THROUGH HOLE CLOCK OSCILLATORS - TTL COMPATIBLE SERIES CO1 AND CO13 FEATURES STANDARD 8 AND 14 PIN DIP PACKAGE TOLERANCE AND STABILITY TO ± 25 PPM LOW COST AVAILABLE IN 3.3 VOLT SPECIFICATIONS SERIES CO1 PACKAGE FREQUENCY RANGE 8 PIN DIP 500.00 KHz TO 125.00 MHz 500.00 KHz TO 125.00 MHz CO1100 : ±100 ppm CO13100 : ±100 ppm CO1050 : ±50 ppm CO13050 : ±50 ppm FREQUENCY STABILITY† OPERATING TEMPERATURE RANGE CO1025 : ±25 ppm CO13025 : ±25 ppm 0° C TO +70° C STANDARD -40° C TO +85° C EXTENDED 0° C TO +70° C STANDARD -40° C TO +85° C EXTENDED -55° C TO +125° C -55° C TO +125° C STORAGE TEMPERATURE RANGE VOLTAGE†† INPUT CURRENT (MAX) +5 VDC ±0.5 VDC +5 VDC ±0.5 VDC 500.00 KHz TO 2.999 MHz: 30 mA 500.00 KHz TO 2.999 MHz: 30 mA 3.00 MHz TO 31.999 MHz: 50 mA 3.00 MHz TO 31.999 MHz: 50 mA 32.00 MHz TO 79.999 MHz: 70 mA 32.00 MHz TO 79.999 MHz: 70 mA 80.00 MHz TO 125.00 MHz: 80 mA 80.00 MHz TO 125.00 MHz: 80 mA 40 TO 60% NORMAL 45 TO 55% TIGHT 40 TO 60% NORMAL 45 TO 55% TIGHT UNDER 9 MHz : ±15 ns MAX UNDER 9 MHz : ±15 ns MAX 9 MHz TO 32 MHz : ±10 ns MAX 9 MHz TO 32 MHz : ±10 ns MAX SYMMETRY (AT 1.4 VDC LEVEL) RISE AND FALL TIME (0.4 - 2.4 VDC) OUTPUT CO13 14 PIN DIP 32 MHz TO 80 MHz : ±6 ns MAX 32 MHz TO 80 MHz : ±6 ns MAX 80 MHz TO 125 MHz : ±4 ns MAX 80 MHz TO 125 MHz : ±4 ns MAX LOGIC "0" LEVEL +0.5 V MAX, SINK TO 16 mA +0.5 V MAX, SINK TO 16 mA LOGIC "1" LEVEL +2.4 V MIN, SOURCE 0.4 mA +2.4 V MIN, SOURCE 0.4 mA 1 TO 10 TTL STANDARD 1 TO 10 TTL STANDARD LOAD††† 35 † FREQUENCY STABILITY INCLUSIVE OF ROOM TOLERANCE , FREQUENCY STABILITY OVER TEMPERATURE, 10% POWER SUPPLY VARIATION, AGING, SHOCK, AND VIBRATION †† +3.3 VOLT VERSION IS AVAILABLE. CONSULT RALTRON FOR SPECIFICATIONS ††† OUTPUT LOADS ALSO AVAILABLE AT 15 pF, 30 pF AND 50 pF. CONSULT RALTRON FOR SPECIFICATIONS ENVIRONMENTAL AND TECHNICAL CONDITIONS OUTPUT WAVEFORM ENVIRONMENTAL TEMPERATURE CYCLE MIL-STD 883, METHOD 1010, 10 CYCLES -20° C TO 85° C SHOCK MIL-STD-202, METHOD 213, TEST CONDITION C VIBRATION MIL-STD-202, METHOD 204, TEST CONDITION A RESISTANCE TO SOLDERING HEAT MIL-STD-202, METHOD 210, TEST CONDITION B HUMIDITY 85% RELATIVE HUMIDITY AT 85° C 250 HOURS tr tf VCC "1" LEVEL +2.5 VDC +1.5 VDC MECHANICAL +0.5 VDC "0" LEVEL GROSS LEAK TEST MIL-STD-883, METHOD 1014, TEST CONDITION C FINE LEAK TEST MIL-STD-883, METHOD 1014, TEST CONDITION A TERMINAL STRENGTH MIL-STD-202, METHOD 211, TEST CONDITION A AND C MARKING INK EPOXY, HEAT CURED. 