TS2023 1A Single Channel USB Power Switch SOT-25 Pin Definition: 1. CTL 2. Ground 3. FLG 4. Input 5. Output General Description The TS2023 is integrated 85mΩ high-side power switch for self-powered and bus-powered Universal Serial Bus (USB) applications. This switch operates with input ranging from 3.2V to 6.5V, making it ideal for 5V system. The protection includes current limiting with foldback, short circuit and thermal shutdown. The TS2023 is ideal for any system where current limiting and power control are desired. The TS2023 has low quiescent current and small package, which is particularly suitable in battery powered portable application. Guaranteed minimum output rise time limits inrush current during hot plug-in as well as minimizing EMI and prevents the voltage at upstream port from dropping excessively. Features ● 85mΩ High-Side MOSFET Switch ● 1A Continuous Load Current Ordering Information Part No. Package ● 40uA Quiescent Supply Current ● 1uA Maximum Shutdown Supply Current ● 3.2V to 6.5V Input Voltage Range Applications ● Open-Drain Over-Current Flag Output ● USB Power Management ● Under-Voltage Lockout ● High-Side Power Protection Switch ● Current-Limit / Short Circuit Protection ● Hot Plug-In Power Supplies ● Thermal Shutdown Protection under Over ● Battery-Charger Circuits Current Condition ● Portable Application Under Voltage Lockout Ensures that Switch is off ● Digital Television ● Packing TS2023CX5 RFG SOT-25 3Kpcs / 7” Reel Note: “G” denote for Halogen Free Product at Start Up ● Soft Start prevents large Inrush Current. ● No Reverse Current when Power off. ● Enable Active-Low Absolute Maximum Rating Parameter Symbol Limit Unit VIN Pin Voltage VIN 7 V CTL Input Voltage VCTL -0.3 ~ 7 V Operating Temperature Range TOP -40 to +85 °C Junction Temperature TJ +125 °C Power Dissipation PD 350 mW TSTG -65 to +150 °C θJC 115 °C/W Storage Temperature Range Thermal Resistance from Junction to case Thermal Resistance from Junction to ambient θJA 250 Note: Absolute maximum rating are those values beyond which the life of a device may be impaired 1/8 °C/W Version: A11 TS2023 1A Single Channel USB Power Switch Electrical Characteristics (VIN=5V, CIN=COUT=1uF, TA=25°C, unless otherwise noted) Characteristics Min Typ VIN 3.2 -- 6.5 V Supply Current IS -- 40 -- uA Shutdown Supply Current ISD -- 0.1 1 µA ILIMIT 1.1 1.5 2 A RDS(ON) -- 85 -- mΩ Input Voltage Current Limit Threshold Output MOSFET Resistance Symbol Conditions VIN=3.6V, VEN=0V Max Units Output Turn-On Rise Time TON RLOAD=10Ω each output -- 400 -- uS Output Turn-Off Fall Time TOFF RLOAD=10Ω each output -- 0.7 20 uS EN Input Threshold VEN low-to-high transition -- -- 1.2 High-to-low transition 0.4 -- -- EN=0, VOUT=0V -- 0.5 1 uA TJ Increasing -- 145 -- °C TJ Decreasing -- 125 -- °C -- 2.5 -- V IOUT =0m~150mA -- 200 -- mV VOUT=0V until FLG low 4 9 -- mS -- -- 0.4 V Output Leakage Current Over Temperature Shutdown Threshold Under Voltage Lockout ILEAKAGE OTP UVLO Under Voltage Lockout Hysteresis UVLOHYTERESIS Over Current Flag Response Delay FLGDELAY FLG Output Low Voltage VFLG-Low V FLG Off-State Current IFLG-OFF --1 uA Note: Specifications are production tested at TA=25. Specifications over the -40°C to 85°C operatin g temperature range are assured by design. Characterization and correlation with statistical quality controls (SQC). 2/8 Version: A11 TS2023 1A Single Channel USB Power Switch Typical Application Circuit Block Diagram Pin Function Description Pin NO. Pin Name Pin Description 1 CTL Switch enable 2 GND Chip power ground 3 FLG Fault status. A logic low on this pin indicates the switch is in current limit or has been shutdown by the thermal protection circuit 4 VIN Power supply input 5 VOUT MOSFET switch output 3/8 Version: A11 TS2023 1A Single Channel USB Power Switch Application Information Flag Output An error Flag is an open-drained output of an N-channel MOSFET. Flag output is pulled low to signal the following fault conditions: input under-voltage, output current limit, and thermal shutdown. The current limit flag response delay time is 9ms. Current Limit The current limit threshold