NTE NTE976

NTE976
Integrated Circuit
Operational Amplifier
Description:
The NTE976 is a general purpose operational amplifier with the necessary frequency compensation
built into a single 8–Lead DIP type package. Advanced processing techniques make the input currents a factor of ten lower than industry standards like the NTE909. Yet, it is a direct plug–in replacement for the NTE909 and the NTE941M.
This device provides better accuracy and lower noise in high impedance circuitry. The low input currents also make it particularly well suited for long interval integrators or timers, sample and hold circuits, and low frequency waveform generators. Further, replacing circuits where matched transistor
pairs buffer the inputs of conventional IC op amps, the NTE976 can give lower offset voltage and drift
at a lower cost.
Features:
D Offset Voltage over Temperature: 3mV Max
D Input Current over Temperature: 100nA Max
D Offset Current over Temperature: 20nA Max
D Guaranteed Drift Characteristics
Absolute Maximum Ratings:
Supply Voltage,
VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +18V
VEE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –18V
Power Dissipation (Note 1), PD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500mW
Differential Input Voltage, VID . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±30V
Input Voltage (Note 2), VIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15V
Output Short–Circuit Duration, ts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Indefinite
Operating Temperature Range, TA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0° to +70°C
Storage Temperature Range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –65° to +150°C
Lead Temperature (During Soldering, 10sec), TL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +300°C
Note 1. The maximum junction temperature of the NTE976 is +100°C. The thermal resistance
junction to ambient is +100°C/W.
Note 2. For supply voltages less than –15V, the absolute maximum input voltage is equal to the
supply voltage.
Electrical Characteristics: (0° ≤ TA ≤ +70°C, ±5V ≤ VS ≤ ±15V unless otherwise specified)
Parameter
Symbol
Input Offset Voltage
VIO
Input Offset Current
IIO
Input Bias Current
IIB
Test Conditions
Min
Typ
Max
Unit
TA = +25°C, RS ≤ 50kΩ
–
2.0
7.5
mV
RS ≤ 50kΩ
–
–
10
mV
TA = +25°C
–
3.0
50
nA
–
–
70
nA
–
70
250
nA
–
–
300
nA
0.5
2.0
–
MΩ
TA = +25°C
Input Resistance
ri
TA = +25°C
Supply Current
ID
TA = +25°C, VS = ±15V
–
1.8
3.0
mA
Large Signal Voltage Gain
Av
TA = +25°C, VS = ±15V,
VOUT = ±10V, RL ≥ 2kΩ
25
160
–
V/mV
VS = ±15V, VOUT = ±10V,
RL ≥ 2kΩ
15
–
–
V/mV
–
6.0
30
µV/°C
+25°C ≤ TA ≤ +70°C
–
0.01
0.3
nA/°C
0°C ≤ TA ≤ +25°C
–
0.02
0.6
nA/°C
VS = ±15V, RL = 10kΩ
±12
±14
–
V
VS = ±15V, RL = 2kΩ
±10
±13
–
V
VICR
VS = ±15V
±12
+15
–13
–
V
Common Mode Rejection Ratio
CMRR
RS ≤ 50kΩ
70
90
–
dB
Supply Voltage Rejection Ratio
PSRR
RS ≤ 50kΩ
70
96
–
dB
Average Temperature Coefficient
of Input Offset Voltage
TCVIO
Average Temperature Coefficient
of Input Offset Current
TCIIO
Output Voltage Swing
VO
Input Voltage Range
Pin Connection Diagram
8
5
.256 (6.52) Max
N.C.
1
8
N.C.
Inverting Input
2
7
V (+)
Non–Inverting
Input
3
6
Output
V (–)
4
5
N.C.
1
4
.393 (10.0)
Max
.300 (7.62)
.150
(3.81)
.100 (2.54)
.070 (1.77) Min
.300 (7.62)