0 VDC t T MOISTURE RESISTANCE MIL-STD 202, METHOD 106, OMIT STEP 7B SOLDERABILITY MIL-STD-202, METHOD 208, 95% COVERAGE SOLVENT RESISTANCE MIL-STD-202, METHOD 2002, METHOD 215 PART NUMBERING SYSTEM FREQUENCY STABILITY SERIES CO1 CO13 (14 PIN DIP) (8 PIN DIP) - 100 050 025 ±100 PPM ±50 PPM ±25 PPM EXTENDED TEMPERATURE FREQUENCY - IN MHz SYMMETRY - EXT T TIGHT SYMMETRY OPTIONS TR TAPE AND REEL GW GULL WING 3.3V +3.3 V EXAMPLE: CO1100-20.000-EXT-T, CO13050-32.000-T-TR Raltron Electronics Corporation 10651 NW 19th St. Miami, Florida 33172 U.S.A. Tel: 305-593-6033 Fax: 305-594-3973 e-mail: [email protected] Internet: http://www.raltron.com THROUGH HOLE CLOCK OSCILLATORS-TTL COMPATIBLE SERIES CO1 AND CO13 TEST CIRCUIT FREQUENCY STANDARD R = SEE TABLE FREQUENCY COUNTER D A OSCILLOSCOPE 14(8) VCC + POWER SUPPLY +5 VDC .01µF 8(5) OUT D V D=1N914 OSCILLATOR - GND 7(4) N/C 1 D C=15 pF MAX D LOADS RESISTANCE (R) 10 390 OHM 5 750 OHM 2 1800 OHM 1 3900 OHM OUTLINE DRAWINGS CO1 PACKAGE (FULL SIZE 14 PIN DIP) COLORED DOT INDICATES PIN 1 LOCATION Scale none Dimension in mm inch CO13 PACKAGE (HALF SIZE 8 PIN DIP) MARKING Scale none Dimension in mm inch MARKING AREA AREA 36 7.62 ± .13 .300 ± .005 PIN 7 PIN 4 13.21 MAX 7.62 ± .13 .300 ± .005 7.62 ± .13 12.19 .300 ± .005 4.57 .180 13.20 MAX .519 MAX PIN 1 PIN 14 6.35 MAX .250 MAX .250 MIN 0.46 ± .08 DIA .018 ± .003 DIA .520 MAX 15.24 ± .13 .600 ± .005 PIN 1 .031 ± .003 0.79 ± .08 5.08 MAX .018 ± .003 DIA .200 MAX 0.79 ± .08 0.46 ± .08 DIA 6.35 MIN 5.08 MAX .200 MAX .031 ± .003 COLORED DOT INDICATES PIN 1 LOCATION PIN 8 PIN 8 .480 PIN 5 13.21 MAX 20.80 MAX .520 MAX .819 MAX PIN CONNECTION PIN CONNECTION NOTE: PIN 7 IS INTERNAL TO HEADER PIN FUNCTION 1 N/C GROUND 4 GROUND OUTPUT 5 OUTPUT VCC 8 VCC PIN FUNCTION 1 N/C 7 8 14 NOTE: PIN 4 IS INTERNAL TO HEADER PACKAGING 14 PIN DIP: 25 PIECES PER ELECTROSTATIC TUBE 8 PIN DIP: 40 PIECES PER ELECTROSTATIC TUBE Raltron Electronics Corporation 10651 NW 19th St. Miami, Florida 33172 U.S.A. Tel: 305-593-6033 Fax: 305-594-3973 e-mail: [email protected] Internet: http://www.raltron.com