AGERE R192

Preliminary Data Sheet, Rev. 4
June 2001
R192P OC-192/STM-64 Lightwave Receiver
with Improved Sensitivity (–18 dBm)
Features
■
High data rate capability, 10.7 Gbits/s
■
PIN photodetector
■
Featuring improved sensitivity for optimum performance in
noisy, amplified systems, the R192P Receiver is manufactured in a compact, 16-pin surface-mount package (above),
and is also available with a convenient mounting bracket
(below).
Fully operational through the 1.3 µm to 1.6 µm
wavelength range
■
Improved typical sensitivity of –18 dBm
■
Single-mode fiber pigtail with ST ®, SC, LC, or
FC/PC optical connector
■
Operating case temperature range:
0 °C to 70 °C
■
■
50 Ω differential data output, with offset control
Package options:
— Space-sensitive package without mounting
bracket (ideal for transponder and transceiver
applications)
— With mounting bracket
Applications
■
Line terminal equipment
■
High-speed networks up to 10.7 Gbits/s
■
SONET/SDH OC-192/STM-64 telecommunications applications
■
Extended-reach datacom and telecom applications
R192P OC-192/STM-64 Lightwave Receiver
with Improved Sensitivity (–18 dBm)
Preliminary Data Sheet, Rev. 4
June 2001
Description
Pin Information
Receiver Operation
Table 1. Pin Descriptions
The R192P 10.7 Gbits/s fiber-optic receiver consists of
a high-speed PIN photodetector and a wide-band linear preamp in a pigtailed, surface-mount metal package. It is designed for use in single-mode, high-speed
telecommunication applications at the SONET OC-192
and the ITU-T SDH STM-64 data rate of
9.95328 Gbits/s.
At 10.7 Gbits/s, the typical room temperature sensitivity
measured at a BER of 1 x 10 –10 is –17 dBm. The operating case temperature range for the receiver is 0 °C to
70 °C.
The receiver is manufactured in a compact, 16-pin surface-mount package with a single-mode optical fiber
pigtail. The fiber pigtail is internally beveled for low
return loss and is available with ST, SC, LC, or FC-PC
optical connectors.
The dc levels of the differential outputs can be adjusted
relative to each other for optimum sensitivity in noisy,
amplified systems. These outputs are centered around
a dc level of typically –0.45 V. The TIA requires only a
–5 V power supply for operation. The PIN photodiode
requires a nominal bias voltage of 5 V to 10 V at less
than 1 mA.
2
Pin Number
Name
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
PIN Bias
GND
VEE
NC
NC
NC
GND
DATAN
DATA
GND
NC
–OFF
+OFF
Feedback Input Threshold Control
GND
Thermistor
Agere Systems Inc.
Preliminary Data Sheet, Rev. 4
June 2001
R192P OC-192/STM-64 Lightwave Receiver
with Improved Sensitivity (–18 dBm)
Absolute Maximum Ratings
Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are absolute stress ratings only. Functional operation of the device is not implied at these or any other conditions in excess
of those given in the operations section of the data sheet. Exposure to absolute maximum ratings for extended
periods can adversely affect device reliability.
Parameter
Symbol
Min
Max
Unit
VEE
–4.7
–5.7
V
—
—
—
—
20
2
mA
mA
PMAX
—
8
dBm
Operating Case Temperature
TC
0
85
°C
Storage Temperature
TC
–40
100
°C
Lead Soldering Temperature
—
—
250
°C
Lead Soldering Time
—
—
10
s
Supply Voltages:
Negative Supply
Photodiode Supply Current:
Forward*
Reverse
Optical Input Power
* Device is normally reverse biased. Forward biasing the photodiode can compromise device performance and reliability.
Optical Characteristics
Table 2. Optical Characteristics (TA = 25 °C)
Parameter
Optical Wavelength
223 –
Sensitivity (10.7 Gbits/s,
1310 nm < λ < 1550 nm)
1 PRBS, 1 x
10–10
BER,
Maximum Optical Input Power (10.7 Gbits/s, 223 – 1 PRBS,
1 x 10–10 BER), VPIN = 5 V
Optical Return Loss
Responsivity of PIN, λ = 1.55 µm
Total Dark Current
Agere Systems Inc.
Symbol
Min
Typ
Max
Unit
λ
1.250
—
1.615
µm
PLOW
—
–18
–17
dBm
PHIGH
0
1
—
dBm
—
—
–30
–27
dB
RPIN
0.7
0.8
—
A/W
ID
—
0.3
—
nA
3
R192P OC-192/STM-64 Lightwave Receiver
with Improved Sensitivity (–18 dBm)
Preliminary Data Sheet, Rev. 4
June 2001
Electrical Characteristics
Table 3. Electrical Characteristics (TA = 25 °C)
Parameter
Symbol
Min
Typ
Max
Unit
dc Power Supply Voltages:
Negative Supply
PIN Bias
VEE
VPIN
–4.94
5
–5.2
9
–5.46
13
V
V
dc Power Supply Currents:
Negative Supply
PIN Bias
IEE
IPIN
—
—
80
—
110
2
mA
mA
Power Dissipation
PDISS
—
—
0.6
W
Transimpedance:*
IPH ≤ 500 µA
TZ
550
700
900
Ω
Note: The output voltage increases linearly up to
750 µAp-p of input current and is operational
up to 2.2 mAp-p of input current.
Conditions: single-ended, 50 Ω load, low frequency.