is preset internally. It protects the output MOSFET switches from damage resulting from undesirable short circuit conditions or excess inrush current, which is often encountered during hot plug-in. The error flag signals when any current limit conditions occur. Thermal Shutdown When temperature of TS2023 exceeds 145ºC for any reasons, the thermal shutdown function turns MOSFET switch off and signals the error flag. A hysteresis of 20ºC prevents the MOSFETs from turning back on until the chip temperature drops below 125ºC. Enable Control Enable must be driven logic low for a clearly defined input. Floating the input may cause unpredictable operation Under-Voltage Lockout UVLO (under-voltage lockout) prevents the output MOSFET from turning on until input voltage exceeds 2.5V typically. After the switch turns on, if the input voltage drops below 2.3V typically, UVLO shuts off the output MOSFET. Supply Filtering A 1uF bypass capacitor from USB IN to GND, located near the device, is strongly recommended to control supply transients. Without a bypass capacitor, an output short may cause sufficient ringing on the input (from supply lead inductance) to damage internal control circuitry Transient Requirements USB supports dynamic attachment (hot plug-in) of peripherals. A current surge is caused by the input capacitance of downstream device. Ferrite beads are recommended in series with all power and ground connector pins. Ferrite beads reduce EMI and limit the inrush current during hot attachment by filtering high-frequency signals. Short Circuit Transient Bulk capacitance provides the short-term transient current needed during a hot-attachment event. A 22uF/10V ceramic capacitor mounted close to downstream connect each port should provide transient drop protection Printed Layout Circuit The power circuitry of USB printed circuit boards requires a customized layout to maximize thermal dissipation and to minimize voltage drop and EMI 4/8 Version: A11 TS2023 1A Single Channel USB Power Switch Electrical Characteristics Curve Figure 1. ON Resistance vs. Supply Voltage Figure 2. ON Resistance vs. Temperature Figure 3. ON-State Current vs. Supply Voltage Figure 4. ON-State Current vs. Temperature Figure 5. Current Limit vs. Supply Voltage Figure 6. Current Limit vs. Temperature 5/8 Version: A11 TS2023 1A Single Channel USB Power Switch Electrical Characteristics Curve Figure 7. Flag Delay Time vs. Supply Voltage Figure 8. Flag Delay Time vs. Temperature Figure 9. Enable Threshold vs. Supply Voltage Figure 10. UVLO Threshold vs. Temperature Figure 11. Rising Time vs. Supply Voltage 6/8 Version: A11 TS2023 1A Single Channel USB Power Switch SOT-25 Mechanical Drawing DIM A+A1 B C D E e H L Ө1 S1 7/8 SOT-25 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX. 0.09 1.25 0.0354 0.0492 0.30 0.50 0.0118 0.0197 0.09 0.25 0.0035 0.0098 2.70 3.10 0.1063 0.1220 1.40 1.80 0.0551 0.0709 1.90 BSC 0.0748 BSC 2.40 3.00 0.09449 0.1181 0.35 BSC 0.0138 BSC 0º 10º 0º 10º 0.95 BSC 0.0374 BSC Version: A11 TS2023 1A Single Channel USB Power Switch Notice Specifications of the products displayed herein are subject to change without notice. TSC or anyone on its behalf, assumes no responsibility or liability for any errors or inaccuracies. Information contained herein is intended to provide a product description only. No license, express or implied, to any intellectual property rights is granted by this document. Except as provided in TSC’s terms and conditions of sale for such products, TSC assumes no liability whatsoever, and disclaims any express or implied warranty, relating to sale and/or use of TSC products including liability or warranties relating to fitness for a particular purpose, merchantability, or infringement of any patent, copyright, or other intellectual property right. The products shown herein are not designed for use in medical, life-saving, or life-sustaining applications. Customers using or selling these products for use in such applications do so at their own risk and agree to fully indemnify TSC for any damages resulting from such improper use or sale. 8/8 Version: A11