ELANTEC EL6201CW

Low Power 430 MHz HFM Oscillator w/Disable
Features
General Description
• Small SOT-23 and MSOP-8
packages
• Frequency to 430MHz min.
• Amplitude to 25mAP-P min.
• Output tristate function (MSOP-8)
• Power-down function (MSOP-8)
• Single +3.5V to +5.0V supply
• Simple to use - only two external
resistors required
• Independent resistor setting for
frequency and amplitude.
The EL6201C is a solid state high performance laser modulation oscillator with external resistor adjustable frequency and amplitude. The
EL6201C is available in both the 8-pin MSOP and the 5-pin SOT23, to
enable device placement close to the laser for reduced EMI.
Applications
•
•
•
•
•
•
•
•
•
DVD players
DVD-ROM drives
DVD-RAM drives
CD-RW drives
MO drives
Optical pickup head assembly
Laser diode modulation
Local oscillator
Communications lasers
EL6201C - Product Brief
EL6201C - Product Brief
The oscillator frequency is set by connecting a single external resistor
from the RFREQ pin to ground. The oscillator current output amplitude is set by connecting a single external resistor from the RAMP pin
to ground. The oscillator in the MSOP package also contains a high
speed output disable function using the OE pin. The OE pin can be
driven by a high speed timing signal to control precise laser modulation during read/write operations. The output current is disabled when
a logical zero ‘L’ is driven to the CE pin. Supply current is reduced to
microamps when CE = LOW.
The EL6201C has internal supply bypass capacitors to reduce oscillation noise spread through supply connections.
Connection Diagram
1 VS
RFREQ 7
2 GND
RAMP 6
Ordering Information
3 IOUT
Part No
Temp. Range
Package
Outline #
EL6201CY
0°C to +75°C
8-Pin MSOP
MDP0043
EL6201CW
0°C to +75°C
5-Pin SOT23
MDP0038
5-Pin SOT23
1 CE
VS 8
2 GND
IOUT 7
3 RFREQ
GND 6
4 RAMP
OE 5
8-Pin MSOP
July 12, 2000
Note: All information contained in this data sheet has been carefully checked and is believed to be accurate as of the date of publication; however, this data sheet cannot be a “controlled document”. Current revisions, if any, to these
specifications are maintained at the factory and are available upon your request. We recommend checking the revision level before finalization of your design documentation.
© 2001 Elantec Semiconductor, Inc.
EL6201C - Product Brief
EL6201C - Product Brief
Low Power 430 MHz HFM Oscillator w/Disable
General Disclaimer
Specifications contained in this data sheet are in effect as of the publication date shown. Elantec, Inc. reserves the right to make changes in the circuitry or specifications contained herein at any time without notice. Elantec, Inc. assumes no responsibility for the use of any circuits described
herein and makes no representations that they are free from patent infringement.
WARNING - Life Support Policy
Elantec, Inc. products are not authorized for and should not be used
within Life Support Systems without the specific written consent of
Elantec, Inc. Life Support systems are equipment intended to support or sustain life and whose failure to perform when properly used
in accordance with instructions provided can be reasonably
expected to result in significant personal injury or death. Users contemplating application of Elantec, Inc. Products in Life Support
Systems are requested to contact Elantec, Inc. factory headquarters
to establish suitable terms & conditions for these applications. Elantec, Inc.’s warranty is limited to replacement of defective
components and does not cover injury to persons or property or
other consequential damages.
July 12, 2000
Elantec Semiconductor, Inc.
675 Trade Zone Blvd.
Milpitas, CA 95035
Telephone: (408) 945-1323
(888) ELANTEC
Fax:
(408) 945-9305
European Office: +44-118-977-6020
Japan Technical Center: +81-45-682-5820
2
Printed in U.S.A.