7.62mm (0.3INCH) DUAL DIGIT NUMERIC DISPLAY DA03-11EWA HIGH EFFICIENCY RED Description Features 0.3 INCH DIGIT HEIGHT. The High Efficiency Red and Orange source color devices LOW CURRENT OPERATION. are made with Gallium Arsenide Phosphide on Gallium EXCELLENT CHARACTER APPEARANCE. Phosphide Orange Light Emitting Diode. EASY MOUNTING ON P.C. BOARDS OR SOCKETS. TWO DIGIT PACKAGE SIMPLIFIES ALIGNMENTS & ASSEMBLY. I.C. COMPATIBLE. MECHANICALLY RUGGED. STANDARD : GRAY FACE, WHITE SEGMENT. RoHS COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAB2471 REV NO: V.6 DATE: APR/23/2005 PAGE: 1 OF 3 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG ERP:1302000002 Selection Guide Part No. Dice DA03-11EWA Iv (ucd) @ 10mA Lens Type HIGH EFFICIENCY RED (GaAsP/GaP) WHITE DIFFUSED Description Min. Typ. 480 1900 Common Anode Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength High Efficiency Red λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter High Efficiency Red Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 5mm below package base. SPEC NO: DSAB2471 REV NO: V.6 DATE: APR/23/2005 PAGE: 2 OF 3 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG ERP:1302000002 High Efficiency Red DA03-11EWA Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAB2471 REV NO: V.6 DATE: APR/23/2005 PAGE: 3 OF 3 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG ERP:1302000002