Capacitors for Power Factor Correction Series/Type: MKK-525-I-10-01 The following products presented in this data sheet are being withdrawn. Ordering Code B25667A5117A175 Substitute Product Date of Withdrawal 2004-07-30 Deadline Last Orders Last Shipments For further information please contact your nearest EPCOS sales office, which will also support you in selecting a suitable substitute. The addresses of our worldwide sales network are presented at www.epcos.com/sales. PhaseCap™ B25667-A5117-A175 MKK525-I-10-01 4RB5 100-5 AA 52 Characteristics CN UN fN QN IN tan δ 0 1x 116 AC 525 50 10 1x 19 µF ±5 % V Hz kvar A Marking 60 Hz 12 kvar 23 A 0,2 W/kvar (dielectric) Maximum ratings The information in our data book / sheet describes the type of component and shall not be considered as assured characteristics. Umax I r(40) Is (du/dt) max (du/dt) s AC 580 AC 680 1x 40 5800 20 50 V, 8 h daily V, 1 min A (ΘA = 40°C, U N ) A V/µs V/µs Toothed washer DIN 6797-J13 Hex nut DIN 439-BM12 Test data UTT UTC AC 1150 V, 10 s AC 3000 V, 10 s tanδ (50 Hz) ≤ 0,5 W/kvar (total) Rivet (Impregnating hole) C61014-A0505-A401 Dimensions in mm Climatic category -40/D Design data Θ min Θ max Humidity Dimensions Ø x l Approx. weight Impregnation 121,6 x 164 mm (4,79 x 6,46 in) 1,3 kg (2,9 lb) Gas Fixing Mounting hole Max. torque Threaded bolt M12 14 mm (0,55 in) 10 Nm Terminals Max. torque Terminal cross section Isolated terminal, IP20 1,2 Nm 16 mm² (5 AWG) Creepage distance Clearance 12,7 mm (0,50 in) 9,6 mm (0,38 in) Θ stg –40 °C +55 °C Max. relative Humidity ≤ 95 % –55 bis +70 °C Life expectancy t LD 100 000 h Overpressure disconnector Any mounting position possible Remarks Natural cooling IEC 60831-1/2, EN 60831-1/2, VDE 560-46/47 KO L E / Pe 01.12.1999 Contact: EPCOS AG KO PM L, P.O. Box 80 17 09, 81617 Munich, Germany, Fax: 0049 89 636-22748, Phone: 0049 89 636-23817