RS401L THRU RS407L SINGLE-PHASE SILICON BRIDGE Reverse Voltage - 50 to 1000 Volts Forward Current - 4.0 Amperes Features Ideal for printed circuit board Surge overload rating - 150 amperes peak Mounting Position: Any Lead: Silver-plated copper Plastic material has Underwriters Laboratory Flammability Classification 94V-0 D IM E N S IO N S D IM in c h e s mm M in . M ax. M in . M ax. A 0 .6 0 5 0 .8 2 5 1 5 .3 6 7 1 6 .3 8 3 B 0 .7 5 0 - 19 - C 0 .7 3 0 0 .7 7 0 1 8 .5 4 2 1 9 .5 5 8 D 0 .2 3 5 0 .2 6 5 5 .9 7 6 .7 3 E 0 .0 7 0 T y p . 1 .7 7 8 T y p . F 0 .1 9 0 0 .2 1 0 4 .8 3 5 .3 3 G 0 .0 4 8 0 .0 5 2 1 .2 2 1 .3 2 H J N o te 0 .1 5 6 x 4 5 o 0 .2 0 0 T y p . 5 .0 8 T y p . Maximum Ratings and Electrical Characteristics Ratings at 25 ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. Symbols RS 401L RS 402L RS 403L RS 404L RS 405L RS 406L RS 407L Units Maximum repetitive peak reverse voltage VRRM 50 100 200 400 600 800 1000 Volts Maximum RMS bridge input voltage VRMS 35 70 140 280 420 560 700 Volts Maximum DC blocking voltage VDC 50 100 200 400 600 800 1000 Volts Maximum average forward output current at TA=50 (Note 1) I(AV) 4.0 Amps Peak forward surge current, 8.3mS single half sine-wave superimposed on rated load IFSM 150.0 Amps Maximum forward Voltage drop per bridge element at 3.0A peak VF 1.0 Volt Maximum DC reverse current at rate DC blocking voltage IR 10.0 A Maximum DC reverse current at rated DC blocking voltage and TA=150 IR 1.0 mA TJ, TSTG -55 to +150 Operating and storage temperature range Note: (1) Mounting conditions, 0.5 lead length maximum 1 RATINGS AND CHARACTERISTIC CURVES 2