NJM2887 ADJUSTABLE LOW DROPOUT VOLTAGE REGULATOR ! GENERAL DESCRIPTION The NJM2887 is an adjustable low dropout voltage regulator with ON/OFF control. Advanced Bipolar technology achieves low noise, high ripple rejection and low quiescent current. It is suitable for DVD, FAX and Car Audio. ! PACKAGE OUTLINE NJM2887DL2 ! FEATURES " High Ripple Rejection 75dB typ. (f=1kHz) " Output Noise Voltage Vno=45µVrms " Output capacitor with 2.2µF ceramic capacitor " Output Current Io(max.)=500mA " High Precision Output Vref=1.27V±1.0% " Low Dropout Voltage 0.18V typ. (Io=300mA) " ON/OFF Contorol " Internal Short Circuit Current Limit " Internal Thermal Overload Protection " Bipolar Technology " Package Outline TO-252-5 ! PIN CONFIGURATION 3 12345 PIN FUNCTION 1.CONTROL 2. VIN 3.GND 4.VOUT 5.VADJ NJM2887DL2 ! EQUIVALENT CIRCUIT VIN VOUT Control Thermal Protection Bandgap Reference VADJ GND Ver.2004-01-16 -1- NJM2887 ! ABSOLUTE MAXIMUM RATINGS PARAMETER SYMBOL Input Voltage VIN Control Voltage VCONT RATINGS +14 +14(*note 1) 8(Tc=25°C) Power Dissipation PD 0.8(Ta≤25°C) Operating Temperature Topr -40 ∼ +85 Storage Temperature Tstg -40 ∼ +125 (*note 1): When input voltage is less than +14V, the absolute maximum control voltage is equal to the input voltage. (Ta=25°C) UNIT V V mW °C °C ! ELECTRICAL CHARACTERISTICS (VIN=Vo+1V, R1=100kΩ, CIN=0.33uF, Co=2.2uF:Vo (Co=4.7µF: Vo≤2.6V), Ta=25°C) PARAMETER SYMBOL TEST CONDITION Io=30mA Output Voltage Vo Io=30mA Reference Voltage Vref Quiescent Current Io=0mA IQ Quiescent Current VCONT=0V IQ(OFF) at Control OFF Output Current Io Vo−0.3V Line Regulation ∆Vo/∆VIN VIN=Vo+1V ∼ Vo+6.0V, Io=30mA Load Regulation ∆Vo/∆Io Io=0 ∼ 500mA Dropout Voltage(*note 2) ∆VI−O Io=300mA ein=200mVrms,f=1kHz, Io=10mA Ripple Rejection RR Vo=3.0V Version Average Temperature Coefficient of Output ∆Vo/∆Ta Ta=0∼85°C, Io=10mA Voltage f=10Hz∼80kHz, Io=10mA, Output Noise Voltage VNO Vo=3.0V Version Control Voltage for VCONT(ON) ON-state Control Voltage for VCONT(OFF) OFF-state MIN. -1.0% 1.257 − TYP. − 1.27 200 MAX. +1.0% 1.283 300 UNIT V V uA − − 100 nA 500 − − − 650 − − 0.18 − 0.10 0.03 0.28 mA %/V %/mA V − 75 − dB − ±50 − ppm/°C − 45 − µVrms 1.6 − − V − − 0.6 V (*note 2): Except output voltage less than 2.1V. -2- Ver.2004-01-16 NJM2887 ! POWER DISSIPATION VS. AMBIENT TEMPERATURE NJU2887DL2 (Topr=-40~+85°C,Tj=125°C,PD=8W(TC=25°C),PD=0.8W(Ta≤25°C)) Power Dissipation PD(W) 10 ∞ Heat Sink 8 θHS=5°C/W 6 θHS=10°C/W 4 θHS=20°C/W 2 Without Heat Sink 0 -50 -25 0 25 50 75 100 Ambient Temperature Ta(°C) ! TEST CIRCUIT A IIN VIN VIN 0.33µF A V VCONT ICONT VO ＮＪＭ2887 CONTROL GND R1 IOUT V VO 2.2µF OR 4.7µF(Vo≤2.6V) VADJ R2 100kΩ A IQ Ver.2004-01-16 -3- NJM2887 ! TYPICAL APPLICATION 1 In the case where ON/OFF Control is not required: VIN VIN VO VO 0.33µF ＮＪＭ2887 2.2µF OR 4.7µF(Vo≤2.6V) R1 R (0～300kΩ) CONTROL VADJ R2 GND 100kΩ Connect control terminal to VIN terminal The quiescent current can be reduced by using a resistance “R”. Instead, it increases the minimum operating voltage. For further information, please refer to Figure “Output Voltage vs. Control Voltage”. 2 In use of ON/OFF CONTROL: VIN VIN VO ＮＪＭ2887 0.33µF VO R1 2.2µF OR 4.7µF(Vo≤2.6V) R CONTROL GND VADJ R2 100kΩ State of control terminal: •“H”→ output is enabled. •“L” or “open” → output is disabled. -4- Ver.2004-01-16 NJM2887 [CAUTION] The specifications on this databook are only given for information , without any guarantee as regards either mistakes or omissions. The application circuits in this databook are described only to show representative usages of the product and not intended for the guarantee or permission of any right including the industrial rights. Ver.2004-01-16 -5-