• 1N746AUR-1 THRU 1N759AUR-1 AVAILABLE IN JAN, JANTX AND JANTXV PER MIL-PRF-19500/127 • 1N4370AUR-1 THRU 1N4372AUR-1 AVAILABLE IN JAN, JANTX AND JANTXV PER MIL-PRF-19500/127 • LEADLESS PACKAGE FOR SURFACE MOUNT • METALLURGICALLY BONDED 1N746AUR-1 thru 1N759AUR-1 and 1N4370AUR-1 thru 1N4372AUR-1 and CDLL746 thru CDLL759A and CDLL4370 thru CDLL4372A MAXIMUM RATINGS Operating Temperature: -65°C to +175°C Storage Temperature: -65°C to +175°C DC Power Dissipation: 500 mW @ TEC = +125°C Power Derating: 10 mW / °C above TEC = +125°C Forward Voltage @ 200mA: 1.1 volts maximum ELECTRICAL CHARACTERISTICS @ 25°C CDI NOMINAL ZENER MAXIMUM TYPE ZENER TEST ZENER MAXIMUM MAXIMUM NUMBER VOLTAGE CURRENT IMPEDANCE (NOTE 1) VZ @ 1ZT (NOTE 2) VOLTS 1ZT ZZT @ 1ZT mA OHMS µA VOLTS mA CDLL4370A 2.4 20 30 100 1.0 155 CDLL4371A 2.7 20 30 60 1.0 140 CDLL4372A 3.0 20 29 30 1.0 125 CDLL746A 3.3 20 28 5 1.0 120 CDLL747A 3.6 20 24 3 1.0 110 CDLL748A 3.9 20 23 2 1.0 100 CDLL749A 4.3 20 22 2 1.0 90 CDLL750A 4.7 20 19 5 1.5 85 CDLL751A 5.1 20 17 5 2.0 75 CDLL752A 5.6 20 11 5 2.5 70 CDLL753A 6.2 20 7 5 3.5 65 CDLL754A 6.8 20 5 2 4.0 60 CDLL755A 7.5 20 6 2 5.0 55 CDLL756A 8.2 20 8 1 6.0 50 CDLL757A 9.1 20 10 1 7.0 45 CDLL758A 10.0 20 17 1 8.0 40 CDLL759A 12.0 20 30 1 9.0 35 REVERSE CURRENT ZENER CURRENT (NOTE 3) NOTE 1 IR @ VR 1ZM Zener voltage tolerance on "A" suffix is +5%. No Suffix denotes + 10% tolerance. "C" suffix denotes + 2% tolerance and "D" suffix denotes + 1% tolerance. NOTE 2 Zener voltage is measured with the device junction in thermal equilibrium at an ambient temperature of 25°C, +3°C. NOTE 3 Zener impedance is derived by superimposing on 1ZT A 60Hz rms a.c. current equal to 10% of 1ZT. DIM D F G G1 S MILLIMETERS INCHES MIN MAX MIN MAX 1.60 1.70 0.063 0.067 0.41 0.55 0.016 0.022 3.30 3.70 .130 .146 2.54 REF. .100 REF. 0.03 MIN. .001 MIN. FIGURE 1 DESIGN DATA CASE: DO-213AA, Hermetically sealed glass case. (MELF, SOD-80, LL34) LEAD FINISH: Tin / Lead THERMAL RESISTANCE: (ROJEC): 100 ˚C/W maximum at L = 0 inch THERMAL IMPEDANCE: (ZOJX): 25 ˚C/W maximum POLARITY: Diode to be operated with the banded (cathode) end positive. MOUNTING POSITION: Any. MOUNTING SURFACE SELECTION: The Axial Coefficient of Expansion (COE) Of this Device is Approximately +6PPM/°C. The COE of the Mounting Surface System Should Be Selected To Provide A Suitable Match With This Device. 22 COREY STREET, MELROSE, MASSACHUSETTS 02176 PHONE (781) 665-1071 FAX (781) 665-7379 WEBSITE: http://www.cdi-diodes.com E-mail: [email protected] CDLL746 CDLL4370 CDLL759A thru and thru CDLL4372A Pd, Rated Power Dissipation (mW) FIGURE 2 500 400 300 200 100 0 0 25 50 75 100 125 150 175 TEC , End cap temperature (°C) POWER DERATING CURVE 100 ZENER IMPEDANCE ZZT (OHMS) 50 20 10 5 2 1 4 6 10 20 40 60 100 FIGURE 3 operating current (mA) ZENER IMPEDANCE VS. OPERATING CURRENT