Average Equivalent Input Noise Spectral Density
(Bandwidth 100 KHz to 15 GHz)
—
—
14
—
pA/√Hz
Summed Equivalent Noise Power
—
—
1400
—
nArms
Low Frequency Cutoff
fL
—
25
—
kHz
Bandwidth
BW
8.5
10
—
GHz
Rolloff (F3 dB to F3 dB + 5 GHz)
—
—
–20
—
dB
Peaking
—
—
2
—
dB
Group Delay:
0.2 GHz—5 GHz
0.2 GHz—8 GHz
—
—
—
±15
±20
—
—
ps
ps
Output Return Loss:
0 GHz—6 GHz
0 GHz—8 GHz
S22
—
—
>10
>8
—
—
dB
dB
V PP
* Transimpedance, T Z = ------------------- , where I PH ( AVG ) = the average photodiode current.
I P H ( AVG )
4
Agere Systems Inc.
Preliminary Data Sheet, Rev. 4
June 2001
R192P OC-192/STM-64 Lightwave Receiver
with Improved Sensitivity (–18 dBm)
Outline Diagrams
Outline Drawing, Package Style A
Dimensions are in inches and (millimeters).
A
0.611
(15.51)
0.375
(9.53)
0.037
(0.95)
6
∅ 4 x 0.087(2.20)
1
0.050
(1.27)
1.017
(25.83)
1.174
(29.82)
7
0.500
(12.70)
10
0.042
(1.10)
0.260
(6.60)
DETAIL “B”
0.043
(1.10)
0.079
(2.00)
0.333
(8.45)
0.097
(2.46)
11
0.150
(3.80)
16
0.608
(15.45)
0.050
(1.27)
SECTION A–A
0.797
(20.25)
A
0.025
(0.64)
0.008
(0.20)
0.272
(6.90)
0.150
(3.80)
2.010 REF.
(51.05)
0.125
(3.18)
0.016
(0.40)
DETAIL B
1-1237(F)
Agere Systems Inc.
5
R192P OC-192/STM-64 Lightwave Receiver
with Improved Sensitivity (–18 dBm)
Preliminary Data Sheet, Rev. 4
June 2001
Outline Diagrams (continued)
Outline Drawing, Package Style N
Dimensions are in inches and (millimeters).
A
0.020
(0.51)
0.050
(1.27)
6
0.060
(1.52)
1
0.156
(3.95)
0.050
(1.27)
7
1.135
(28.84)
0.500
(12.70)
0.606
(15.38)
0.500
(12.70)
0.042
(1.10)
10
0.260
(6.60)
0.087
(2.22)
0.175
(4.44)
11
0.569
(14.45)
0.043
(1.10)
16
0.150
(3.80)
A
SECTION A-A
0.611
(15.51)
0.004
(0.100)
0.170
(4.32)
0.354
(9.00)
0.272
(6.90)
0.146
(3.70)
0.125
(3.18)
0.037
(0.95)
0.354
(9.00)
0.157
(4.00)
0.611
(15.51)
0.013
(0.32)
0.063
(1.59)
2 x 0.008
(0.20)
0.276
(7.00)
0.315
(8.00)
2 x 0.016
(0.40)
0.025
(0.64)
1-1236(F)
6
Agere Systems Inc.
Preliminary Data Sheet, Rev. 4
June 2001
R192P OC-192/STM-64 Lightwave Receiver
with Improved Sensitivity (–18 dBm)
Ordering Information
Table 4. Ordering Information1
Description
R192P-Type OC-192/STM-64
Lightwave Receiver
Product Code
Package Style
Connector
Comcode
R192PDAA
A
SC
108668815
R192PGAA
A
FC
108668849
R192PSAA
A
LC
108989435
R192PDAN
N
SC
108940412
R192PSAN
N
LC
108989443
1. For additional ordering information, please contact an Agere Systems account manager at Opto West, 1-800-362-3891 (for sales staff,
please press option 2).
Agere Systems Inc.
7
R192P OC-192/STM-64 Lightwave Receiver
with Improved Sensitivity (–18 dBm)
Preliminary Data Sheet, Rev. 4
June 2001
For additional information, contact your Agere Systems Account Manager or the following:
INTERNET:
http://www.agere.com
E-MAIL:
[email protected]
N. AMERICA: Agere Systems Inc., 555 Union Boulevard, Room 30L-15P-BA, Allentown, PA 18109-3286
1-800-372-2447, FAX 610-712-4106 (In CANADA: 1-800-553-2448, FAX 610-712-4106)
ASIA PACIFIC: Agere Systems Singapore Pte. Ltd., 77 Science Park Drive, #03-18 Cintech III, Singapore 118256
Tel. (65) 778 8833, FAX (65) 777 7495
CHINA:
Agere Systems (Shanghai) Co., Ltd., 33/F Jin Mao Tower, 88 Century Boulevard Pudong, Shanghai 200121 PRC
Tel. (86) 21 50471212, FAX (86) 21 50472266
JAPAN:
Agere Systems Japan Ltd., 7-18, Higashi-Gotanda 2-chome, Shinagawa-ku, Tokyo 141, Japan
Tel. (81) 3 5421 1600, FAX (81) 3 5421 1700
EUROPE:
Data Requests: DATALINE: Tel. (44) 7000 582 368, FAX (44) 1189 328 148
Technical Inquiries: OPTOELECTRONICS MARKETING: (44) 1344 865 900 (Ascot UK)
Agere Systems Inc. reserves the right to make changes to the product(s) or information contained herein without notice. No liability is assumed as a result of their use or application. ST is a
registered trademark of Agere Systems Inc.
Copyright © 2001 Agere Systems Inc.
All Rights Reserved
June 2001
DS01-064OPTO-4 (Replaces DS00-064OPTO-3)