ELANTEC EL6263CU

Quad 20MHz & Quad 70MHz, Switched Gain Pre-Amp
Features
General Description
• Autozero of output offset to
<10mV
• 3 selectable gains
• Space-saving QSOP-24 package
• Differential Sum & Sum-Bar
outputs
• Single 5V supply
The EL6263C consists of four 30MHz trans-impedance amplifiers and
four 70MHz trans-impedance amplifiers. The four 70MHz amplifier
outputs also are averaged to provide differential 70MHz outputs.
Applications
•
•
•
•
•
•
DVD RAM, RW, and ROM
CD RW, R and ROM
MO drives
Optical Pickup pre-amplifier
Servo positioning systems
High speed instrumentation
EL6263CU
Package
24-Pin QSOP
Tape & Reel
Two TTL/CMOS-compatible select the gains for all eight amplifiers.
The gain settings for the fast amplifiers are 5.4kΩ, 10.7kΩ, and
28.6kΩ. The gain settings for the slow amplifiers are 13.3kΩ, 25kΩ,
and 66.7kΩ. The gain settings for the sum and sumbar outputs are
7.6kΩ, 14.3kΩ, and 38.1kΩ measured single-ended. Gain matching is
typically 3% channel to channel. The autozero input reduces each
amplifier’s output offset to less than 10mV when it goes high. The AZ
pin is TTL/CMOS-compatible.
The E, F, G, and H channel bandwidths are 30MHz for all gains and
reasonable input and output loads. The A, B, C, D, S, and S channels
have bandwidths of 70MHz, 46MHz, and 40MHz at low, middle, and
high gains respectively after driving 25cm of flex circuit.
Ordering Information
Part No
The EL6263C is designed to amplify the photodiode currents for CD,
DVD, or other photodiode pick-up applications.
EL6263C - Product Brief
EL6263C - Product Brief
Outline #
MDP0040
Each amplifier output can typically sink or source up to 5mA and their
outputs can swing 1VP-P at full bandwidth.
The EL6263C operates from a single +5V supply and is available in
QSOP-24 package. It is specified for operation from -0°C to 70°C.
Connection Diagram
GAIN 0 SELECT 1
24 AZ INPUT
GAIN 1 SELECT 2
23 SUM OUTPUT
REF INPUT 3
22 SUM OUTPUT
21 A OUTPUT
B INPUT 5
20 B OUTPUT
C INPUT 6
19 C OUTPUT
D INPUT 7
18 D OUTPUT
0V (VSS) 8
17 +5V (VDD)
E INPUT 9
16 E OUTPUT
F INPUT 10
15 F OUTPUT
G INPUT 11
14 G OUTPUT
H INPUT 12
13 H OUTPUT
Note: All information contained in this data sheet has been carefully checked and is believed to be accurate as of the date of publication; however, this data sheet cannot be a “controlled document”. Current revisions, if any, to these
specifications are maintained at the factory and are available upon your request. We recommend checking the revision level before finalization of your design documentation.
© 2001 Elantec Semiconductor, Inc.
October 12, 2000
A INPUT 4
EL6263C - Product Brief
EL6263C - Product Brief
Quad 20MHz & Quad 70MHz, Switched Gain Pre-Amp
General Disclaimer
Specifications contained in this data sheet are in effect as of the publication date shown. Elantec, Inc. reserves the right to make changes in the circuitry or specifications contained herein at any time without notice. Elantec, Inc. assumes no responsibility for the use of any circuits described
herein and makes no representations that they are free from patent infringement.
October 12, 2000
WARNING - Life Support Policy
Elantec, Inc. products are not authorized for and should not be used
within Life Support Systems without the specific written consent of
Elantec, Inc. Life Support systems are equipment intended to support or sustain life and whose failure to perform when properly used
in accordance with instructions provided can be reasonably
expected to result in significant personal injury or death. Users contemplating application of Elantec, Inc. Products in Life Support
Systems are requested to contact Elantec, Inc. factory headquarters
to establish suitable terms & conditions for these applications. Elantec, Inc.’s warranty is limited to replacement of defective
components and does not cover injury to persons or property or
other consequential damages.
Elantec Semiconductor, Inc.
675 Trade Zone Blvd.
Milpitas, CA 95035
Telephone: (408) 945-1323
(888) ELANTEC
Fax:
(408) 945-9305
European Office: +44-118-977-6020
Japan Technical Center: +81-45-682-5820
2
Printed in U.S.A.