D
RoHS compatible
Approximate weight 0.037 g
Package for Surface Mount Technology (SMT)
Ni, gold-plated terminals
Electrostatic Sensitive Device (ESD)
3.0
■
■
■
■
■
■
■
■
December 15, 2006
SAW Components
B1617
SAW RF low loss filter
1178.12 MHz
Data Sheet
Characteristics
Operating temperature range:
Terminating source impedance:
Terminating load impedance:
T = –40 ˚C to +85 ˚C
ZS = 150 Ω
ZL = 150 Ω
min.
Nominal frequency
fN
—
typ.
@ 25 ˚C
1178.12
max.
—
MHz
Maximum insertion attenuation
αmax
1158.12 ... 1198.12 MHz
—
3.5
Pass bandwidth
αrel < 1.5 dB
—
57.6
—
1.8
2.3
dB
—
17.0
25.0
ns
—
4.0
5.5
B1.5 dB
Amplitude ripple (p-p)
∆α
1158.12 ... 1198.12 MHz
Group delay ripple (p-p)
∆τ
1158.12 ... 1198.12 MHz
Deviation from linear phase (rms)
in any 30 MHz band
1158.12 ... 1198.12 MHz
Relative attenuation (relative to αmax)
α
50.00 ... 1096.06 MHz
1260.18 ... 2000.00 MHz
2000.00 ... 6000.00 MHz
46.0
44.0
15.0
50.0
49.0
—
4.5
—
—
—
—
dB
MHz
˚
dB
dB
dB
Maximum ratings
Operable temperature range T
–40/+85
˚C
Storage temperature range
DC voltage
Source power
–40/+85
0
0
˚C
V
dBm
Tstg
VDC
PS
Please read cautions and warnings and
important notes at the end of this document.
3
source impedance 150 Ω
December 15, 2006
SAW Components
B1617
SAW RF low loss filter
1178.12 MHz
Data Sheet
Transfer function
Transfer function (passband)
Please read cautions and warnings and
important notes at the end of this document.
4
December 15, 2006
SAW Components
B1617
SAW RF low loss filter
1178.12 MHz
Data Sheet
References
Type
B1617
Ordering code
B39122B1617U810
Marking and package
C61157-A7-A72
Packaging
F61074-V8168-Z000
Date codes
L_1126
S-parameters
B1617_NB.s4p
Soldering profile
S_6001
RoHS compatible
defined as compatible with the following documents:
"DIRECTIVE 2002/95/EC OF THE EUROPEAN PARLIAMENT
AND OF THE COUNCIL of 27 January 2003 on the restriction
of the use of certain hazardous substances in electrical and
electronic equipment. 2005/618/EC from April 18th, 2005,
amending Directive 2002/95/EC of the European Parliament
and of the Council for the purposes of establishing the maximum concentration values for certain hazardous substances in
electrical and electronic equipment."
For further information please contact your local EPCOS sales office or visit our webpage at
www.epcos.com .
Published by EPCOS AG
Surface Acoustic Wave Components Division
P.O. Box 80 17 09, 81617 Munich, GERMANY
 EPCOS AG 2006. This brochure replaces the previous edition.
For questions on technology, prices and delivery please contact the Sales Offices of EPCOS AG or
the international Representatives.
Due to technical requirements components may contain dangerous substances. For information on
the type in question please also contact one of our Sales Offices.
Please read cautions and warnings and
important notes at the end of this document.
5
December 15, 2006
Important notes
The following applies to all products named in this publication:
1.
2.
3.
4.
5.
6.
7.
Some parts of this publication contain statements about the suitability of our products for
certain areas of application. These statements are based on our knowledge of typical
requirements that are often placed on our products in the areas of application concerned. We
nevertheless expressly point out that such statements cannot be regarded as binding
statements about the suitability of our products for a particular customer application.
As a rule, EPCOS is either unfamiliar with individual customer applications or less familiar
with them than the customers themselves. For these reasons, it is always ultimately incumbent on the customer to check and decide whether an EPCOS product with the properties
described in the product specification is suitable for use in a particular customer application.
We also point out that in individual cases, a malfunction of passive electronic components or failure before the end of their usual service life cannot be completely ruled
out in the current state of the art, even if they are operated as specified. In customer
applications requiring a very high level of operational safety and especially in customer applications in which the malfunction or failure of a passive electronic component could endanger
human life or health (e.g. in accident prevention or life-saving systems), it must therefore be
ensured by means of suitable design of the customer application or other action taken by the
customer (e.g. installation of protective circuitry or redundancy) that no injury or damage is
sustained by third parties in the event of malfunction or failure of a passive electronic component.
The warnings, cautions and product-specific notes must be observed.
In order to satisfy certain technical requirements, some of the products described in this
publication may contain substances subject to restrictions in certain jurisdictions (e.g.
because they are classed as “hazardous”). Useful information on this will be found in our
Material Data Sheets on the Internet (www.epcos.com/material). Should you have any more
detailed questions, please contact our sales offices.
We constantly strive to improve our products. Consequently, the products described in this
publication may change from time to time. The same is true of the corresponding product
specifications. Please check therefore to what extent product descriptions and specifications
contained in this publication are still applicable before or when you place an order.
We also reserve the right to discontinue production and delivery of products. Consequently, we cannot guarantee that all products named in this publication will always be available.
Unless otherwise agreed in individual contracts, all orders are subject to the current version of the “General Terms of Delivery for Products and Services in the Electrical
Industry” published by the German Electrical and Electronics Industry Association
(ZVEI).
The trade names EPCOS, CeraDiode, CSSP, PhaseCap, PhaseMod, SIFI, SIKOREL, SilverCap, SIMID, SIOV, SIP5D, SIP5K, TOPcap, UltraCap, WindCap are trademarks registered
or pending in Europe and in other countries. Further information will be found on the Internet
at www.epcos.com/trademarks.
6
December 15, 2006