NO.:QB/SPS 73 PS 1088A SPECIFICATIONS NAME: 0.36 inch DIGITAL DISPLAY TYPE: LDS40361SRA SHENZHEN DITELONG INDUSTRIAL CO.,LTD. SHENZHEN CANDELA ELECTRONIC CO.,LTD. SHENZHEN SUCCESS PHOTOELECTRONICS CO.,LTD SHENZHEN OFFICE Add: Room 1911,Zhongwin Science & Techn.Bldg,Bagua 3th Rd.Bagualing Industry Zone Shenzhen,China Tel: 86-755-25884151 Fax: 86-755-25884659 Post Code: 518029 E-mail: [email protected] http://www.ditelong.com SHENZHEN FACTORY Add:4/F Ranbao Bldg,NO. 189 Industrial Zone,Henggang,ShenZhen,china Tel:86-755-28630148 28630040 Fax:86-755-28631216 Post Code:518115 3-1 SPECIFICATION NO.:QB/SPS 73 PS 1088A LDS—40361SRA 1.FEATURES • High intensity and reliability. • Low power reguirement • I.C. compatible 2.PACKAGE DIMENSIONS: NOTES: All dimensions are in millimeters,tolerance are ± 0.25 mm unless otherwise noted. 3.INTERNAL CIRCUIT DIAGRAM. 3-2 SPECIFICATION NO.:QB/SPS 73 PS 1088A 4.ABSOLUTE MAXIMUM RATINGS Ta=25℃ PARAMETER RED Green UNIT Power dissipation per segment 60 mw Peak forward current per segment* 80 mA Continuous forward current per segment** 15 mA Reverse voltage per segment 5 V Operating temperature range -35~80 ℃ Storage temperature range -35~85 ℃ Solder temperature 1/16 inch below seating plane for 3 seconds at 260℃ NOTES: * 1/10 duty cycle 10 mes pulse width ** We advise average forward c urrent is 15mA 5.ELECTRICAL/OPTICAL CHARACTERISTICS ITEM Luminous Intensity Peak Emission SYMBOL IV λP Wavelength Spectral Line Half-width Forward Voltage per segment Reverse Current per segment Red Green Red Red Green VF IR RATING CONDITION Green △λ Ta=25℃ Red Green IF=20mA IF=20mA IF=20mA IF=20mA UNIT min typ max — 9 — — — — — 640 — — — — — 35 — — — — — 2.0 2.4 — — — Red VR=5V — — 50 Green VR=5V — — — mcd nm nm V μA 6.CAUTIONS: a)When being used, do not be over the corresponding limited scale and note in our specification. b)For some products with the static electricity mark, please operate refer to the rules of static electricity fence. c)When designing, please consider the factor of heat, and taking keep away measure to avoid high temperature. d)Do not clean the product with organic impregnant as some of them may damage the product. 3-3