IN4001 thru IN4007 CHENG- YI PLASTIC SILICON RECTIFIER ELECTRONIC VOLTAGE RANGE 50 TO 1000 Volts CURRENT 1.0 Ampere DO-41 FEATURE Low forward voltage High current capability Low leakage current High surge capability Low cost MECHANICAL DATA Case:Molded plastic use UL 94V-0 recognized Flame retardant epoxy Terminals:Axial leads, solderable per MIL-STD-202, method 208 Polarity:Color band denotes cathode Mounting Position:Any MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Single-phase, half-wave, 60Hz, resistive or inductive load IN4001 IN4002 IN4003 IN4004 IN4005 IN4006 IN4007 UNITS Maximum Recurrent Peak Reverse Voltage 50 100 200 400 600 800 1000 V Maximum RMS Voltage 35 70 140 280 420 560 700 V Maximum DC Blocking Voltage 50 100 200 400 600 800 1000 V Maximum Average Forward Rectified Current 3/8 Lead Length at TA =750C 1.0 A Maximum Overload Surge 8.3 ms single half sine-wave 50 A Maximum Forward Voltage at 1.0A AC and 250C 1.1 V Maximum Full Load Reverse Current, Full Cycle Average at 750C Ambient 30 5.0 Maximum DC Reverse Current at 250C at Rated DC Blocking Voltage at 750C 50.0 Typical Junction Capacitance (Note 1) 30 Operating and Storage Temperature Range Notes : 1. Measured at 1.0MHz and applied reverse voltage of 4.0 VDC. * JEDEC Registered Value. -65 to +175 pF 0 C IN4001 thru IN4007 CHENG- YI PLASTIC SILICON RECTIFIER ELECTRONIC RATING AND CHARACTERISTICS CURVES IN4001 THRU IN4007 Fig.1 - TYPICAL REVERSE CHARACTERISTICS PEAK FORWARD SURGE CURRENT.(A) INSTANTANEOUS FORWARD CURRENT, AMPERES 10 1.0 0 TJ=25 C 0.1 Fig.2 - PAEK FORWARD SURGE CURRENT 50 40 TJ=250C 30 20 10 0 1 10 100 0.1 .6 .4 .8 1.0 1.2 1.4 1.6 NUMBER OF CYCLES AT 60 Hz INSTANTANEOUS FORWARD VOLTAGE, (V) Fig.3 - FORWARD CURRENT DERATING CURVE Fig.4 - TYPICAL JUNCTION CAPACITANCE 100 1.25 1.00 CAPACITANCE, pF AVERAGE FORWARD RECTIFIED CURRENT AMPERES 1.50 .75 .50 .25 SINGLE PHASE HALF WAVE 60 Hz RESISTIVE OR INDUCTIVE LOAD .375" (9.5mm) LEAD LENGTH TJ=250C 10 0 25 50 75 100 125 150 0 175 1 1 10 AMBIENT TEMPERATURE, C REVERSE VOLTAGE(V) 100